- 您现在的位置：买卖IC网 > PDF目录15292 > LTC1143CS (Linear Technology)IC REG CTRLR BUCK PWM CM 16-SOIC PDF资料下载
参数资料
| 型号： | LTC1143CS |
| 厂商： | Linear Technology |
| 文件页数： | 12/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 16-SOIC |
| 标准包装： | 50 |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 400kHz |
| 占空比： | 100% |
| 电源电压： | 3.5 V ~ 16 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 包装： | 管件 |
| 其它名称： | LTC1143CSW LTC1143CSW-ND |
LTC1143/LTC1143L
LTC1143L-ADJ
APPLICATIO N S I N FOR M ATIO N
Aluminum electrolytic and dry tantalum capacitors are
both available in surface mount configurations. In the case
of tantalum it is critical that the capacitors are surge tested
for use in switching power supplies. An excellent choice is
the AVX TPS series of surface mount tantalums, available
in case heights ranging from 2mm to 4mm. For example,
if 200 μ F/10V is called for in an application requiring 3mm
height, (2) AVX 100 μ F/10V (P/N TPSD 107M010) could be
used. Consult the manufacturer for other specific
recommendations.
At low supply voltages a minimum capacitance at C OUT is
needed to prevent an abnormal low frequency operating
mode (see Figure 4). When C OUT is made too small the
output ripple at low frequencies will be large enough to trip
the voltage comparator. This causes Burst Mode operation
to be activated when the LTC1143 series would normally
be in continuous operation. The output remains in
regulation at all times.
During this recovery time V OUT can be monitored for
overshoot or ringing which would indicate a stability
problem. The Pin 15(7) external components shown in the
Figure 1 circuit will prove adequate compensation for
most applications.
A second, more severe transient is caused by switching in
loads with large (>1 μ F) supply bypass capacitors. The
discharged bypass capacitors are effectively put in parallel
with C OUT causing a rapid drop in V OUT . No regulator can
deliver enough current to prevent this problem if the load
switch resistance is low and it is driven quickly. The only
solution is to limit the rise time of the switch drive so that
the load rise time is limited to approximately 25 ? C LOAD .
Thus a 10 μ F capacitor would require a 250 μ s rise time,
limiting the charging current to about 200mA.
Efficiency Considerations
The percent efficiency of a switching regulator is equal to
the output power divided by the input power times 100%.
1000
800
600
400
200
0
L = 50 μ H
R SENSE = 0.02 ?
L = 25 μ H
R SENSE = 0.02 ?
L = 50 μ H
R SENSE = 0.05 ?
It is often useful to analyze individual losses to determine
what is limiting the efficiency and which change would
produce the most improvement. Percent efficiency can be
expressed as:
%Efficiency = 100% – (L1 + L2 + L3 + ...)
where L1, L2, etc. are the individual losses as a percentage
of input power. (For high efficiency circuits only small
errors are incurred by expressing losses as a percentage
of output power.)
0
1
2 3
V IN – V OUT VOLTAGE (V)
4
5
Although all dissipative elements in the circuit produce
1143 F04
Figure 4. Minimum Value of C OUT
losses, four main sources usually account for most of the
losses in LTC1143 series circuits:
1)
DC bias current
Checking Transient Response
The regulator loop response can be checked by looking at
the load transient response. Switching regulators take
2)
3)
4)
MOSFET gate charge current
I 2 R losses
Voltage drop of the Schottky diode.
several cycles to respond to a step in DC (resistive) load
current. When a load step occurs, V OUT shifts by an
amount equal to ? I LOAD × ESR, where ESR is the effective
series resistance of C OUT . ? I LOAD also begins to charge or
discharge C OUT until the regulator loop adapts to the
current change and returns V OUT to its steady-state value.
12
1) The DC supply current is the current that flows into
V IN (Pin 13 and Pin 5) less the gate charge current. For
V IN = 10V the DC supply current for each section is 160 μ A
for no load and increases proportionally with load up to
a constant 1.6mA after the LTC1143 series has entered
continuous mode. Because the DC bias current is
相关PDF资料 |
PDF描述 |
|---|---|
| VI-220-EY-F1 | CONVERTER MOD DC/DC 5V 50W |
| VE-JWK-EY-F4 | CONVERTER MOD DC/DC 40V 50W |
| LTC3716EG | IC REG CTRLR BUCK PWM CM 36-SSOP |
| RYM24DRMN-S288 | CONN EDGECARD 48POS .156 EXTEND |
| LTC1266IS#PBF | IC REG CTRLR BST PWM CM 16-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1143CS#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1143CS#TR | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1143CS#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1143L | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual High Efficiency SO-16 Step-Down Switching Regulator Controllers |
| LTC1143L-ADJ | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual High Efficiency SO-16 Step-Down Switching Regulator Controllers |
发布紧急采购，3分钟左右您将得到回复。