- 您现在的位置：买卖IC网 > PDF目录15292 > LTC1143CS (Linear Technology)IC REG CTRLR BUCK PWM CM 16-SOIC PDF资料下载
参数资料
| 型号： | LTC1143CS |
| 厂商： | Linear Technology |
| 文件页数： | 8/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 16-SOIC |
| 标准包装： | 50 |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 400kHz |
| 占空比： | 100% |
| 电源电压： | 3.5 V ~ 16 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 包装： | 管件 |
| 其它名称： | LTC1143CSW LTC1143CSW-ND |
LTC1143/LTC1143L
LTC1143L-ADJ
OPERATIO N
Refer to Functional Diagram and Figure 1
The circuit now enters sleep mode with the power MOSFET
turned off. In sleep mode a majority of the circuitry is
turned off, dropping the quiescent current from 1.6mA to
160 μ A (for one regulator block). The load current is now
being supplied from the output capacitor. When the output
voltage has dropped by the amount of hysteresis in
comparator V, the P-channel MOSFET is again turned on
and the process repeats.
To avoid the operation of the current loop interfering with
Burst Mode operation, a built-in offset (V OS ) is incorpo-
APPLICATIO N S I N FOR M ATIO N
The basic LTC1143L-ADJ application circuit is shown in
Figure 1. The LTC1143 and LTC1143L are similar but omit
the external resistive V OUT dividers (see Figures 10 and
13). External component selection is driven by the load
requirement and begins with V OUT and the selection of
R SENSE . Once R SENSE is known, C T and L can be chosen.
Next, the power MOSFET and D1 are selected. Finally, C IN
and C OUT are selected and the loop is compensated. Since
the two regulator sections are identical, the process of
component selection is the same for both sections. The
circuit shown in Figure 1 can be configured for operation
up to an input voltage of 16V.
Output Voltage Selection
The LTC1143/LTC1143L output voltages are internally set
to 3.3V and 5V. The LTC1143L-ADJ requires an external
resistive divider from V OUT to V FB on each section as
shown in Figure 1. The regulated LTC1143L-ADJ output
voltages are given by:
rated in the gain stage. This prevents the current compara-
tor threshold from increasing until the output voltage has
dropped below a minimum threshold.
Using constant off-time architecture the operating fre-
quency is a function of the input voltage. To minimize the
frequency variation as dropout is approached, the off-time
controller increases the C T discharge current as V IN drops
below V OUT + 1.5V. In dropout the P-channel MOSFET is
turned on continuously (100% duty cycle), providing
extremely low dropout operation.
For Figure 1 applications with V OUT below 2V, or when
R SENSE is moved to ground, the current sense comparator
inputs operate near ground. When the current comparator
is operated at less than 2V common mode, the off-time
increases approximately 40%, requiring the use of a
smaller timing capacitor C T .
R SENSE Selection for Output Current
R SENSE is chosen based on the required output current.
The LTC1143 series current comparators have a threshold
range that extends from a minimum of 25mV/R SENSE to a
maximum of 150mV/R SENSE . The current comparator
threshold sets the peak of the inductor ripple current,
yielding a maximum output current I MAX equal to the peak
value less half the peak-to-peak ripple current. For proper
Burst Mode operation, I RIPPLE(P-P) must be less than or
equal to the minimum current comparator threshold.
Since efficiency generally increases with ripple current,
the maximum allowable ripple current is assumed, i.e.,
V OUT 1 = 1 . 25 ? 1 +
V OUT 2 = 1 . 25 ? 1 +
?
?
?
?
R 2 ?
R 1 ? ?
R 4 ?
R 3 ? ?
I RIPPLE(P-P) = 25mV/R SENSE . (See C T and L Selection for
Operating Frequency). Solving for R SENSE and allowing a
margin for variations in the LTC1143 series and external
component values yields:
R SENSE = 100mV
I MAX
To prevent stray pickup, a 100pF capacitor is suggested
across R1 and R3 located close to the LTC1143L-ADJ.
8
A graph for selecting R SENSE versus maximum output
current is given in Figure 2.
相关PDF资料 |
PDF描述 |
|---|---|
| VI-220-EY-F1 | CONVERTER MOD DC/DC 5V 50W |
| VE-JWK-EY-F4 | CONVERTER MOD DC/DC 40V 50W |
| LTC3716EG | IC REG CTRLR BUCK PWM CM 36-SSOP |
| RYM24DRMN-S288 | CONN EDGECARD 48POS .156 EXTEND |
| LTC1266IS#PBF | IC REG CTRLR BST PWM CM 16-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1143CS#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1143CS#TR | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1143CS#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1143L | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual High Efficiency SO-16 Step-Down Switching Regulator Controllers |
| LTC1143L-ADJ | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual High Efficiency SO-16 Step-Down Switching Regulator Controllers |
发布紧急采购，3分钟左右您将得到回复。