- 您现在的位置：买卖IC网 > PDF目录10322 > LTC1196-1ACS8 (Linear Technology)IC A/DCONV 8BIT 1MHZ SAMPL 8SOIC PDF资料下载
参数资料
| 型号： | LTC1196-1ACS8 |
| 厂商： | Linear Technology |
| 文件页数： | 13/28页 |
| 文件大小： | 0K |
| 描述： | IC A/DCONV 8BIT 1MHZ SAMPL 8SOIC |
| 标准包装： | 100 |
| 位数： | 8 |
| 采样率（每秒）： | 1M |
| 数据接口： | 串行 |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 50mW |
| 电压电源： | 单电源 |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOIC |
| 包装： | 管件 |
| 输入数目和类型： | 1 个差分，单极 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC1196/LTC1198
20
119698fb
APPLICATIONS INFORMATION
Source Resistance
The analog inputs of the LTC1196/LTC1198 look like
a 25pF capacitor (CIN) in series with a 120Ω resistor
(RON) as shown in Figure 8. CIN gets switched between
the selected “+” and “–” inputs once during each con-
version cycle. Large external source resistors will slow
the settling of the inputs. It is important that the overall
RC time constants be short enough to allow the analog
inputs to completely settle within tSMPL.
REFERENCE INPUT
The voltage on the reference input of the LTC1196 denes
the voltage span of the A/D converter. The reference
input has transient capacitive switching currents which
are due to the switched-capacitor conversion technique
(see Figure 9). During each bit test of the conversion
(every CLK cycle), a capacitive current spike will be
generated on the reference pin by the ADC. These high
frequency current spikes will settle quickly and do not
cause a problem if the reference input is bypassed with
at least a 0.1μF capacitor.
The reference input can be driven with standard volt-
age references. Bypassing the reference with a 0.1μF
capacitor is recommended to keep the high frequency
impedance low as described above. Some references
require a small resistor in series with the bypass capaci-
tor for frequency stability. See the individual reference
data sheet for details.
Reduced Reference Operation
The minimum reference voltage of the LTC1198 is limited
to 2.7V because the VCC supply and reference are internally
tied together. However, the LTC1196 can operate with
reference voltages below 1V.
The effective resolution of the LTC1196 can be increased
by reducing the input span of the converter. The LTC1196
exhibits good linearity and gain over a wide range of
reference voltages (see the Linearity and Full-Scale Error
vs Reference Voltage curves in the Typical Performance
Characteristics section). However, care must be taken when
operating at low values of VREF because of the reduced
LSB step size and the resulting higher accuracy require-
ment placed on the converter. The following factors must
be considered when operating at low VREF values.
1. Offset
2. Noise
Offset with Reduced VREF
The offset of the LTC1196 has a larger effect on the output
code when the ADC is operated with reduced reference
voltage. The offset (which is typically a xed voltage) be-
comes a larger fraction of an LSB as the size of the LSB is
reduced. The Unadjusted Offset Error vs Reference Voltage
curve in the Typical Performance Characteristics section
depicts how offset in LSBs is related to reference voltage
for a typical value of VOS. For example, a VOS of 2mV which
is 0.1LSB with a 5V reference becomes 0.5LSB with a 1V
reference and 2.5LSB with a 0.2V reference. If this offset is
unacceptable, it can be corrected digitally by the receiving
system or by offsetting the “–” input of the LTC1196.
RON
120Ω
CIN
25pF
LTC1196
LTC1198
+
INPUT
VIN
+
–
INPUT
RSOURCE
–
RSOURCE
+
VIN
–
1196/98 F08
tSMPL
Figure 8. Analog Input Equivalent Circuit
RON
5pF TO
30pF
LTC1196
REF+
ROUT
VREF
EVERY CLK CYCLE
5
4
GND
1196/98 F09
Figure 9. Reference Input Equivalent Circuit
相关PDF资料 |
PDF描述 |
|---|---|
| VE-B7N-MW-S | CONVERTER MOD DC/DC 18.5V 100W |
| VI-21J-IU-S | CONVERTER MOD DC/DC 36V 200W |
| VE-B7M-MW-S | CONVERTER MOD DC/DC 10V 100W |
| AD9609BCPZRL7-20 | IC ADC 10BIT SPI/SRL 20M 32LFCSP |
| VE-B7K-MW-S | CONVERTER MOD DC/DC 40V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1196-1ACS8#PBF | 功能描述:IC A/DCONV 8BIT 1MHZ SAMPL 8SOIC RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| LTC1196-1ACS8#TR | 功能描述:IC ADC 8BIT 1MHZ SHUTDOWN 8SOIC RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| LTC1196-1ACS8#TRPBF | 功能描述:IC A/DCONV 8BIT 1MHZ SAMPL 8SOIC RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| LTC1196-1ACS8-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:8-Bit, SO-8, 1Msps ADCs with Auto-Shutdown Options |
| LTC1196-1ACS8-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:8-Bit, SO-8, 1Msps ADCs with Auto-Shutdown Options |
发布紧急采购，3分钟左右您将得到回复。