- 您现在的位置：买卖IC网 > PDF目录10225 > LTC1412IG#PBF (Linear Technology)IC A/D CONV 12BIT SAMPLNG 28SSOP PDF资料下载
参数资料
| 型号： | LTC1412IG#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 3/16页 |
| 文件大小： | 0K |
| 描述： | IC A/D CONV 12BIT SAMPLNG 28SSOP |
| 标准包装： | 47 |
| 位数： | 12 |
| 采样率（每秒）： | 3M |
| 数据接口： | 并联 |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 220mW |
| 电压电源： | 双 ± |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 28-SSOP |
| 包装： | 管件 |
| 输入数目和类型： | 2 个单端，双极；1 个差分，双极 |
11
LTC1412
APPLICATIONS INFORMATION
WU
U
width of the sample-and-hold circuit is 40MHz. Any noise
or distortion products that are present at the analog inputs
will be summed over this entire bandwidth. Noisy input
circuitry should be filtered prior to the analog inputs to
minimize noise. A simple 1-pole RC filter is sufficient for
many applications.
For example, Figure 7 shows a 500pF capacitor from AIN+
to ground and a 100
source resistor to limit the input
bandwidth to 3.2MHz. The 500pF capacitor also acts as a
charge reservoir for the input sample-and-hold and iso-
lates the ADC input from sampling glitch-sensitive
circuitry. High quality capacitors and resistors should be
used since these components can add distortion. NPO and
silver mica type dielectric capacitors have excellent linear-
ity. Carbon surface mount resistors can also generate
distortion from self heating and from damage that may
occur during soldering. Metal film surface mount resis-
tors are much less susceptible to both problems.
When high amplitude unwanted signals are close in
frequency to the desired signal frequency, a multiple pole
filter is required. Figure 7b shows a simple implementa-
tion using an LTC1560-1 fifth-order elliptic continuous
time filter.
Input Range
The
±2.5V input range of the LTC1412 is optimized for low
noise and low distortion. Most op amps also perform best
over this same range, allowing direct coupling to the ana-
log inputs and eliminating the need for special translation
circuitry.
Some applications may require other input ranges. The
LTC1412 differential inputs and reference circuitry can ac-
commodate other input ranges often with little or no addi-
tional circuitry. The following sections describe the reference
and input circuitry and how they affect the input range.
Internal Reference
The LTC1412 has an on-chip, temperature compensated,
curvature corrected, bandgap reference that is factory
trimmed to 2.500V. It is connected internally to a reference
amplifier and is available at VREF (Pin 3), see Figure 8a. A
2k resistor is in series with the output so that it can be
easily overdriven by an external reference or other cir-
cuitry, see Figure 8b. The reference amplifier gains the
voltage at the VREF pin by 1.625 to create the required
internal reference voltage. This provides buffering be-
tween the VREF pin and the high speed capacitive DAC. The
reference amplifier compensation pin, REFCOMP (Pin 4)
must be bypassed with a capacitor to ground. The refer-
ence amplifier is stable with capacitors of 1
F or greater.
For the best noise performance, a 10
F ceramic or 10F
tantalum in parallel with a 0.1
F ceramic is recommended.
Figure 7b. 1MHz Fifth-Order Elliptic Lowpass Filter
LTC1412
AIN
+
AIN
–
VREF
REFCOMP
AGND
LTC1560-1
1412 F07b
1
2
3
4
1
2
3
4
8
7
6
5
10
F
VIN
–5V
5V
0.1
F
0.1
F
Figure 7a. RC Input Filter
LTC1412
AIN
+
AIN
–
VREF
REFCOMP
AGND
1412 F07a
1
2
3
4
5
10
F
500pF
100
ANALOG INPUT
Figure 8a. LTC1412 Reference Circuit
R2
40k
R3
64k
REFERENCE
AMP
10
F
REFCOMP
AGND
VREF
R1
2k
3
4
5
2.500V
4.0625V
LTC1412
1412 F08a
BANDGAP
REFERENCE
相关PDF资料 |
PDF描述 |
|---|---|
| SP491EN-L/TR | IC TXRX RS485 FULL DUPLX 14NSOIC |
| LTC1412IG | IC A/D CONV 12BIT SAMPLNG 28SSOP |
| SP490EN-L/TR | IC TXRX RS485 FULL DUPLEX 8NSOIC |
| LTC1418AIN | IC A/D CONV 14BIT SRL&PAR 28-DIP |
| SP481ECN-L/TR | IC TXRX RS484 HALF DUPLEX 8NSOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1414CGN | 功能描述:IC A/D CONV 14BIT SAMPLNG 28SSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| LTC1414CGN#PBF | 功能描述:IC A/D CONV 14BIT SAMPLNG 28SSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:microPOWER™ 位数:8 采样率（每秒）:1M 数据接口:串行，SPI? 转换器数目:1 功率耗散（最大）:- 电压电源:模拟和数字 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商设备封装:24-VQFN 裸露焊盘（4x4） 包装:Digi-Reel® 输入数目和类型:8 个单端，单极 产品目录页面:892 (CN2011-ZH PDF) 其它名称:296-25851-6 |
| LTC1414CGN#PBF | 制造商:Linear Technology 功能描述:ADC, 14BIT, 2.2MSPS, SSOP-28 |
| LTC1414CGN#TR | 功能描述:IC ADC 14BIT 2.2MSPS SMPL 28SSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| LTC1414CGN#TRPBF | 功能描述:IC A/D CONV 14BIT SAMPLNG 28SSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
发布紧急采购，3分钟左右您将得到回复。