- 您现在的位置：买卖IC网 > PDF目录20336 > LTC1473CGN (Linear Technology)IC SWITCH DVR PWRPATH DUAL16SSOP PDF资料下载
参数资料
| 型号： | LTC1473CGN |
| 厂商： | Linear Technology |
| 文件页数： | 7/16页 |
| 文件大小： | 0K |
| 描述： | IC SWITCH DVR PWRPATH DUAL16SSOP |
| 标准包装： | 100 |
| 系列： | PowerPath™ |
| 应用： | 手持/移动设备 |
| FET 型： | N 沟道 |
| 输出数： | 2 |
| 内部开关： | 无 |
| 延迟时间 - 开启： | 22µs |
| 延迟时间 - 关闭： | 1µs |
| 电源电压： | 4.75 V ~ 30 V |
| 电流 - 电源： | 100µA |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SSOP |
| 包装： | 管件 |
LTC1473
OPERATIO N
The LTC1473 is responsible for low-loss switching and
isolation at the “front end” of the power management
system, where up to two battery packs can be connected
and disconnected seamlessly. Smooth switching between
input power sources is accomplished with the help of
lowloss N-channel switches. They are driven by special
gate drive circuitry which limits the inrush current in and
out of the battery packs and the system power supply
capacitors.
All N-Channel Switching
The LTC1473 drives external back-to-back N-channel
MOSFET switches to direct power from two sources: the
primary battery and the secondary battery or a battery and
two switch pairs, SW A1/B1 and SW A2/B2, during the
transitions.
Figure 2 shows a block diagram of a switch driver pair, SW
A1/B1. A bidirectional current sensing and limiting circuit
determines when the voltage drop across R SENSE reaches
± 200mV. The gate-to-source voltage, V GS , of the appro-
priate switch is limited during the transition period until
the inrush current subsides, generally within a few milli-
seconds, depending upon the value of the following
system’s input capacitor.
This scheme allows capacitors and MOSFET switches of
differing sizes and current ratings to be used in the same
system without circuit modifications.
a wall unit. (N-channel MOSFET switches are more cost
effective and provide lower voltage drops than their P-
channel counterparts.)
Gate Drive (V GG ) Power Supply
LTC1473
V +
DCIN
L1
BAT1
BAT2
The gate drive for the low-loss N-channel switches is
supplied by an internal micropower boost regulator which
is regulated at approximately 8.5V above V + , up to 37V
maximum. In two battery systems, the LTC1473 V + pin is
TO GATE
DRIVERS
(8.5V + V + )
V GG
SW
1mH
C1
1 μ F
50V
diode ORed through three external diodes connected to
the three main power sources, DCIN, BAT1 and BAT2.
Thus, V GG is regulated at 8.5V above the highest power
V GG
SWITCHING
REGULATOR
C2
1 μ F
50V
source and will provide the overdrive required to fully
enhance the MOSFET switches.
For maximum efficiency the top of the boost regulator
inductor is connected to V + as shown in Figure 1. C1
GND
Figure 1. V GG Switching Regulator
1473 F01
provides filtering at the top of the 1mH switched inductor,
L1, which is housed in a small surface mount package. An
internal diode directs the current from the 1mH inductor to
BAT1
SW A1
SW B1
R SENSE
+
OUTPUT
LOAD
the V GG output capacitor C2.
GA1
SAB1
GB1
V SENSE +
V SENSE –
C OUT
Inrush and Short-Circuit Current Limiting
The LTC1473 uses an adaptive inrush current limiting
6V
6V
± 200mV
THRESHOLD
scheme to reduce current flowing in and out of the two
main power sources and the following system’s input
capacitor during switch-over transitions. The voltage across
a single small valued resistor, R SENSE , is measured to
ascertain the instantaneous current flowing through the
V GG
LTC1473
SW A/B
GATE
DRIVERS
BIDIRECTIONAL
INRUSH CURRENT
SENSING AND
LIMITING
1473 F02
Figure 2. SW A1/B1 Inrush Current Limiting
7
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4416IMS#TRPBF | IC CNTRLR POWERPATH 10-MSOP |
| BPD2FF | TRANSFR WALL 120V TO 18VAC 1.11A |
| T95D107M016HSAL | CAP TANT 100UF 16V 20% 2917 |
| VI-J6K-CW-F3 | CONVERTER MOD DC/DC 40V 100W |
| RS2J-13 | RECT FAST RECOVERY 600V 1.5A SMB |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1473CGN#PBF | 功能描述:IC SWITCH DVR PWRPATH DUAL16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - O 圈控制器 系列:PowerPath™ 标准包装:1,000 系列:- 应用:电池备份，工业/汽车，大电流开关 FET 型:- 输出数:5 内部开关:是 延迟时间 - 开启:100ns 延迟时间 - 关闭:- 电源电压:3 V ~ 5.5 V 电流 - 电源:250µA 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC N 包装:带卷 (TR) |
| LTC1473CGN#TR | 功能描述:IC DRIVER SWITCH DUAL 16SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - O 圈控制器 系列:PowerPath™ 标准包装:1,000 系列:- 应用:电池备份，工业/汽车，大电流开关 FET 型:- 输出数:5 内部开关:是 延迟时间 - 开启:100ns 延迟时间 - 关闭:- 电源电压:3 V ~ 5.5 V 电流 - 电源:250µA 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC N 包装:带卷 (TR) |
| LTC1473CGN#TRPBF | 功能描述:IC SWITCH DVR PWRPATH DUAL16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - O 圈控制器 系列:PowerPath™ 标准包装:1,000 系列:- 应用:电池备份，工业/汽车，大电流开关 FET 型:- 输出数:5 内部开关:是 延迟时间 - 开启:100ns 延迟时间 - 关闭:- 电源电压:3 V ~ 5.5 V 电流 - 电源:250µA 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC N 包装:带卷 (TR) |
| LTC1473IGN | 功能描述:IC SWITCH DVR PWRPATH DUAL16SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - O 圈控制器 系列:PowerPath™ 标准包装:1,000 系列:- 应用:电池备份，工业/汽车，大电流开关 FET 型:- 输出数:5 内部开关:是 延迟时间 - 开启:100ns 延迟时间 - 关闭:- 电源电压:3 V ~ 5.5 V 电流 - 电源:250µA 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC N 包装:带卷 (TR) |
| LTC1473IGN#PBF | 功能描述:IC SWITCH DVR PWRPATH DUAL16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - O 圈控制器 系列:PowerPath™ 标准包装:1,000 系列:- 应用:电池备份，工业/汽车，大电流开关 FET 型:- 输出数:5 内部开关:是 延迟时间 - 开启:100ns 延迟时间 - 关闭:- 电源电压:3 V ~ 5.5 V 电流 - 电源:250µA 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC N 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。