参数资料
| 型号： | LTC1564IG#TR |
| 厂商： | Linear Technology |
| 文件页数： | 2/12页 |
| 文件大小： | 0K |
| 描述： | IC ANTIALIASING FILTER 16-SSOP |
| 标准包装： | 2,000 |
| 滤波器类型： | 抗混迭 |
| 频率 - 截止或中心： | 150kHz |
| 滤波器数： | 1 |
| 滤波器阶数： | 8th |
| 电源电压： | 2.7 V ~ 10.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 16-SSOP |
| 包装： | 带卷 (TR) |
| 其它名称： | LTC1564IGTR |
10
LTC1564
1564fa
APPLICATIO S I FOR ATIO
WU
UU
levels that program the part for enabled F and G pins
(CS/HOLD = 0), 20kHz fC and unity passband gain. There-
fore six connections (power pins, EN to logic 0, AGND, IN
and OUT) are enough to set up a working 20kHz lowpass
filter, and additional pins can be connected as necessary
to select different fC or gain.
This feature of floatable logic inputs is intended for rapid
prototyping and experimentation. Floating the logic inputs
is not recommended for production designs because,
depending on construction details, the high impedances
of these inputs may permit unwanted interference cou-
pling and consequent erroneous digital inputs to the
LTC1564.
Also, it may be necessary to consider the effect of the pull-
up and pull-down current sources on the logic that drives
the LTC1564. In particular, if the LTC1564 operates from
±5Vbutreceivesdigitalinputsfromlogicusing5Vand0V,
CMOS logic levels will be compatible but the possibility
exists of the LTC1564 pulling current out of the driving logic
at those LTC1564 inputs that are capable of floating to logic
0. That is because the small current sources at these in-
puts return to V –, not to 0V. If the driving logic presents a
high impedance or three-state output, the LTC1564’s in-
put current may pull this output below 0V, although the
current is limited to about 10
A. The system designer
should be aware of this possibility and ensure that any such
current flow is compatible with the driving logic.
Mute State
The Mute mode keeps the filter powered as in normal
filtering but “turns off” the signal path for minimal signal
transmission (approximately –100dB) and reduced out-
put noise. This feature may be useful for gating a signal
source on and off, or for system calibration procedures.
Note however that the DC output in the Mute state may
shift by some millivolts compared to normal filtering
because the internal signal path changes. Recovery from
Mute, like other transient responses in a filter, proceeds at
the time scale of the filter’s pole-zero time constants and
therefore is faster at the higher fC settings (that is, at the
higher F codes).
The LTC1564 enters the Mute state when the F bits at the
latch output (Figure 3) become 0000. (It can be remem-
bered as a “zero-bandwidth” frequency setting.) This is
achieved either by presenting a 0000 code to the F inputs
and lowering the CS/HOLD input to enable the latch, or
alternatively at any time by lowering RST, which immedi-
ately resets the latch contents to all zeroes. Such a reset
also occurs normally at the application of power, unless
CS/HOLD is low and a nonzero pattern at the F inputs
overrides the brief power-on reset. In the Mute state, the
G gain-control inputs have no effect.
Output noise in Mute is largely thermal and wideband
(unlike in normal filtering, where the filter’s response
affects the noise spectrum). Typical Mute-state output
noise is 5.4
VRMS in 200kHz measurement bandwidth
and less than 3
VRMS in 40kHz bandwidth. It has occa-
sionally happened elsewhere in the electronics industry
that someone would characterize a circuit or system by
comparing its output level in normal operation to the noise
level in a Mute state as though this were a normal signal-
to-noise ratio (SNR), which it is not, because this signal
and noise exist only at different times. A scrupulous name
for such a measure is SMR, signal-to-mute ratio. Accord-
ingly in a 40kHz bandwidth, the LTC1564 can exhibit an
SMR exceeding 120dB.
Construction and Instrumentation Cautions
Electrically clean construction is important in applications
seeking the full dynamic range or high stopband rejection
of the LTC1564. Short, direct wiring will minimize parasitic
capacitance and inductance. High quality supply bypass
capacitors of 0.1
F near the chip provide good decoupling
from a clean, low inductance power source. But several
inches of wire (i.e., a few microhenrys of inductance) from
the power supplies, unless decoupled by substantial ca-
pacitance (
≥ 10F) near the chip, can cause a high-Q LC
resonance in the hundreds of kHz in the chip’s supplies or
ground reference. This may impair stopband rejection and
other specifications at those frequencies. In stringent filter
applications we have often found that a compact, carefully
laid out printed circuit board with good ground plane
makes a difference in both stopband rejection and distor-
tion. Finally, equipment to measure filter performance can
itself introduce distortion or noise floors. Checking for
these limits with a wire replacing the filter is a prudent
routine procedure.
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1565-31IS8#TR | IC FILTR 7TH ORDER 650KHZ 8-SOIC |
| LTC1566-1IS8#TRPBF | IC FILTER LP 7ORDER 2.3MHZ 8SOIC |
| LTC1569IS8-6#TRPBF | IC FILTER 10TH ORDR LOWPASS8SOIC |
| LTC1569IS8-7#TRPBF | IC FILTER 10TH ORDR LOWPASS8SOIC |
| LTC1685IS8 | IC TXRX RS485 PREC DELAY 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1565-31CS8 | 功能描述:IC FILTR 7TH ORDER 650KHZ 8-SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1565-31CS8#PBF | 功能描述:IC FILTR 7TH ORDER 650KHZ 8-SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1565-31CS8#TR | 功能描述:IC FILTR 7TH ORDER 650KHZ 8-SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1565-31CS8#TRPBF | 功能描述:IC FILTR 7TH ORDER 650KHZ 8-SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1565-31IS8 | 功能描述:IC FILTR 7TH ORDER 650KHZ 8-SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。