参数资料
型号: LTC1628CUH#TR
厂商: Linear Technology
文件页数: 16/32页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 32-QFN
标准包装: 2,500
PWM 型: 电流模式
输出数: 2
频率 - 最大: 360kHz
占空比: 99.4%
电源电压: 3.5 V ~ 30 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: 0°C ~ 85°C
封装/外壳: 32-WFQFN 裸露焊盘
包装: 带卷 (TR)
其它名称: LTC1628CUHTR
LTC1628/LTC1628-PG
APPLICATIO S I FOR ATIO
Medium voltage (20V to 35V) ceramic, tantalum, OS-CON
and switcher-rated electrolytic capacitors can be used as
input capacitors, but each has drawbacks: ceramic voltage
coefficients are very high and may have audible piezoelec-
tric effects; tantalums need to be surge-rated; OS-CONs
suffer from higher inductance, larger case size and limited
surface-mount applicability; electrolytics’ higher ESR and
dryout possibility require several to be used. Multiphase
systems allow the lowest amount of capacitance overall.
As little as one 22 μ F or two to three 10 μ F ceramic capaci-
tors are an ideal choice in a 20W to 35W power supply due
to their extremely low ESR. Even though the capacitance
at 20V is substantially below their rating at zero-bias, very
low ESR loss makes ceramics an ideal candidate for
highest efficiency battery operated systems. Also con-
sider parallel ceramic and high quality electrolytic capaci-
tors as an effective means of achieving ESR and bulk
capacitance goals.
operating due to the interleaving of current pulses through
the input capacitor’s ESR. This is why the input capacitor’s
requirement calculated above for the worst-case control-
ler is adequate for the dual controller design. Remember
that input protection fuse resistance, battery resistance
and PC board trace resistance losses are also reduced due
to the reduced peak currents in a multiphase system. The
overall benefit of a multiphase design will only be fully
realized when the source impedance of the power supply/
battery is included in the efficiency testing. The drains of
the two top MOSFETS should be placed within 1cm of each
other and share a common C IN (s). Separating the drains
and C IN may produce undesirable voltage and current
resonances at V IN .
The selection of C OUT is driven by the required effective
series resistance (ESR). Typically once the ESR require-
ment is satisfied the capacitance is adequate for filtering.
The output ripple ( ? V OUT ) is determined by:
? V OUT L ? ESR +
8 fC OUT ?
Incontinuousmode,thesourcecurrentofthetopN-chan-
nel MOSFET is a square wave of duty cycle V OUT /V IN . To
prevent large voltage transients, a low ESR input capacitor
sized for the maximum RMS current of one channel must
≈ ? I
?
?
1 ?
?
[ V ( V ) ]
? V
≈ I
beused.ThemaximumRMScapacitorcurrentisgivenby:
1 / 2
OUT IN OUT
C IN Re quiredI RMS MAX
V IN
This formula has a maximum at V IN = 2V OUT , where
I RMS = I OUT /2. This simple worst case condition is com-
monly used for design because even significant deviations
do not offer much relief. Note that capacitor manufacturer’s
ripple current ratings are often based on only 2000 hours
of life. This makes it advisable to further derate the
capacitor, or to choose a capacitor rated at a higher
temperature than required. Several capacitors may also be
paralleled to meet size or height requirements in the
design. Always consult the manufacturer if there is any
question.
The benefit of the LTC1628 multiphase can be calculated
by using the equation above for the higher power control-
ler and then calculating the loss that would have resulted
if both controller channels switch on at the same time. The
Where f = operating frequency, C OUT = output capacitance,
and ? I L = ripple current in the inductor. The output ripple
is highest at maximum input voltage since ? I L increases
with input voltage. With ? I L = 0.3I OUT(MAX) the output
ripple will typically be less than 50mV at max V IN assum-
ing:
C OUT Recommended ESR < 2 R SENSE
and C OUT > 1/(8fR SENSE )
The first condition relates to the ripple current into the ESR
of the output capacitance while the second term guaran-
tees that the output capacitance does not significantly
discharge during the operating frequency period due to
ripple current. The choice of using smaller output capaci-
tance increases the ripple voltage due to the discharging
term but can be compensated for by using capacitors of
very low ESR to maintain the ripple voltage at or below
50mV. The I TH pin OPTI-LOOP compensation compo-
nents can be optimized to provide stable, high perfor-
mance transient response regardless of the output capaci-
tors selected.
total RMS power lost is lower when both controllers are
1628fb
16
相关PDF资料
PDF描述
H2BXG-10108-V8-ND JUMPER-H1501TR/A3048V/X 8"
LTC3723EGN-1#TRPBF IC REG CTRLR FLYBK ISO CM 16SSOP
LTC3723EGN-1#TR IC REG CTRLR FLYBK ISO CM 16SSOP
LTC3723EGN-2#TRPBF IC REG CTRLR FLYBK ISO VM 16SSOP
H2BXG-10108-S8-ND JUMPER-H1501TR/A3048S/X 8"
相关代理商/技术参数
参数描述
LTC1628IG 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1628IG#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LTC1628IG#TR 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1628IG#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1628IGPBF 制造商:Linear Technology 功能描述:DC-DC Controller Dual Step-Dn 36V SSOP28