- 您现在的位置：买卖IC网 > PDF目录14875 > LTC1779ES6#TRMPBF (Linear Technology)IC REG BUCK ADJ 0.25A SOT23-6 PDF资料下载
参数资料
| 型号： | LTC1779ES6#TRMPBF |
| 厂商： | Linear Technology |
| 文件页数： | 5/12页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 0.25A SOT23-6 |
| 标准包装： | 1 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 9.8 V |
| 输入电压： | 2.5 V ~ 9.8 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 100kHz ~ 550kHz |
| 电流 - 输出： | 250mA |
| 同步整流器： | 无 |
| 工作温度： | -65°C ~ 150°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-23-6 |
| 包装： | 标准包装 |
| 供应商设备封装： | SOT-23-6 |
| 产品目录页面： | 1333 (CN2011-ZH PDF) |
| 其它名称： | LTC1779ES6#TRMPBFDKR |
LTC1779
OPERATIO
(Refer to Functional Diagram)
up, the corresponding output current trip level follows,
allowing normal operation.
Comparator OVP guards against transient overshoots
> 7.5% by turning off the internal P-channel power
MOSFET and keeping it off until the fault is removed.
Burst Mode Operation
The LTC1779 enters Burst Mode operation at low load
currents. In this mode, the peak current of the inductor is
set as if V ITH /RUN = 1V (at low duty cycles) even though
the voltage at the I TH /RUN pin is at a lower value. If the
inductor’s average current is greater than the load require-
ment, the voltage at the I TH /RUN pin will drop. When the
I TH /RUN voltage goes below 0.85V, the sleep signal goes
high, turning off the internal MOSFET. The sleep signal
goes low when the I TH /RUN voltage goes above 0.925V
and the LTC1779 resumes normal operation. The next
oscillator cycle will turn the internal MOSFET on and the
Short-Circuit Protection
When the output is shorted to ground, the frequency of the
oscillator will be reduced to about 100kHz. This lower
frequency allows the inductor current to safely discharge,
thereby preventing current runaway. The oscillator’s fre-
quency will gradually increase to its designed rate when
the feedback voltage again approaches 0.8V.
Overvoltage Protection
As a further protection, the overvoltage comparator in the
LTC1779 will turn the internal MOSFET off when the
feedback voltage has risen 7.5% above the reference
voltage of 0.8V. This comparator has a typical hysteresis
of 30mV.
Slope Compensation and Inductor’s Peak Current
The inductor’s peak current is determined by:
(
)
switching cycle repeats.
Dropout Operation
I PK =
M( V ITH/ RUN – 0. 7)
10 R SENSE + 2 ?
When the input supply voltage decreases towards the
output voltage, the rate of change of inductor current
during the ON cycle decreases. This reduction means that
the internal P-channel MOSFET will remain on for more
than one oscillator cycle since the inductor current has not
ramped up to the threshold set by EAMP. Further reduc-
tion in input supply voltage will eventually cause the
P-channel MOSFET to be turned on 100%, i.e., DC. The
output voltage will then be determined by the input voltage
minus the voltage drop across the MOSFET, the sense
resistor and the inductor.
when the LTC1779 is operating below 40% duty cycle.
However, once the duty cycle exceeds 40%, slope com-
pensation begins and effectively reduces the peak induc-
tor current. The amount of reduction is given by the curves
in Figure 2.
110
100
90
80
70
60
Undervoltage Lockout
To prevent operation of the P-channel MOSFET below safe
input voltage levels, an undervoltage lockout is incorpo-
rated into the LTC1779. When the input supply voltage
drops below approximately 2.0V, the P-channel MOSFET
and all circuitry is turned off except the undervoltage
50
40
30
20
10
0
I RIPPLE = 0.4I PK
AT 5% DUTY CYCLE
I RIPPLE = 0.2I PK
AT 5% DUTY CYCLE
V IN = 4.2V
10 20 30 40 50 60 70 80 90 100
DUTY CYCLE (%)
1779 F02
block, which draws only several microamperes.
Figure 2. Maximum Output Current vs Duty Cycle
5
相关PDF资料 |
PDF描述 |
|---|---|
| VI-BNK-EU | CONVERTER MOD DC/DC 40V 200W |
| EBC25DRYS-S734 | CONN EDGECARD 50POS DIP .100 SLD |
| MAX6461XR35+T | IC VOLT DETECTOR LP SC70-3 |
| ECC15DRYI-S734 | CONN EDGECARD 30POS DIP .100 SLD |
| MAX6461XR38+T | IC VOLT DETECTOR LP SC70-3 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1798CS8 | 功能描述:IC VREF SERIES ADJ 8-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 电压基准 系列:- 标准包装:3,000 系列:- 基准类型:旁路，精度 输出电压:5V 容差:±0.5% 温度系数:100ppm/°C 输入电压:- 通道数:1 电流 - 阴极:80µA 电流 - 静态:- 电流 - 输出:15mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:TO-236-3，SC-59，SOT-23-3 供应商设备封装:SOT-23-3 包装:带卷 (TR) 其它名称:LM4040CIM3-5.0MLTRLM4040CIM3-5.0MLTR-ND |
| LTC1798CS8#PBF | 功能描述:IC VREF SERIES ADJ 8-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 电压基准 系列:- 标准包装:3,000 系列:- 基准类型:旁路，精度 输出电压:5V 容差:±0.5% 温度系数:100ppm/°C 输入电压:- 通道数:1 电流 - 阴极:80µA 电流 - 静态:- 电流 - 输出:15mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:TO-236-3，SC-59，SOT-23-3 供应商设备封装:SOT-23-3 包装:带卷 (TR) 其它名称:LM4040CIM3-5.0MLTRLM4040CIM3-5.0MLTR-ND |
| LTC1798CS8#TR | 功能描述:IC VREF SERIES ADJ 8-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 电压基准 系列:- 标准包装:2,000 系列:- 基准类型:旁路，可调节，精度 输出电压:1.24 V ~ 16 V 容差:±0.5% 温度系数:- 输入电压:1.24 V ~ 16 V 通道数:1 电流 - 阴极:100µA 电流 - 静态:- 电流 - 输出:20mA 工作温度:-40°C ~ 85°C 安装类型:通孔 封装/外壳:TO-226-3、TO-92-3（TO-226AA）成形引线 供应商设备封装:TO-92-3 包装:带卷 (TR) |
| LTC1798CS8#TRPBF | 功能描述:IC VREF SERIES ADJ 8-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 电压基准 系列:- 标准包装:3,000 系列:- 基准类型:旁路，精度 输出电压:5V 容差:±0.5% 温度系数:100ppm/°C 输入电压:- 通道数:1 电流 - 阴极:80µA 电流 - 静态:- 电流 - 输出:15mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:TO-236-3，SC-59，SOT-23-3 供应商设备封装:SOT-23-3 包装:带卷 (TR) 其它名称:LM4040CIM3-5.0MLTRLM4040CIM3-5.0MLTR-ND |
| LTC1798CS8-2.5 | 功能描述:IC VREF SERIES 2.5V 8-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 电压基准 系列:- 产品培训模块:Voltage Reference Basics 标准包装:100 系列:- 基准类型:旁路，精度 输出电压:4.096V 容差:±0.075% 温度系数:50ppm/°C 输入电压:- 通道数:1 电流 - 阴极:1µA 电流 - 静态:- 电流 - 输出:10mA 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SOIC 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。