参数资料
| 型号： | LTC2050HVCS5#TRM |
| 厂商： | Linear Technology |
| 文件页数： | 2/16页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP ZERO-DRIFT TSOT23-5 |
| 标准包装： | 1 |
| 放大器类型： | 断路器（零漂移） |
| 电路数： | 1 |
| 输出类型： | 满摆幅 |
| 转换速率： | 2 V/µs |
| 增益带宽积： | 3MHz |
| 电流 - 输入偏压： | 25pA |
| 电压 - 输入偏移： | 0.5µV |
| 电流 - 电源： | 1mA |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 11 V，±1.35 V ~ 5.5 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-23-5 细型，TSOT-23-5 |
| 供应商设备封装： | TSOT-23-5 |
| 包装： | 标准包装 |
| 产品目录页面： | 1321 (CN2011-ZH PDF) |
| 其它名称： | LTC2050HVCS5#TRMDKR |
LTC2050/LTC2050HV
10
2050fc
multiplied by the closed loop gain of the op amp. To reduce
this form of clock feedthrough, use smaller valued gain
setting resistors and minimize the source resistance at the
input. If the resistance seen at the inputs is less than 10k,
this form of clock feedthrough is less than 1μVRMS input
referred at 7.5kHz, or less than the amount of residue clock
feedthrough from the rst form described above.
Placing a capacitor across the feedback resistor reduces
either form of clock feedthrough by limiting the bandwidth
of the closed loop gain.
Input bias current is dened as the DC current into the
input pins of the op amp. The same current spikes that
cause the second form of clock feedthrough described
above, when averaged, dominate the DC input bias current
of the op amp below 70°C.
At temperatures above 70°C, the leakage of the ESD
protection diodes on the inputs increases the input bias
currents of both inputs in the positive direction, while
the current caused by the charge injection stays rela-
tively constant. At elevated temperatures (above 85°C) the
leakage current begins to dominate and both the negative
and positive pin’s input bias currents are in the positive
direction (into the pins).
Input Pins, ESD Sensitivity
ESD voltages above 700V on the input pins of the op amp
will cause the input bias currents to increase (more DC
current into the pins). At these voltages, it is possible to
damage the device to a point where the input bias current
exceeds the maximums specied in this data sheet.
Shutdown
The LTC2050 includes a shutdown pin in the 6-lead SOT-23
and the SO-8 version. When this active low pin is high or
allowed to oat, the device operates normally. When the
shutdown pin is pulled low, the device enters shutdown
mode; supply current drops to 3μA, all clocking stops, and
both inputs and output assume a high impedance state.
Clock Feedthrough, Input Bias Current
The LTC2050 uses auto-zeroing circuitry to achieve an
almost zero DC offset over temperature, common mode
voltage, and power supply voltage. The frequency of the
clock used for auto-zeroing is typically 7.5kHz. The term
clock feedthrough is broadly used to indicate visibility of
this clock frequency in the op amp output spectrum. There
are typically two types of clock feedthrough in auto zeroed
op amps like the LTC2050.
The rst form of clock feedthrough is caused by the settling
of the internal sampling capacitor and is input referred;
that is, it is multiplied by the closed loop gain of the op
amp. This form of clock feedthrough is independent of the
magnitude of the input source resistance or the magnitude
of the gain setting resistors. The LTC2050 has a residue
clock feedthrough of less then 1μVRMS input referred
at 7.5kHz.
The second form of clock feedthrough is caused by the
small amount of charge injection occurring during the
sampling and holding of the op amp’s input offset voltage.
The current spikes are multiplied by the impedance seen at
the input terminals of the op amp, appearing at the output
APPLICATIONS INFORMATION
相关PDF资料 |
PDF描述 |
|---|---|
| TSW-134-26-G-S | CONN HEADER 34POS .100" SGL GOLD |
| AC0603FR-07180KL | RES 180K OHM 1/10W 1% 0603 |
| TSW-141-17-G-S | CONN HEADER 41POS .100" SGL GOLD |
| 5-102699-5 | 12 MODII HDR DRST SHRD A/PIN |
| MAX4377TASA+ | IC AMP CURRENT DUAL 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC2050HVCS5TRMPBF | 制造商:Linear Technology 功能描述:Op Amp GP RRO +/-5.5V/11V TSOT23-5 |
| LTC2050HVCS5-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Zero-Drift Operational Amplifi ers in SOT-23 |
| LTC2050HVCS6 | 制造商:Linear Technology 功能描述:SP Amp Zero Drift Amplifier Single R-R O/P ±5.5V/11V 6-Pin TSOT-23 |
| LTC2050HVCS6#PBF | 制造商:Linear Technology 功能描述:OP-AMP ZERO DRIFT 3MHZ 2V/u 制造商:Linear Technology 功能描述:OP-AMP, ZERO DRIFT, 3MHZ, 2V/us, TSOT-23-6; Op Amp Type:Zero Drift; No. of Amplifiers:1; Slew Rate:2V/s; Supply Voltage Range:2.7V to 5.5V; Amplifier Case Style:TSOT-23; No. of Pins:6; Bandwidth:3MHz; Operating Temperature Min:0C;RoHS Compliant: Yes |
| LTC2050HVCS6#TR | 功能描述:IC OPAMP ZERO DRIFT HV SOT23-6 RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1,000 系列:- 放大器类型:电压反馈 电路数:4 输出类型:满摆幅 转换速率:33 V/µs 增益带宽积:20MHz -3db带宽:30MHz 电流 - 输入偏压:2nA 电压 - 输入偏移:3000µV 电流 - 电源:2.5mA 电流 - 输出 / 通道:30mA 电压 - 电源，单路/双路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOIC 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。