- 您现在的位置：买卖IC网 > PDF目录10531 > LTC2280IUP#PBF (Linear Technology)IC ADC DUAL 10BIT 105MSPS 64-QFN PDF资料下载
参数资料
| 型号： | LTC2280IUP#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/24页 |
| 文件大小： | 0K |
| 描述： | IC ADC DUAL 10BIT 105MSPS 64-QFN |
| 标准包装： | 40 |
| 位数： | 10 |
| 采样率（每秒）： | 105M |
| 数据接口： | 并联 |
| 转换器数目： | 2 |
| 功率耗散（最大）： | 630mW |
| 电压电源： | 单电源 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 64-WFQFN 裸露焊盘 |
| 供应商设备封装： | 64-QFN（9x9） |
| 包装： | 管件 |
| 输入数目和类型： | 2 个单端，双极; 2 个差分, 双极 |
| 产品目录页面： | 1349 (CN2011-ZH PDF) |
LTC2280
16
2280fa
CLK
5pF-30pF
ETC1-1T
0.1
F
VCM
FERRITE
BEAD
DIFFERENTIAL
CLOCK
INPUT
2280 F13
LTC2280
CLK
100
0.1
F
4.7
F
FERRITE
BEAD
CLEAN
SUPPLY
IF LVDS USE FIN1002 OR FIN1018.
FOR PECL, USE AZ1000ELT21 OR SIMILAR
2280 F12
LTC2280
CLK
50
0.1
F
0.1
F
4.7
F
1k
FERRITE
BEAD
CLEAN
SUPPLY
SINUSOIDAL
CLOCK
INPUT
2280 F11
NC7SVU04
LTC2280
APPLICATIO S I FOR ATIO
WU
UU
The noise performance of the LTC2280 can depend on the
clock signal quality as much as on the analog input. Any
noise present on the clock signal will result in additional
aperture jitter that will be RMS summed with the inherent
ADC aperture jitter.
In applications where jitter is critical, such as when digitiz-
ing high input frequencies, use as large an amplitude as
possible. Also, if the ADC is clocked with a sinusoidal
signal, filter the CLK signal to reduce wideband noise and
distortion products generated by the source.
It is recommended that CLKA and CLKB are shorted
together and driven by the same clock source. If a small
time delay is desired between when the two channels
sample the analog inputs, CLKA and CLKB can be driven
by two different signals. If this delay exceeds 1ns, the
performance of the part may degrade. CLKA and CLKB
should not be driven by asynchronous signals.
Figures 12 and 13 show alternatives for converting a
differential clock to the single-ended CLK input. The use of
a transformer provides no incremental contribution to
phase noise. The LVDS or PECL to CMOS translators
provide little degradation below 70MHz, but at 140MHz
will degrade the SNR compared to the transformer solu-
tion. The nature of the received signals also has a large
bearing on how much SNR degradation will be experi-
enced. For high crest factor signals such as WCDMA or
OFDM, where the nominal power level must be at least 6dB
to 8dB below full scale, the use of these translators will
have a lesser impact.
The transformer shown in the example may be terminated
with the appropriate termination for the signaling in use.
The use of a transformer with a 1:4 impedance ratio may
be desirable in cases where lower voltage differential
signals are considered. The center tap may be bypassed to
ground through a capacitor close to the ADC if the differ-
ential signals originate on a different plane. The use of a
capacitor at the input may result in peaking, and depend-
ing on transmission line length may require a 10
to 20
ohm series resistor to act as both a low pass filter for high
frequency noise that may be induced into the clock line by
neighboring digital signals, as well as a damping mecha-
nism for reflections.
Maximum and Minimum Conversion Rates
The maximum conversion rate for the LTC2280 is 105Msps.
The lower limit of the LTC2280 sample rate is determined
by droop of the sample-and-hold circuits. The pipelined
Figure 11. Sinusoidal Single-Ended CLK Drive
Figure 12. CLK Drive Using an LVDS or PECL to CMOS Converter
Figure 13. LVDS or PECL CLK Drive Using a Transformer
相关PDF资料 |
PDF描述 |
|---|---|
| PT06A-14-5P | CONN PLUG 5 POS STRAIGHT W/PINS |
| TAS5615DKDR | IC AMP AUDIO 160W STER D 44HSSOP |
| AD7863ARSZ-3 | IC ADC 14BIT DUAL 2CHAN 28SSOP |
| MS3102E24-24P | CONN RCPT 16POS BOX MNT W/PINS |
| AD7863ARSZ-10 | IC ADC 14BIT DUAL 2CHAN 28SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC2280UP | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 10-Bit, 105Msps Low Noise 3V ADC |
| LTC2281 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 10-Bit, 125Msps Low Power 3V ADC |
| LTC2281CUP | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 10-Bit, 125Msps Low Power 3V ADC |
| LTC2281CUP#PBF | 功能描述:IC ADC DUAL 10BIT 125MSPS 64QFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:- 位数:14 采样率（每秒）:83k 数据接口:串行，并联 转换器数目:1 功率耗散（最大）:95mW 电压电源:双 ± 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:28-DIP（0.600"，15.24mm） 供应商设备封装:28-PDIP 包装:管件 输入数目和类型:1 个单端，双极 |
| LTC2281CUP#TRPBF | 功能描述:IC ADC DUAL 10BIT 125MSPS 64QFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:- 位数:14 采样率（每秒）:83k 数据接口:串行，并联 转换器数目:1 功率耗散（最大）:95mW 电压电源:双 ± 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:28-DIP（0.600"，15.24mm） 供应商设备封装:28-PDIP 包装:管件 输入数目和类型:1 个单端，双极 |
发布紧急采购，3分钟左右您将得到回复。