参数资料
| 型号： | LTC2485CDD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 6/40页 |
| 文件大小： | 0K |
| 描述： | IC ADC 24BIT I2C 10-DFN |
| 标准包装： | 2,500 |
| 位数： | 24 |
| 采样率（每秒）： | 6.8 |
| 数据接口： | I²C，串行 |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 480µW |
| 电压电源： | 单电源 |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 供应商设备封装： | 10-DFN（3x3） |
| 包装： | 带卷 (TR) |
| 输入数目和类型： | 1 个差分，双极 |
| 配用： | DC956A-ND - BOARD DELTA SIGMA ADC LTC2485 |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页
LTC2485
14
2485fc
APPLICATIONS INFORMATION
The LTC2485 powers up in a default mode commonly
used for most measurements. The device will remain in
this mode until a valid write cycle is performed. In this
default mode, the measured input is external, the digital
lter simultaneously rejects 50Hz and 60Hz line frequency
noise, and the speed mode is 1x (offset automatically,
continuously calibrated).
The I2C serial interface grants access to any or all special
functions contained within the LTC2485. In order to change
the mode of operation, a valid write address followed by 8
bits of data are shifted into the device (see Table 1). The
rst 4 bits are reserved and should be low. The 5th bit
(IM) is used to select the internal temperature sensor as
the conversion input, while the 6th and 7th bits (FA, FB)
combine to determine the line frequency rejection mode.
The 8th bit (SPD) is used to double the output rate by
disabling the offset auto calibration.
Table 1. Selecting Special Modes
IM
FA
FB
SPD
COMMENTS
0
External Input, 50Hz and 60Hz Rejection,
Autocalibration
00
1
0
External Input, 50Hz Rejection,
Autocalibration
01
0
External Input, 60Hz Rejection,
Autocalibration
0
1
External Input, 50Hz and 60Hz Rejection,
2x Speed
0
1
External Input, 50Hz Rejection, 2x Speed
0
1
0
1
External Input, 60Hz Rejection, 2x Speed
1
0
Temperature Input, 50Hz and 60Hz
Rejection, Autocalibration
1
0
1
X
Temperature Input, 50Hz Rejection,
Autocalibration
1
0
X
Temperature Input, 60Hz Rejection,
Autocalibration
X
1
X
Reserved, Do Not Use
Temperature Sensor (IM)
The LTC2485 includes an on-chip temperature sensor.
The temperature sensor is selected by setting IM = 1 in
the serial input data stream. Conversions are performed
directly on the temperature sensor by the converter. While
operating in this mode, the device behaves as a temperature
to bits converter. The digital reading is proportional to the
absolute temperature of the device. This feature allows
the converter to linearize temperature sensors or continu-
ously remove temperature effects from external sensors.
Several applications leveraging this feature are presented
in more detail in the applications section. While operating
in this mode, the speed is set to normal independent of
the control bit (SPD).
Rejection Mode (FA, FB)
The LTC2485 includes a high accuracy on-chip oscilla-
tor with no required external components. Coupled with
a 4th order digital lowpass lter, the LTC2485 rejects
line frequency noise. In the default mode, the LTC2485
simultaneously rejects 50Hz and 60Hz by at least 87dB.
The LTC2485 can also be congured to selectively reject
50Hz or 60Hz to better than 110dB.
Speed Mode (SPD)
The LTC2485 continuously performs offset calibrations.
Every conversion cycle, two conversions are automatically
performed (default) and the results combined. This result
is free from offset and drift. In applications where the offset
is not critical, the autocalibration feature can be disabled
with the benet of twice the output rate.
Linearity, full-scale accuracy and full-scale drift are identi-
cal for both 2x and 1x speed modes. In both the 1x and
2x speed there is no latency. This enables input steps or
multiplexer channel changes to settle in a single conver-
sion cycle easing system overhead and increasing the
effective conversion rate.
相关PDF资料 |
PDF描述 |
|---|---|
| LTC2487CDE#PBF | IC ADC 16BIT DELTA SIG 14-DFN |
| LTC2492IDE#TRPBF | IC ADC 24BIT DELTA SIG 14-DFN |
| LTC2493IDE#TRPBF | IC ADC 24BIT DELTA SIG 14-DFN |
| LTC2494IUHF#TRPBF | IC ADC 16BIT W/PGA 38-QFN |
| LTC2495CUHF#PBF | IC ADC 16BIT W/PGA 38-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC2485IDD | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 7.5sps 24-bit Serial 10-Pin DFN EP |
| LTC2485IDD#PBF | 功能描述:IC ADC 24BIT I2C 10-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:microPOWER™ 位数:8 采样率（每秒）:1M 数据接口:串行，SPI? 转换器数目:1 功率耗散（最大）:- 电压电源:模拟和数字 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商设备封装:24-VQFN 裸露焊盘（4x4） 包装:Digi-Reel® 输入数目和类型:8 个单端，单极 产品目录页面:892 (CN2011-ZH PDF) 其它名称:296-25851-6 |
| LTC2485IDD#TRPBF | 功能描述:IC ADC 24BIT I2C 10-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率（每秒）:15 数据接口:MICROWIRE?，串行，SPI? 转换器数目:1 功率耗散（最大）:480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN（5x7） 包装:带卷 (TR) 输入数目和类型:16 个单端，双极；8 个差分，双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2486CDE#PBF | 功能描述:IC ADC 16BIT W/PGA 14-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:microPOWER™ 位数:8 采样率（每秒）:1M 数据接口:串行，SPI? 转换器数目:1 功率耗散（最大）:- 电压电源:模拟和数字 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商设备封装:24-VQFN 裸露焊盘（4x4） 包装:Digi-Reel® 输入数目和类型:8 个单端，单极 产品目录页面:892 (CN2011-ZH PDF) 其它名称:296-25851-6 |
| LTC2486CDE#TRPBF | 功能描述:IC ADC 16BIT W/PGA 14-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率（每秒）:15 数据接口:MICROWIRE?，串行，SPI? 转换器数目:1 功率耗散（最大）:480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN（5x7） 包装:带卷 (TR) 输入数目和类型:16 个单端，双极；8 个差分，双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
发布紧急采购，3分钟左右您将得到回复。