- 您现在的位置：买卖IC网 > PDF目录16037 > LTC2941IDCB#TRMPBF (Linear Technology)IC FUEL/GAS GAUGE LI-ION 6DFN PDF资料下载
参数资料
| 型号： | LTC2941IDCB#TRMPBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/16页 |
| 文件大小： | 0K |
| 描述： | IC FUEL/GAS GAUGE LI-ION 6DFN |
| 标准包装： | 500 |
| 功能： | 燃料，电量检测计/监控器 |
| 电池化学： | 锂离子（Li-Ion） |
| 电源电压： | 2.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-WFDFN 裸露焊盘 |
| 供应商设备封装： | 6-DFN-EP（2x3） |
| 包装： | 带卷 (TR) |
| 配用： | DC1496A-A-ND - BOARD EVAL LTC2941 |
LTC2941
APPLICATIONS INFORMATION
Bit A[5] is set if the LTC2941’s accumulated charge over-
flows or underflows the combined total in registers C and D.
Note that the counting process does not roll over, but simply
stops at FFFFh or 0000h until the direction is reversed.
The LTC2941 includes a battery undervoltage monitor,
which sets bit A1 if the limit is exceeded. Limits are selected
in the control register.
The undervoltage lockout (UVLO) bit A[0] is set if, dur-
ing operation, the voltage on SENSE + drops below 2.7V
without reaching the POR level. The analog parts of the
coulomb counter are switched off while the digital register
values are retained. After recovery of the supply voltage
the coulomb counter resumes integrating with the stored
value in the accumulated charge registers (C, D) but it has
missed any charge flowing while V SENSE+ < 2.7V.
The hard coded bit A[7] of the status register enables the
host to distinguish the LTC2941 from the pin compatible
LTC2942, allowing the same software to be used with
both devices.
Control Register (B)
The operation of the LTC2941 can be controlled by pro-
gramming the control register at address 01h. Table 3
shows the organization of the 8-bit control register B[7:0]
Table 3. Control Register B
BIT NAME OPERATION DEFAULT
B[7:6] V BAT Alert [11] Threshold Value = 3.0V. [00]
[10] Threshold Value = 2.9V.
[01] Threshold Value = 2.8V.
[00] V BAT Alert Off.
B[5:3] Prescaler M Sets coulomb counter prescaling [111]
factor M between 1 and 128.
Default is 128.
M = 2 (4 ? B[5] + 2 ? B[4] + B[3]) .
Power Down B[0]
Programming the last bit B[0] of the control register to 1
sets the analog parts of the LTC2941 in power down and
the current consumption drops typically below 1μA. All
analog circuits are disabled while the values in the registers
are retained. Note that any charge flowing while B[0] is 1
is not measured and the charge information below 1 LSB
of the accumulated charge register is lost.
Alert/Charge Complete Configuration B[2:1]
The AL /CC pin is a dual function pin configured by the
control register. By setting bits B[2:1] to [10] (default)
the AL /CC pin is configured as an alert pin following the
SMBus protocol. In this alert mode the AL /CC pin is a digital
output and is pulled low if one of the measured quantities
exceeds its high or low threshold or if the an overflow/
underflow occurs in the accumulated charge registers C
and D. An alert response procedure started by the master
resets the alert at the AL /CC pin. For further information
see the Alert Response Protocol section.
Setting the control bits B[2:1] to [01] configures the AL /
CC pin as a digital input. In this mode, a high input on the
AL /CC pin communicates to the LTC2941 that the battery
is full and the accumulated charge is set to its maximum
value FFFFh. The AL /CC pin would typically be connected
to the “charge complete” output from the battery charger
circuitry.
If neither the alert nor the charge complete functionality
is desired, bits B[2:1] should be set to [00]. The AL /CC
pin is then disabled and should be tied to GND. Avoid set-
ting B[2:1] to [11] as it enables the alert and the charge
complete modes simultaneously.
B[2:1] AL /CC
Configure
Configures the AL /CC pin.
[10] Alert Mode.
Alert functionality enabled.
Pin becomes logic output.
[01] Charge Complete Mode.
Pin becomes logic input and accepts
“charge complete” signal (e.g., from
a charger) to set accumulated charge
Register to FFFFh.
[00] AL /CC pin disabled.
[10]
Choosing R SENSE and Coulomb Counter
Prescaler “M” B[5:3]
To achieve the specified precision of the coulomb counter
the differential voltage between SENSE + and SENSE – must
stay within ±50mV. For differential input signals up to
±300mV the LTC2941 will remain functional but the preci-
sion of the coulomb counter is not guaranteed.
[11] Not allowed.
B[0]
Shutdown
Shut down analog section to reduce
I SUPPLY .
[0]
2941fa
8
相关PDF资料 |
PDF描述 |
|---|---|
| M3UGK-3436R | IDC CABLE - MKS34K/MC34M/MCS34K |
| CAT1025WI-25-T3 | IC SUPERVISOR W/MEM 2.55V 8SOIC |
| RBM08DCTI-S288 | CONN EDGECARD 16POS .156 EXTEND |
| ECM15DTKI-S288 | CONN EDGECARD 30POS .156 EXTEND |
| LTC1733EMSE#TR | IC CTRLR BATT CHRG LI-ION 10MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC2942CDCB#PBF | 制造商:Linear Technology 功能描述:IC, BATTERY GAS GAUGE, LI-ION, DFN-6; Battery Management Function:Fuel Gauge; Battery Type:Li-Ion; Supply Voltage Min:2.7V; Supply Voltage Max:5.5V; Battery IC Case Style:DFN; No. of Pins:6; IC Interface Type:I2C ;RoHS Compliant: Yes |
| LTC2942CDCB#TRMPBF | 功能描述:IC FUEL/GAS GAUGE LI-ION 6DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 其它有关文件:STC3100 View All Specifications 特色产品:STC3100 - Battery Monitor IC 标准包装:4,000 系列:- 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.7 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MiniSO 包装:带卷 (TR) 其它名称:497-10526-2 |
| LTC2942CDCB#TRPBF | 功能描述:IC FUEL/GAS GAUGE LI-ION 6DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:61 系列:- 功能:电源管理 电池化学:锂离子（Li-Ion）、锂聚合物（Li-Pol） 电源电压:4.35 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:22-WFDFN 裸露焊盘 供应商设备封装:22-DFN（6x3）裸露焊盘 包装:管件 |
| LTC2942CDCB-1#PBF | 制造商:Linear Technology 功能描述:IC BATTERY FUEL GAUGE LI-ION 5.5V DFN-6 制造商:Linear Technology 功能描述:IC, BATTERY FUEL GAUGE LI-ION 5.5V DFN-6 制造商:Linear Technology 功能描述:IC, BATTERY FUEL GAUGE LI-ION 5.5V DFN-6; Battery Management Function:Fuel Gauge, Charge Controller; Battery Type:Li-Ion; Supply Voltage Min:2.7V; Supply Voltage Max:5.5V; Battery IC Case Style:DFN; No. of Pins:6 ;RoHS Compliant: Yes |
| LTC2942CDCB-1#TRMPBF | 功能描述:IC FUEL/GAS GAUGE LI-ION 1A 6DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 其它有关文件:STC3100 View All Specifications 特色产品:STC3100 - Battery Monitor IC 标准包装:4,000 系列:- 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.7 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MiniSO 包装:带卷 (TR) 其它名称:497-10526-2 |
发布紧急采购，3分钟左右您将得到回复。