- 您现在的位置：买卖IC网 > PDF目录20627 > LTC3100EUD#PBF (Linear Technology)IC REG BUCK/BOOST/LINEAR 16-QFN PDF资料下载
参数资料
| 型号： | LTC3100EUD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 15/26页 |
| 文件大小： | 403K |
| 描述： | IC REG BUCK/BOOST/LINEAR 16-QFN |
| 产品培训模块： | More Information on LDOs |
| 标准包装： | 121 |
| 拓扑： | 降压（降压）（1），升压（升压）（1），线性（LDO）（1） |
| 功能： | 任何功能 |
| 输出数： | 3 |
| 频率 - 开关： | 1.5MHz |
| 电压/电流 - 输出 1： | 0.6 V ~ 5.5 V，250mA |
| 电压/电流 - 输出 2： | 1.5 V ~ 5.25 V，700mA |
| 电压/电流 - 输出 3： | 0.6 V ~ 5.25 V，100mA |
| 带 LED 驱动器： | 无 |
| 带监控器： | 无 |
| 带序列发生器： | 是 |
| 电源电压： | 0.5 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-WFQFN 裸露焊盘 |
| 供应商设备封装： | 16-QFN-EP（3x3） |
| 包装： | 管件 |
LTC3100
15
3100fb
For more information www.linear.com/LTC3100
Dropout Operation
As the input voltage decreases to a value approaching the
output regulation voltage, the duty cycle increases toward
the maximum on-time. Further reduction of the supply
voltage will force the main switch to remain on for more
than one cycle until 100% duty cycle operation is reached
where the main switch remains on continuously. In this
dropout state, the output voltage will be determined by
the input voltage less the resistive voltage drop across the
main switch and series resistance of the inductor.
Slope Compensation
Current mode control requires the use of slope compen-
sation to prevent subharmonic oscillations in the inductor
current waveform at high duty cycle operation. This is ac-
complished internally on the LTC3100 through the addition
of a compensating ramp to the current sense signal. In
some current mode ICs, current limiting is performed by
clamping the error amplifier voltage to a fixed maximum.
This leads to a reduced output current capability at low
step-down ratios. In contrast, the LTC3100 performs cur-
rent limiting prior to addition of the slope compensation
ramp and therefore achieves a peak inductor current limit
that is independent of duty cycle.
Short-Circuit Protection
When the buck output is shorted to ground, the error am-
plifier will saturate high and the P-channel MOSFET switch
will turn on at the start of each cycle and remain on until
the current limit trips. During this minimum on-time, the
inductor current will increase rapidly and will decrease very
slowly during the remainder of the period due to the very
small reverse voltage produced by a hard output short.
To eliminate the possibility of inductor current runaway
in this situation, the buck converter switching frequency
is reduced to approximately 375kHz when the voltage on
FBBK falls below 0.3V.
Soft-Start
The buck converter has an internal voltage mode soft-start
circuit with a nominal duration of 1.3ms. The converter
remains in regulation during soft-start and will therefore
respond to output load transients which occur during
this time. In addition, the output voltage rise time has
minimal dependency on the size of the output capacitor
or load current.
Error Amplifier and Compensation
The LTC3100 buck converter utilizes an internal transcon-
ductance error amplifier. Compensation of the feedback
loop is performed internally to reduce the size of the
application circuit and simplify the design process. The
compensation network has been designed to allow use of
a wide range of output capacitors while simultaneously
ensuring rapid response to load transients.
Undervoltage Lockout
If the V
INBK
supply voltage decreases below 1.6V (typical),
the buck converter will be disabled. The soft-start for the
buck converter will be reset during undervoltage lockout
to provide a smooth restart once the input voltage rises
above the undervoltage lockout threshold.
PGOOD Comparator
The PGBK pin is an open-drain output which indicates the
status of the buck converter output voltage. If the buck
output voltage falls 8% below the regulation voltage, the
PGBK open-drain output will pull low. The output voltage
must rise 3% above the falling threshold before the pull-
down will turn off. In addition, there is a 60祍 typical deg-
litching delay in order to prevent false trips due to voltage
transients on load steps. The PGBK output will also pull
low during overtemperature shutdown and undervoltage
lockout to indicate these fault conditions, or if the buck
converter is disabled. The typical PGBK pull-down switch
resistance is 13?when V
INBK
= 3.3V.
Schottky Diode
Although it is not required, adding a Schottky diode from
SWBK to the ground plane will improve efficiency by
about 2%.
OPERATION
相关PDF资料 |
PDF描述 |
|---|---|
| ADE7751ARSZRL | IC ENERGY METERING 1PHASE 24SSOP |
| ISL6609ACRZ | IC MOSFET DRVR SYNC BUCK 8-QFN |
| MCP3905LT-I/SS | IC POWER METERING-1 PHASE 24SSOP |
| ELT-5KT6R8MB | COIL 6.8UH 760MA STEP-UP SMD |
| DFN3.34BK | DURA-FLEX 3.34" BLACK 50' |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3100EUD-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5MHz Synchronous Dual Channel DC/DC Converter and 100mA LDO |
| LTC3101 | 制造商:LINER 制造商全称:Linear Technology 功能描述:8-Output Regulator with Sequencing and I2C |
| LTC3101_10 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Wide VIN, Multi-Output DC/DC Converter and PowerPath Controller |
| LTC3101EUF#PBF | 功能描述:IC BUCK/BST TRPL ADJ 350MA 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:PowerPath™ 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 应用:热电冷却器 电流 - 电源:- 电源电压:3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.173"，4.40mm 宽）裸露焊盘 供应商设备封装:28-TSSOP 裸露焊盘 包装:管件 产品目录页面:1410 (CN2011-ZH PDF) |
| LTC3101EUF#TRPBF | 功能描述:IC BUCK/BST TRPL ADJ 350MA 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:PowerPath™ 标准包装:1 系列:- 应用:手持/移动设备 电流 - 电源:- 电源电压:3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-WFDFN 裸露焊盘 供应商设备封装:14-LLP-EP（4x4） 包装:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名称:LP3905SD-30DKR |
发布紧急采购，3分钟左右您将得到回复。