- 您现在的位置：买卖IC网 > PDF目录67758 > LTC3105EDD#PBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, PDSO10 PDF资料下载
参数资料
| 型号： | LTC3105EDD#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING REGULATOR, PDSO10 |
| 封装： | 3 X 3 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, MO-229WEED-2, DFN-10 |
| 文件页数： | 17/18页 |
| 文件大小： | 1913K |
| 代理商： | LTC3105EDD#PBF |
LTC3105
8
3105fa
Introduction
The LTC3105 is a unique, high performance, synchronous
boost converter that incorporates maximum power point
control, 250mV start-up capability and an integrated LDO
regulator.Thispartoperatesoveraverywiderangeofinput
voltages from 225mV to 5V. Its Burst Mode architecture
and low 24A quiescent current optimize efficiency in low
power applications.
An integrated maximum power point controller allows for
operation directly from high impedance sources such as
photovoltaic cells by preventing the input power source
voltage from collapsing below the user programmable
MPPC threshold. Peak current limits are automatically
adjustedwithproprietarytechniquestomaintainoperation
at levels that maximize power extraction from the source.
The 250mV start-up voltage and 225mV minimum
operating voltage enable direct operation from a single
photovoltaic cell and other very low voltage, high series
impedance power sources such as TEGs and fuel cells.
Synchronous rectification provides high efficiency opera-
tionwhileeliminatingtheneedforexternalSchottkydiodes.
The LTC3105 provides output disconnect which prevents
large inrush currents during start-up. This is particularly
important for high internal resistance power sources like
photovoltaic cells and thermoelectric generators which
can become overloaded if inrush current is not limited
during start-up of the power converter. In addition, output
disconnect isolates VOUT from VIN while in shutdown.
VIN > VOUT Operation
The LTC3105 includes the ability to seamlessly maintain
regulation if VIN becomes equal to or greater than VOUT.
With VIN greater than or equal to VOUT, the synchro-
nous rectifiers are disabled which may result in reduced
efficiency.
Shutdown Control
The SHDN pin is an active low input that places the IC
into low current shutdown mode. This pin incorporates an
internal 2MΩ pull-up resistor which enables the converter
if the SHDN pin is not controlled by an external circuit. The
SHDN pin should be allowed to float while the part is in
OPERATION
start-up mode. Once in normal operation, the SHDN pin
may be controlled using an open-drain or open-collector
pull-down. Other external loads on this pin should be
avoided, as they may result in the part failing to reach
regulation. In shutdown, the internal switch connecting
AUX and VOUT is enabled.
When the SHDN pin is released, the LTC3105 is enabled
and begins switching after a short delay. When either VIN
or VAUX is above 1.4V, this delay will typically range be-
tween 20s and 100s. Refer to the Typical Performance
Characteristics section for more details.
Start-Up Mode Operation
The LTC3105 provides the capability to start with voltages
as low as 250mV. During start-up the AUX output initially
is charged with the synchronous rectifiers disabled. Once
VAUXhasreachedapproximately1.4V,theconverterleaves
start-up mode and enters normal operation. Maximum
powerpointcontrolisnotenabledduringstart-up,however,
the currents are internally limited to sufficiently low levels
to allow start-up from weak input sources.
While the converter is in start-up mode, the internal switch
between AUX and VOUT remains disabled and the LDO
is disabled. Refer to Figure 1 for an example of a typical
start-up sequence.
The LTC3105 is optimized for use with high impedance
power sources such as photovoltaic cells. For operation
fromverylowimpedance,lowinputvoltagesources,itmay
be necessary to add several hundred milliohms of series
input resistance to allow for proper low voltage start-up.
Normal Operation
When either VIN or VAUX is greater than 1.4V typical, the
converter will enter normal operation.
The converter continues charging the AUX output until
the LDO output enters regulation. Once the LDO output
is in regulation, the converter begins charging the VOUT
pin. VAUX is maintained at a level sufficient to ensure the
LDO remains in regulation. If VAUX becomes higher than
required to maintain LDO regulation, charge is transferred
from the AUX output to the VOUT output. If VAUX falls too
low, current is redirected to the AUX output instead of
being used to charge the VOUT output. Once VOUT rises
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3105EMS#PBF | SWITCHING REGULATOR, PDSO12 |
| LTC3105EMS#TRPBF | SWITCHING REGULATOR, PDSO12 |
| LTC3240EDC-3.3 | 0.45 A SWITCHED CAPACITOR REGULATOR, 1800 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3459EDCB#PBF | 0.09 A SWITCHING REGULATOR, PDSO6 |
| LTC3459ES6#PBF | 0.09 A SWITCHING REGULATOR, PDSO6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3105EMS#PBF | 功能描述:IC CONV DC/DC STEP DOWN 12-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:2,000 系列:- 应用:控制器，DSP 输入电压:4.5 V ~ 25 V 输出数:2 输出电压:最低可调至 1.2V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:30-TFSOP（0.173"，4.40mm 宽） 供应商设备封装:30-TSSOP 包装:带卷 (TR) |
| LTC3105EMS#TRPBF | 功能描述:IC CONV DC/DC 400MA HIEFF 12MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3108 | 制造商:LINEAR 制造商全称:LINEAR 功能描述:Ultralow Voltage Step-Up Converter and Power Manager |
| LTC3108_10 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Ultralow Voltage Step-Up Converter and Power Manager |
| LTC3108_12 | 制造商:LINEAR 制造商全称:LINEAR 功能描述:Ultralow Voltage Step-Up Converter and Power Manager |
发布紧急采购，3分钟左右您将得到回复。