参数资料
型号: LTC3200EMS8#TRPBF
厂商: Linear Technology
文件页数: 6/12页
文件大小: 0K
描述: IC REG SWITCHED CAP DBL 8MSOP
标准包装: 2,500
类型: 切换式电容器(充电泵),倍增器
输出数: 1
输入电压: 2.7 V ~ 4.5 V
频率 - 开关: 2MHz
电流 - 输出: 100mA
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-TSSOP,8-MSOP(0.118",3.00mm 宽)
包装: 带卷 (TR)
供应商设备封装: 8-MSOP
LTC3200/LTC3200-5
OPERATIO
Operation (Refer to Simplified Block Diagrams)
The LTC3200/LTC3200-5 use a switched capacitor charge
pump to boost V IN to a regulated output voltage. Regula-
tion is achieved by sensing the output voltage through an
internal resistor divider (LTC3200-5) and modulating the
charge pump output current based on the error signal. A
2-phase nonoverlapping clock activates the charge pump
switches. The flying capacitor is charged from V IN on the
first phase of the clock. On the second phase of the clock
it is stacked in series with V IN and connected to V OUT . This
sequence of charging and discharging the flying capacitor
continues at a free running frequency of 2MHz (typ).
ensure that V OUT is at 0V in shutdown on the adjustable
LTC3200 a bleed resistor may be needed from V OUT to GND.
Typically 10k to 100k is acceptable.
Soft-Start
The LTC3200/LTC3200-5 have built-in soft-start circuitry
to prevent excessive current flow at V IN during start-up.
The soft-start time is preprogrammed to approximately
1ms, so the start-up current will be primarily dependent
upon the output capacitor. The start-up input current can
be calculated with the expression:
In shutdown mode all circuitry is turned off and the
LTC3200/LTC3200-5 draw only leakage current from the
I STARTUP = 2 C OUT
V OUT
1 ms
=
V IN supply. Furthermore, V OUT is disconnected from V IN .
The SHDN pin is a CMOS input with a threshold voltage of
approximately 0.8V. The LTC3200/LTC3200-5 is in shut-
down when a logic low is applied to the SHDN pin. Since
the SHDN pin is a high impedance CMOS input it should
never be allowed to float. To ensure that its state is defined
it must always be driven with a valid logic level.
Short-Circuit/Thermal Protection
The LTC3200/LTC3200-5 have built-in short-circuit current
limiting as well as overtemperature protection. During
short-circuit conditions, they will automatically limit their
output current to approximately 225mA. At higher tempera-
tures, or if the input voltage is high enough to cause exces-
sive self heating on chip, thermal shutdown circuitry will
shut down the charge pump once the junction temperature
exceeds approximately 160 ° C. It will reenable the charge
pump once the junction temperature drops back to approxi-
mately 155 ° C. The LTC3200/LTC3200-5 will cycle in and
out of thermal shutdown indefinitely without latch-up or
damage until the short-circuit on V OUT is removed.
For example, with a 2.2 μ F output capacitor the start-up
input current of an LTC3200-5 will be approximately
22mA. If the output capacitor is 10 μ F then the start-up
input current will be about 100mA.
Programming the LTC3200 Output Voltage (FB Pin)
While the LTC3200-5 version has an internal resistive
divider to program the output voltage, the programmable
LTC3200 may be set to an arbitrary voltage via an external
resistive divider. Since it employs a voltage doubling
charge pump, it is not possible to achieve output voltages
greater than twice the available input voltage. Figure 1
shows the required voltage divider connection.
The voltage divider ratio is given by the expression:
R 1 V OUT
– 1
R 2 1 . 268 V
Typical values for total voltage divider resistance can
range from several k ? s up to 1M ? .
( )
Shutdown Current
Since the output voltage can go above the input voltage,
special circuitry is required to control internal logic.
Detection logic will draw an input current of 5 μ A when the
LTC3200 is in shutdown. However, this current will be
V OUT
FB
PGND
SGND
8
7
4
5
R1
R2
V OUT
1.268V 1 + R1
R2
C OUT
32005 F01
eliminated when the output voltage (V OUT ) is at 0V. To
Figure 1. Programming the Adjustable LTC3200
6
相关PDF资料
PDF描述
LTC3203BEDD-1#TRPBF IC REG BST SWITCHED CAP 5V 10DFN
LTC3204EDC-3.3#TRPBF IC REG SWITCHD CAP DBL 3.3V 6DFN
LTC3216EDE#TRPBF IC CHARGE PUMP LED 12-DFN
LTC3221EDC-3.3#TRMPBF IC REG SWITCHD CAP DBL 3.3V 6DFN
LTC3240EDC-2.5#TRPBF IC REG MULTI CONFIG 2.5V 6DFN
相关代理商/技术参数
参数描述
LTC3200ES6-5 制造商:Linear Technology 功能描述:Charge Pump STPUP 5V 100mA 6-Pin TSOT-23
LTC3200ES6-5#PBF 制造商:Linear Technology 功能描述:DC-DC CONVERTER 2MHZ 5V 100 制造商:Linear Technology 功能描述:DC-DC CONVERTER, 2MHZ, 5V, 100mA, SOT-23-6; Primary Input Voltage:4.5V; No. of Outputs:1; Output Voltage:5V; Output Current:100mA; No. of Pins:6; Operating Temperature Min:-40C; Operating Temperature Max:85C ;RoHS Compliant: Yes
LTC3200ES6-5#TR 功能描述:IC REG SWITCHED CAP DBL SOT23-6 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:500 系列:- 类型:切换式电容器(充电泵),反相 输出类型:固定 输出数:1 输出电压:-3V 输入电压:2.3 V ~ 5.5 V PWM 型:Burst Mode? 频率 - 开关:900kHz 电流 - 输出:100mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 细型,TSOT-23-6 包装:带卷 (TR) 供应商设备封装:TSOT-23-6 其它名称:LTC1983ES6-3#TRMTR
LTC3200ES6-5#TRM 功能描述:IC REG SWITCHED CAP DBL SOT23-6 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:500 系列:- 类型:切换式电容器(充电泵),反相 输出类型:固定 输出数:1 输出电压:-3V 输入电压:2.3 V ~ 5.5 V PWM 型:Burst Mode? 频率 - 开关:900kHz 电流 - 输出:100mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 细型,TSOT-23-6 包装:带卷 (TR) 供应商设备封装:TSOT-23-6 其它名称:LTC1983ES6-3#TRMTR
LTC3200ES6-5#TRMPBF 功能描述:IC REG SWITCHED CAP DBL SOT23-6 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:High Efficiency Current Mode Switching Regulators CMOS LDO Regulators 特色产品:BD91x Series Step-Down Regulators 标准包装:2,500 系列:- 类型:降压(降压) 输出类型:两者兼有 输出数:2 输出电压:3.3V,0.8 V ~ 2.5 V 输入电压:4.5 V ~ 5.5 V PWM 型:电流模式 频率 - 开关:1MHz 电流 - 输出:1.5A 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 包装:带卷 (TR) 供应商设备封装:VQFN020V4040 产品目录页面:1373 (CN2011-ZH PDF) 其它名称:BD9152MUV-E2TR