- 您现在的位置：买卖IC网 > PDF目录20886 > LTC3215EDD#TR (Linear Technology)IC LED DRIVR WHITE BCKLGT 10-DFN PDF资料下载
参数资料
| 型号： | LTC3215EDD#TR |
| 厂商： | Linear Technology |
| 文件页数： | 6/14页 |
| 文件大小： | 0K |
| 描述： | IC LED DRIVR WHITE BCKLGT 10-DFN |
| 标准包装： | 2,500 |
| 拓扑： | PWM，升压（升压），切换式电容器（充电泵） |
| 输出数： | 1 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光，闪灯/白光 |
| 类型 - 次要： | 白色 LED |
| 频率： | 600kHz ~ 1.2MHz |
| 电源电压： | 2.9 V ~ 4.4 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 供应商设备封装： | 10-DFN（3x3） |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
LTC3215
BLOCK DIAGRAM
OSCILLATOR
2
C1 +
10
C1 –
1
C2 +
1X MODE: CPO = V IN
1.5X MODE: CPO = 4.6V
2X MODE: CPO = 5.1V
8
C2 –
CPO
3
–
+
V REF
7
V IN
MODE
CONTROL
DROPOUT
DETECTOR
I LED
4
6
EN
CONTROL
LOGIC
GND
CURRENT
SOURCE
CONTROL
I SET
GND
9
5
11
3215 BD
OPERATION
The LTC3215 uses a fractional switched capacitor charge
pump to power a high current LED with a programmed
regulated current. The part starts up into the 1x mode. In
this mode, V IN is directly connected to CPO. This mode
provides maximum efficiency and minimum noise. The
LTC3215 will remain in this mode until the LED current
source begins to dropout. When dropout is detected,
the LTC3215 will switch to 1.5x mode after a soft-start
period. Any subsequent dropout detected will cause the
part to enter 2x mode. The part may be reset to 1x mode
by bringing the part into shutdown mode and then re-
enabling the part.
A two phase nonoverlapping clock activates the charge
pump switches. In the 2x mode, the flying capacitors are
charged on alternate clock phases from V IN . While one
capacitor is being charged from V IN , the other is stacked
on top of V IN and connected to the output. Alternatively, in
the 1.5x mode the flying capacitors are charged in series
during the first clock phase, and stacked in parallel on
top of V IN on the second clock phase. This sequence of
charging and discharging the flying capacitors continues
at a free running frequency of 900kHz (typ).
The current delivered to the LED load is controlled by
the internal programmable current source. The value of
this current may be selected by choosing the appropriate
programming resistor. The resistor is connected between
the I SET pin and GND. The resistor value needed to attain
the desired current level can be determined by Equation 1.
R SET = 3990/I LED (1)
A resistor value of 2k or less (e.g., a short-circuit) will
cause the LTC3215 to enter overcurrent shutdown mode.
This mode will prevent damage to the part by shutting
down the high power sections of the chip.
3215fc
6
相关PDF资料 |
PDF描述 |
|---|---|
| P51-1500-S-R-I36-20MA-000-000 | SENSOR 1500PSIS M12 4-20 MA |
| REC3-0505SRW/H4/A/CTRL | CONV DC/DC 3W 4.5-9VIN 05VOUT |
| LTC3215EDD | IC LED DRIVR WHITE BCKLGT 10-DFN |
| LTC3210EUD-1#TRPBF | IC LED DRIVR WHITE BCKLGT 16-QFN |
| P51-200-S-R-D-4.5V-000-000 | SENSOR 200PSI M12-1.0 6G .5-4.5V |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3216 | 制造商:LINER 制造商全称:Linear Technology 功能描述:700mA Low Noise High Current LED Charge Pump |
| LTC3216EDE | 制造商:Linear Technology 功能描述:LED DRVR 1Segment 3.3V 12-Pin DFN EP |
| LTC3216EDE#PBF | 功能描述:IC CHARGE PUMP LED 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3216EDE#TRPBF | 功能描述:IC CHARGE PUMP LED 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3217 | 制造商:LINER 制造商全称:Linear Technology 功能描述:600mA Low Noise Multi-LED Camera Light Charge Pump |
发布紧急采购，3分钟左右您将得到回复。