- 您现在的位置：买卖IC网 > PDF目录20886 > LTC3215EDD (Linear Technology)IC LED DRIVR WHITE BCKLGT 10-DFN PDF资料下载
参数资料
| 型号： | LTC3215EDD |
| 厂商： | Linear Technology |
| 文件页数： | 7/14页 |
| 文件大小： | 0K |
| 描述： | IC LED DRIVR WHITE BCKLGT 10-DFN |
| 标准包装： | 121 |
| 拓扑： | PWM，升压（升压），切换式电容器（充电泵） |
| 输出数： | 1 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光，闪灯/白光 |
| 类型 - 次要： | 白色 LED |
| 频率： | 600kHz ~ 1.2MHz |
| 电源电压： | 2.9 V ~ 4.4 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 供应商设备封装： | 10-DFN（3x3） |
| 包装： | 管件 |
| 工作温度： | -40°C ~ 85°C |
LTC3215
OPERATION
–
Regulation is achieved by sensing the voltage at the CPO
pin and modulating the charge pump strength based
on the error signal. The CPO regulation voltages are set
internally, and are dependent on the charge pump mode
as shown in Table 1.
1.5V IN
OR
2V IN
+
R OL
3215 F01
+
CPO
–
Table 1. Charge Pump Output Regulation Voltages
CHARGE PUMP MODE
1.5x
V CPO
4.6V
Figure 1. Charge Pump Open-Loop Thevenin-Equivalent Circuit
2x 5.1V
In shutdown mode all circuitry is turned off and the
LTC3215 draws a very low current from the V IN supply.
Furthermore, CPO is weakly connected to V IN . The LTC3215
enters shutdown mode when the EN pin is brought low.
Since EN is a high impedance CMOS input it should never
be allowed to float. To ensure that its state is defined, it
must always be driven with valid logic levels.
Thermal Protection
The LTC3215 has built-in overtemperature protection.
Thermal shutdown circuitry will shutdown the I LED output
when the junction temperature exceeds approximately
150°C. It will re-enable the I LED output once the junc-
tion temperature drops back to approximately 135°C.
The LTC3215 will cycle in and out of thermal shutdown
indefinitely without latch up or damage until the heat
source is removed.
Soft-Start
To prevent excessive inrush current during start-up and
mode switching, the LTC3215 employs built-in soft-start
circuitry. Soft-start is achieved by increasing the amount
of current available to the output charge storage capacitor
linearly over a period of approximately 250μs.
Charge Pump Strength
When the LTC3215 operates in either the 1.5x mode or 2x
mode, the charge pump can be modeled as a Thevenin-
equivalent circuit to determine the amount of current
available from the effective input voltage and effective
open-loop output resistance, R OL (Figure 1).
R OL is dependent on a number of factors including the
oscillator frequency, flying capacitor values and switch
resistances.
From Figure 1, we can see that the output current is
proportional to:
(1.5V IN – CPO)/R OL or (2V IN – CPO)/R OL (2)
in the 1.5x mode or 2x mode respectively.
LED Current Programming
The LTC3215 includes an accurate, programmable cur-
rent source that is capable of driving LED currents up to
350mA continuously and up to 700mA for pulsed opera-
tion. Pulsed operation may be achieved by toggling the
EN pin. In either continuous or pulsed operation, proper
board layout is required for effective heat sinking.
The current may be programmed using a single external
resistor. Equation 1, used to calculate the resistor value
from the desired current level is repeated below:
R SET = 3990/I LED (1)
For applications requiring multiple current levels, several
schemes may be used to change the resistance for the R SET
resistor. Figure 2 shows two such schemes. The circuit
in Figure 2a uses the I/O output of a microcontroller to
switch a second resistor (R2) in parallel or series with R1,
changing the effective I SET current. Alternatively, the circuit
in Figure 2b uses a pulse-width modulator (PWM) to vary
the current through R SET , which changes the LED current.
3215fc
7
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3210EUD-1#TRPBF | IC LED DRIVR WHITE BCKLGT 16-QFN |
| P51-200-S-R-D-4.5V-000-000 | SENSOR 200PSI M12-1.0 6G .5-4.5V |
| REC5-4809SRWZ/H2/A/M/SMD/CTRL | CONV DC/DC 5W 18-72VIN 09VOUT |
| P51-3000-A-AF-M12-20MA-000-000 | SENSOR 3000PSI 9/16-18UNF 4-20MA |
| P51-75-A-C-M12-4.5OVP-000-000 | SENSOR 75PSI M12-1.5 6G .5-4.5V |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3215EDD#PBF | 功能描述:IC LED DRIVR WHITE BCKLGT 10-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:60 系列:- 恒定电流:- 恒定电压:- 拓扑:线性（LDO），PWM，升压（升压） 输出数:8 内部驱动器:是 类型 - 主要:背光 类型 - 次要:RGB，白色 LED 频率:500kHz ~ 1.5MHz 电源电压:4.75 V ~ 26 V 输出电压:45V 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* 工作温度:-40°C ~ 85°C |
| LTC3215EDD#TR | 功能描述:IC LED DRIVR WHITE BCKLGT 10-DFN RoHS:否 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LTC3215EDD#TRPBF | 功能描述:IC LED DRIVR WHITE BCKLGT 10-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LTC3216 | 制造商:LINER 制造商全称:Linear Technology 功能描述:700mA Low Noise High Current LED Charge Pump |
| LTC3216EDE | 制造商:Linear Technology 功能描述:LED DRVR 1Segment 3.3V 12-Pin DFN EP |
发布紧急采购，3分钟左右您将得到回复。