参数资料
型号: LTC3250ES6-1.5#TRPBF
厂商: Linear Technology
文件页数: 6/12页
文件大小: 0K
描述: IC REG BUCK 1.5V 0.25A SOT23-6
标准包装: 2,500
类型: 降压(降压)
输出类型: 固定
输出数: 1
输出电压: 1.5V
输入电压: 3.1 V ~ 5.5 V
PWM 型: Burst Mode?
频率 - 开关: 1.5MHz
电流 - 输出: 250mA
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: SOT-23-6
包装: 带卷 (TR)
供应商设备封装: SOT-23-6
LTC3250-1.5/LTC3250-1.2
OPERATIO
(Refer to Simplified Block Diagram)
The LTC3250-1.5/LTC3250-1.2 use a switched capacitor
charge pump to step down V IN to a regulated 1.5V ± 4% or
1.2V ± 4% (respectively) output voltage. Regulation is
achieved by sensing the output voltage through an internal
resistor divider and modulating the charge pump output
current based on the error signal. A 2-phase nonoverlapping
clock activates the charge pump switches. On the first
phase of the clock current is transferred from V IN , through
the flying capacitor, to V OUT . Not only is current being
delivered to V OUT on the first phase, but the flying capaci-
tor is also being charged up. On the second phase of the
clock the flying capacitor is connected from V OUT to
ground, delivering the charge stored during the first phase
of the clock to V OUT . Using this method of switching, only
half of the output current is delivered from V IN , thus
achieving twice the efficiency over a conventional LDO.
The sequence of charging and dis-charging the flying
capacitor continues at a free running frequency of 1.5MHz
(typ). This constant frequency architecture provides a low
noise regulated output as well as lower input noise than
conventional switch-capacitor charge pump regulators.
The part also has a low current Burst Mode operation to
improve efficiency even at light loads.
In shutdown mode all circuitry is turned off and the
LTC3250-1.5/LTC3250-1.2 draw only leakage current from
the V IN supply. Furthermore, V OUT is disconnected from
V IN . The SHDN pin is a CMOS input with a threshold
voltage of approximately 0.8V. The LTC3250-1.5/LTC3250-
1.2 are in shutdown when a logic low is applied to the
SHDN pin. Since the SHDN pin is a high impedance CMOS
input it should never be allowed to float. To ensure that its
state is defined it must always be driven with a valid logic
level.
Short-Circuit/Thermal Protection
The LTC3250-1.5/LTC3250-1.2 have built-in short-circuit
current limiting as well as overtemperature protection.
During short-circuit conditions, the parts will automati-
cally limit the output current to approximately 500mA. At
higher temperatures, or if the input voltage is high enough
to cause excessive self heating on chip, thermal shutdown
temperature exceeds approximately 160 ° C. It will reenable
the charge pump once the junction temperature drops
back to approximately 150 ° C. The LTC3250-1.5/LTC3250-
1.2 will cycle in and out of thermal shutdown without latch-
up or damage until the short-circuit on V OUT is removed.
Long term overstress (I OUT > 350mA, and/or T J > 140 ° C)
should be avoided as it can degrade the performance of the
part.
Soft-Start
To prevent excessive current flow at V IN during start-up,
the LTC3250-1.5/LTC3250-1.2 have a built-in soft-start
circuitry. Soft-start is achieved by increasing the amount
of current available to the output charge storage capacitor
linearly over a period of approximately 500 μ s. Soft-start is
enabled whenever the device is brought out of shutdown,
and is disabled shortly after regulation is achieved.
Low Current “Burst Mode” Operation
To improve efficiency at low output currents, Burst Mode
operation was included in the design of the LTC3250-1.5/
LTC3250-1.2. An output current sense is used to detect
when the required output current drops below an inter-
nally set threshold (30mA typ.). When this occurs, the part
shuts down the internal oscillator and goes into a low
current operating state. The LTC3250-1.5/LTC3250-1.2
will remain in the low current operating state until the
output has dropped enough to require another burst of
current. Unlike traditional charge pumps whose burst
current is dependant on many factors (i.e. supply voltage,
switch resistance, capacitor selection, etc.), the LTC3250-
1.5/LTC3250-1.2’s burst current is set by the burst thresh-
old and hysteresis. This means that the V OUT ripple voltage
in Burst Mode will be fixed and is typically 12mV for a
4.7 μ F output capacitor.
Power Efficiency
The power efficiency ( η ) of the LTC3250-1.5/LTC3250-
1.2 are approximately double that of a conventional linear
regulator. This occurs because the input current for a 2 to
1 step-down charge pump is approximately half the output
circuitry will shut down the charge pump once the junction
3250fa
6
相关PDF资料
PDF描述
LTC3251EMSE-1.5#TRPBF IC REG BUCK SWITCHED CAP 10MSOP
LTC3252EDE#TRPBF IC REG BUCK SWITCHED CAP 12DFN
LTC3388IMSE-3#TRPBF IC REG BUCK SYNC 50MA 10MSOP
LTC3400ES6-1#TRPBF IC REG BST SYNC ADJ .85A SOT23-6
LTC3401EMS#TR IC REG BOOST SYNC ADJ 1A 10MSOP
相关代理商/技术参数
参数描述
LTC3251 制造商:LINER 制造商全称:Linear Technology 功能描述:500mA High Efficiency, Low Noise, Inductorless Step-Down DC/DC Converter
LTC3251-1.2 制造商:LINER 制造商全称:Linear Technology 功能描述:500mA High Efficiency, Low Noise, Inductorless Step-Down DC/DC Converter
LTC3251-1.5 制造商:LINER 制造商全称:Linear Technology 功能描述:500mA High Efficiency, Low Noise, Inductorless Step-Down DC/DC Converter
LTC3251EMSE 功能描述:IC REG BUCK SWITCHED CAP 10MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式,混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:8-SOIC
LTC3251EMSE#PBF 功能描述:IC REG BUCK SWITCHED CAP 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON(1.45x1) 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2