- 您现在的位置：买卖IC网 > PDF目录14070 > LTC3404EMS8 (Linear Technology)IC REG BUCK SYNC ADJ 0.6A 8MSOP PDF资料下载
参数资料
| 型号： | LTC3404EMS8 |
| 厂商： | Linear Technology |
| 文件页数： | 11/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 0.6A 8MSOP |
| 标准包装： | 50 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 6 V |
| 输入电压： | 2.65 V ~ 6 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 1.4MHz |
| 电流 - 输出： | 600mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 包装： | 管件 |
| 供应商设备封装： | 8-MSOP |
LTC3404
APPLICATIO S I FOR ATIO
Phase-Locked Loop and Frequency Synchronization
The LTC3404 has an internal voltage-controlled oscillator
and phase detector comprising a phase-locked loop. This
allows the top MOSFET turn-on to be locked to the rising
edge of an external frequency source. The frequency range
of the voltage-controlled oscillator is 1MHz to 1.7MHz. The
phase detector used is an edge sensitive digital type that
provides zero degrees phase shift between the
external and internal oscillators. This type of phase detec-
tor will not lock up on input frequencies close to the har-
monics of the V CO center frequency. The PLL hold-in range
Δ f H is equal to the capture range, Δ f H = Δ f C = 300kHz and
–400kHz.
The output of the phase detector is a pair of complemen-
tary current sources charging or discharging the external
filter network on the PLL LPF pin. The relationship
2.0
1.8
1.6
1.4
1.2
1.0
0.8
between the voltage on the PLL LPF pin and operating
frequency is shown in Figure 4. A simplified block diagram
is shown in Figure 5.
If the external frequency (V SYNC/MODE ) is greater than
1.4MHz, the center frequency, current is sourced
continuously, pulling up the PLL LPF pin. When the
external frequency is less than 1.4MHz, current is sunk
continuously, pulling down the PLL LPF pin. If the
external and internal frequencies are the same but exhibit
a phase difference, the current sources turn on for an
amount of time corresponding to the phase difference.
Thus the voltage on the PLL LPF pin is adjusted until the
phase and frequency of the external and internal oscilla-
tors are identical. At this stable operating point the phase
comparator output is high impedance and the filter
capacitor C LP holds the voltage.
The loop filter components C LP and R LP smooth out the
current pulses from the phase detector and provide a
stable input to the voltage controlled oscillator. The filter
component’s C LP and R LP determine how fast the loop
acquires lock. Typically R LP = 10k and C LP is 2200pF to
0.01 μ F. When not synchronized to an external clock, the
internal connection to the VCO is disconnected. This
disallows setting the internal oscillator frequency by a DC
voltage on the V PLL LPF pin.
0.6
0.4
0.6
0.8
1.0
1.2
1.4
1.6
1.8
2.0
Efficiency Considerations
V PPL LPF (V)
3404 ? F04
Figure 4. Relationship Between Oscillator
Frequency and Voltage at PLL LPF Pin
The efficiency of a switching regulator is equal to the
output power divided by the input power times 100%. It is
often useful to analyze individual losses to determine what
PHASE
DETECTOR
2.4V
R LP
C LP
is limiting the efficiency and which change would produce
the most improvement. Efficiency can be expressed as:
Efficiency = 100% – (L1 + L2 + L3 + ...)
SYNC/
MODE
DIGITAL
PHASE/
FREQUENCY
DETECTOR
PLL LPF
VCO
where L1, L2, etc. are the individual losses as a percentage
of input power.
Although all dissipative elements in the circuit produce
losses, two main sources usually account for most of the
losses in LTC3404 circuits: V IN quiescent current and I 2 R
losses. The V IN quiescent current loss dominates the
efficiency loss at very low load currents whereas the I 2 R
3404 F05
Figure 5. Phase-Locked Loop Block Diagram
loss dominates the efficiency loss at medium to high load
currents. In a typical efficiency plot, the efficiency curve at
3404fb
11
相关PDF资料 |
PDF描述 |
|---|---|
| HM76-302R2JLFTR13 | DRUM CORE HIGH PERF INDUCTORS |
| HM76-301R5JLFTR13 | DRUM CORE HIGH PERF INDUCTORS |
| LNX2L103MSEK | CAP ALUM 10000UF 550V 20% SCREW |
| HM76-301R0JLFTR13 | DRUM CORE HIGH PERF INDUCTORS |
| HM53-103R3VLF | HIGH POWER LOW COST INDUCTORS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3404EMS8#PBF | 功能描述:IC REG BUCK SYNC ADJ 0.6A 8MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3404EMS8#TR | 功能描述:IC REG BUCK SYNC ADJ 0.6A 8MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC3404EMS8#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 0.6A 8MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC3404EMS8PBF | 制造商:Linear Technology 功能描述:DC-DC Converter Step-Down 2.65-6V MSOP8 |
| LTC3404IMS8 | 制造商:Linear Technology 功能描述:DP-SWREG/Monolithic, 1.4MHz High Eff Synch Step-dn Reg |
发布紧急采购，3分钟左右您将得到回复。