- 您现在的位置：买卖IC网 > PDF目录14070 > LTC3404EMS8 (Linear Technology)IC REG BUCK SYNC ADJ 0.6A 8MSOP PDF资料下载
参数资料
| 型号： | LTC3404EMS8 |
| 厂商： | Linear Technology |
| 文件页数： | 9/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 0.6A 8MSOP |
| 标准包装： | 50 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 6 V |
| 输入电压： | 2.65 V ~ 6 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 1.4MHz |
| 电流 - 输出： | 600mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 包装： | 管件 |
| 供应商设备封装： | 8-MSOP |
LTC3404
OPERATIO
Slope Compensation and Inductor Peak Current
Slope compensation provides stability in constant fre-
quency architectures by preventing subharmonic oscilla-
tions at high duty cycles. It is accomplished internally by
adding a compensating ramp to the inductor current
signal at duty cycles in excess of 40%. As a result, the
maximum inductor peak current is reduced for duty cycles
> 40%. This is shown in the decrease of the inductor peak
current as a function of duty cycle graph in Figure 2.
1100
1000
900
800
700
600
V IN = 3.3V
0
20
40
60
80
100
DUTY CYCLE (%)
3404 F02
Figure 2. Maximum Inductor Peak Current vs Duty Cycle
APPLICATIO S I FOR ATIO
The basic LTC3404 application circuit is shown on the first
page. External component selection is driven by the load
requirement and begins with the selection of L followed by
C IN and C OUT .
Inductor Value Calculation
The inductor selection will depend on the operating fre-
quency of the LTC3404. The internal nominal frequency is
1.4MHz, but can be externally synchronized from 1MHz to
1.7MHz.
The operating frequency and inductor selection are inter-
related in that higher operating frequencies allow the use
of smaller inductor and capacitor values. However, oper-
ating at a higher frequency generally results in lower
efficiency because of increased internal gate charge losses.
The inductor value has a direct effect on ripple current. The
ripple current Δ I L decreases with higher inductance or
frequency and increases with higher V IN or V OUT .
The inductor value also has an effect on Burst Mode
operation. The transition to low current operation begins
when the inductor current peaks fall to approximately
250mA. Lower inductor values (higher Δ I L ) will cause this
to occur at lower load currents, which can cause a dip in
efficiency in the upper range of low current operation. In
Burst Mode operation, lower inductance values will cause
the burst frequency to increase.
Inductor Core Selection
Once the value for L is known, the type of inductor must be
selected. High efficiency converters generally cannot
afford the core loss found in low cost powdered iron cores,
forcing the use of more expensive ferrite, molypermalloy,
or Kool M μ ? cores. Actual core loss is independent of core
size for a fixed inductor value, but it is very dependent on
inductance selected. As inductance increases, core losses
go down. Unfortunately, increased inductance requires
more turns of wire and therefore copper losses will
V OUT ? 1 ? OUT ?
Δ I L =
1
( f )( L )
? V ?
? V IN ?
(1)
increase.
Ferrite designs have very low core losses and are pre-
ferred at high switching frequencies, so design goals can
Accepting larger values of Δ I L allows the use of smaller
inductors, but results in higher output voltage ripple and
greater core losses. A reasonable starting point for setting
ripple current is Δ I L = 0.4(I MAX ).
concentrate on copper loss and preventing saturation.
Ferrite core material saturates “hard,” which means that
inductance collapses abruptly when the peak design cur-
rent is exceeded. This results in an abrupt increase in
3404fb
9
相关PDF资料 |
PDF描述 |
|---|---|
| HM76-302R2JLFTR13 | DRUM CORE HIGH PERF INDUCTORS |
| HM76-301R5JLFTR13 | DRUM CORE HIGH PERF INDUCTORS |
| LNX2L103MSEK | CAP ALUM 10000UF 550V 20% SCREW |
| HM76-301R0JLFTR13 | DRUM CORE HIGH PERF INDUCTORS |
| HM53-103R3VLF | HIGH POWER LOW COST INDUCTORS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3404EMS8#PBF | 功能描述:IC REG BUCK SYNC ADJ 0.6A 8MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3404EMS8#TR | 功能描述:IC REG BUCK SYNC ADJ 0.6A 8MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC3404EMS8#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 0.6A 8MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC3404EMS8PBF | 制造商:Linear Technology 功能描述:DC-DC Converter Step-Down 2.65-6V MSOP8 |
| LTC3404IMS8 | 制造商:Linear Technology 功能描述:DP-SWREG/Monolithic, 1.4MHz High Eff Synch Step-dn Reg |
发布紧急采购，3分钟左右您将得到回复。