- 您现在的位置：买卖IC网 > PDF目录1829 > LTC3417AIFE-2#TRPBF (Linear Technology)IC REG BUCK SYNC ADJ DL 20TSSOP PDF资料下载
参数资料
| 型号： | LTC3417AIFE-2#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/20页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ DL 20TSSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 0.8 V ~ 5 V |
| 输入电压： | 2.25 V ~ 5.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 1.5MHz，600kHz ~ 4MHz |
| 电流 - 输出： | 1A，1.5A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 20-TSSOP-EP |
LTC3417A-2
OPERATION
The LTC3417A-2 uses a constant frequency, current
mode architecture. Both channels share the same clock
frequency. The PHASE pin sets whether the channels are
running in-phase or out of phase. The operating frequency
is determined by connecting the FREQ pin to V IN for
1.5MHz operation or by connecting a resistor from FREQ
to ground for a frequency from 0.6MHz to 4MHz. To suit
a variety of applications, the SYNC/MODE pin allows the
user to trade off noise for ef?ciency.
The output voltages are set by external dividers returned
to the V FB1 and V FB2 pins. An error ampli?er compares the
divided output voltage with a reference voltage of 0.8V and
adjusts the peak inductor current accordingly. Undervoltage
comparators will pull the PGOOD output low when either
output voltage is 6% below its targeted value.
Main Control Loop
For each regulator, during normal operation, the P-chan-
nel MOSFET power switch is turned on at the beginning
of a clock cycle when the V FB voltage is below the refer-
ence voltage. The current into the inductor and the load
increases until the current limit is reached. The switch
turns off and energy stored in the inductor ?ows through
the bottom N-channel MOSFET switch into the load until
the next clock cycle.
The peak inductor current is controlled by the voltage
on the I TH pin, which is the output of the error ampli?er.
This ampli?er compares the V FB pin to the 0.8V reference.
When the load current increases the V FB voltage decreases
slightly below the reference. This decrease causes the er-
ror ampli?er to increase the I TH voltage until the average
inductor current matches the new load current.
The main control loop is shut down by pulling the RUN pin
to ground. A digital soft-start is enabled after shutdown,
which will slowly ramp the peak inductor current up over
1024 clock cycles.
To optimize ef?ciency, Burst Mode operation can be se-
lected. When the load is relatively light, the LTC3417A-2
automatically switches into Burst Mode operation in which
the PMOS switches operate intermittently based on load
demand. By running cycles periodically, the switching
losses, which are dominated by the gate charge losses
of the power MOSFETs, are minimized. The main control
loop is interrupted when the output voltage reaches the
desired regulated value. The hysteresis voltage comparator
trips when I TH is below 0.24V, shutting off the switch and
reducing the power. The output capacitor and the induc-
tor supply the power to the load until I TH exceeds 0.31V,
turning on the switch and the main control loop which
starts another cycle.
For lower output voltage ripple at low currents, pulse skip-
ping mode can be used. In this mode, the LTC3417A-2
continues to switch at constant frequency down to very
low currents, where it will begin skipping pulses used to
control the power MOSFETs.
Finally, in forced continuous mode, the inductor current is
constantly cycled creating a ?xed output voltage ripple at all
output current levels. This feature is desirable in telecom-
munications since the noise is a constant frequency and is
thus easy to ?lter out. Another advantage of this mode is
that the regulator is capable of both sourcing current into
a load and sinking some current from the output.
The mode selection for the LTC3417A-2 is set using the
SYNC/MODE pin. The SYNC/MODE pin sets the mode for
both the1A and the 1.5A step-down DC/DC converters.
Dropout Operation
When the input supply voltage decreases toward the output
voltage, the duty cycle increases to 100%. In this dropout
condition, the PMOS switch is turned on continuously with
the output voltage being equal to the input voltage minus
the voltage drops across the internal P-channel MOSFET
and inductor.
Low Current Operation
Three modes are available to control the operation of the
LTC3417A-2 at low currents. Each of the three modes
automatically switch from continuous operation to the
selected mode when the load current is low.
Low Supply Operation
The LTC3417A-2 incorporates an undervoltage lockout
circuit which shuts down the part when the input voltage
drops below about 2.07V to prevent unstable operation.
3417a2fa
8
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3417EDHC#PBF | IC REG BUCK SYNC ADJ DL 16DFN |
| LTC3418EUHF#TRPBF | IC REG BUCK SYNC ADJ 8A 38QFN |
| LTC3419IMS-1#TRPBF | IC REG BUCK SYNC ADJ 0.6A 10MSOP |
| LTC3421EUF#TRPBF | IC REG BOOST SYNC ADJ 1.5A 24QFN |
| LTC3422EDD#TRPBF | IC REG BOOST SYNC ADJ 1.5A 10DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3417AIFEPBF | 制造商:Linear Technology 功能描述:Conv DC-DC Dual Step-Down 5.5V TSSOP20EP |
| LTC3417EDHC | 制造商:Linear Technology 功能描述:Conv DC-DC Dual Step Down 2.25V to 5.5V 16-Pin DFN EP |
| LTC3417EDHC#PBF | 功能描述:IC REG BUCK SYNC ADJ DL 16DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3417EDHC#TRPBF | 功能描述:IC REG BUCK SYNC ADJ DL 16DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3417EFE | 制造商:Linear Technology 功能描述:Conv DC-DC Dual Step Down 2.25V to 5.5V 20-Pin TSSOP EP |
发布紧急采购，3分钟左右您将得到回复。