- 您现在的位置：买卖IC网 > PDF目录14788 > LTC3418EUHF#PBF (Linear Technology)IC REG BUCK SYNC ADJ 8A 38QFN PDF资料下载
参数资料
| 型号： | LTC3418EUHF#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/20页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 8A 38QFN |
| 标准包装： | 52 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 5 V |
| 输入电压： | 2.25 V ~ 5.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 1MHz |
| 电流 - 输出： | 8A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 38-QFN（5x7） |
| 产品目录页面： | 1334 (CN2011-ZH PDF) |
LTC3418
OPERATION
Dropout Operation
When the input supply voltage decreases toward the output
voltage, the duty cycle increases toward the maximum
on-time. Further reduction of the supply voltage forces
the main switch to remain on for more than one cycle
eventually reaching 100% duty cycle. The output voltage
will then be determined by the input voltage minus the
voltage drop across the internal P-channel MOSFET and
Short-Circuit Protection
When the output is shorted to ground, the inductor cur-
rent decays very slowly during a single switching cycle.
To prevent current runaway from occurring, a secondary
current limit is imposed on the inductor current. If the
inductor valley current increases larger than 15A, the top
power MOSFET will be held off and switching cycles will
be skipped until the inductor current is reduced.
the inductor.
Voltage Tracking
Low Supply Operation
The LTC3418 is designed to operate down to an input sup-
ply voltage of 2.25V. One important consideration at low
input supply voltages is that the R DS(ON) of the P-channel
and N-channel power switches increases. The user should
calculate the power dissipation when the LTC3418 is used
at 100% duty cycle with low input voltages to ensure that
thermal limits are not exceeded.
Slope Compensation and Inductor Peak Current
Slope compensation provides stability in constant fre-
quency architectures by preventing subharmonic oscilla-
tions at duty cycles greater than 50%. It is accomplished
internally by adding a compensating ramp to the inductor
current signal. Normally, the maximum inductor peak
current is reduced when slope compensation is added.
In the LTC3418, however, slope compensation recovery
is implemented to keep the maximum inductor peak cur-
rent constant throughout the range of duty cycles. This
keeps the maximum output current relatively constant
regardless of duty cycle.
Some microprocessors and DSP chips need two power
supplies with different voltage levels. These systems often
require voltage sequencing between the core power sup-
ply and the I/O power supply. Without proper sequencing,
latch-up failure or excessive current draw may occur that
could result in damage to the processor’s I/O ports or the
I/O ports of a supporting system device such as memory,
an FPGA or a data converter. To ensure that the I/O loads
are not driven until the core voltage is properly biased,
tracking of the core supply and the I/O supply voltage is
necessary.
Voltage tracking is enabled by applying a ramp voltage
to the TRACK pin. When the voltage on the TRACK pin
is below 0.8V, the feedback voltage will regulate to this
tracking voltage. When the tracking voltage exceeds 0.8V,
control over the feedback voltage is gradually released.
Full release of tracking control over the feedback voltage
is achieved when the tracking voltage exceeds 1.05V.
Voltage Reference Output
The LTC3418 provides a 1.25V reference voltage that is
capable of sourcing up to 5mA of output current. This
reference voltage is generated from a linear regulator
and is intended for applications requiring a low noise
reference voltage. To ensure that the output is stable,
the reference voltage pin should be decoupled with a
minimum of 2.2μF.
3418fb
8
相关PDF资料 |
PDF描述 |
|---|---|
| LGY1J472MELA50 | CAP ALUM 4700UF 63V 20% SNAP |
| VE-BWY-EX-F1 | CONVERTER MOD DC/DC 3.3V 49.5W |
| LT1370CR#PBF | IC REG MULTI CONFIG ADJ 6A D2PAK |
| EBA36DTKD | CONN EDGECARD 72POS DIP .125 SLD |
| LT1082IQ#PBF | IC REG MULTI CONFIG 1A D2PAK |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3419 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Monolithic 600mA Synchronous Step-Down Regulator |
| LTC3419EDD | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Monolithic 600mA Synchronous Step-Down Regulator |
| LTC3419EDD#PBF | 功能描述:IC REG BUCK SYNC ADJ .6A DL 8DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3419EDD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ .6A DL 8DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC3419EDD-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Monolithic 600mA Synchronous Step-Down Regulator |
发布紧急采购，3分钟左右您将得到回复。