- 您现在的位置：买卖IC网 > PDF目录1829 > LTC3427EDC#TRPBF (Linear Technology)IC REG BOOST SYNC ADJ 0.5A 6DFN PDF资料下载
参数资料
| 型号： | LTC3427EDC#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 7/12页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST SYNC ADJ 0.5A 6DFN |
| 标准包装： | 2,500 |
| 类型： | 升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.8 V ~ 5.25 V |
| 输入电压： | 1.8 V ~ 5 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 1.25MHz |
| 电流 - 输出： | 500mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 6-DFN-EP（2x2） |
LTC3427
APPLICATIO S I FOR ATIO
LTC3427
SW 1
6 V OUT
GND 2
5 FB
MINIMIZE
TRACE ON FB
+
V IN 3
4 SHDN
V IN
MULTIPLE VIAS
TO GROUND PLANE
3427 F01
Figure 1. Recommended Component Placement for a Single Layer Board. Traces Carrying High Current are Direct (GND, SW, V IN ,
V OUT ). Trace Area at FB is Kept Low. Lead Length to Battery Should be Kept Short. V IN and V OUT Ceramic Capacitors Should be as
Close to the LTC3427 as Possible. A Multilayer Board with a Separate Ground Plane is Ideal, but not Absolutely Necessary
COMPONENT SELECTION
Inductor Selection
The LTC3427 can utilize small surface mount and chip
inductors due to its fast 1.25MHz switching frequency. A
minimum inductance value of 3.3 μ H is necessary for 3.6V
and lower voltage applications and a 4.7 μ H for output
voltages greater than 3.6V. Larger values of inductance
will allow greater output current capability by reducing the
inductor ripple current. Increasing the inductance above
10 μ H will increase size while providing little improvement
in output current capability.
The approximate output current capability of the LTC3427
vs Inductance value is given below in Equation 1 and
illustrated graphically in Figure 2.
The inductor current ripple is typically set for 20% to 40%
of the maximum inductor current (I P ). High frequency
ferrite core inductor materials reduce frequency depen-
dent power losses compared to cheaper powdered iron
types, improving efficiency. The inductor should have low
ESR (series resistance of the windings) to reduce the I 2 R
power losses, and must be able to handle the peak
inductor current without saturating. Molded chokes and
some chip inductors usually do not have enough core to
support the peak inductor currents of greater than 500mA
seen on the LTC3427. To minimize radiated noise, use a
toroid, pot core or shielded bobbin inductor. See Table 1
for suggested suppliers.
Output and Input Capacitor Selection
Low ESR (equivalent series resistance) capacitors should
? ? ( 1 – D )
I OUT ( MAX ) = n ? ? I P – IN
? V ? D ?
? f ? L ? 2 ?
where:
n = estimated efficiency
I P = peak current limit value (0.5A min)
V IN = input (battery) voltage
D = steady-state duty ratio = (V OUT – V IN )/V OUT
f = switching frequency (1.25MHz typical)
L = inductance value
(1)
be used to minimize the output voltage ripple. Multilayer
ceramic capacitors are an excellent choice as they have
extremely low ESR and are available in small footprints. A
2.2 μ F to 10 μ F output capacitor is sufficient for most
applications. Larger values up to 22 μ F may be used to
obtain extremely low output voltage ripple and improve
transient response. An additional phase lead capacitor
may be required with output capacitors larger than 10 μ F to
maintain acceptable phase margin. X5R and X7R dielec-
tric materials are preferred for their ability to maintain
capacitance over wide voltage and temperature ranges.
3427fa
7
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3428EDD#TRPBF | IC REG BOOST ADJ 4A 10DFN |
| LTC3429ES6#TRM | IC REG BST SYNC ADJ .6A TSOT23-6 |
| LTC3440EDD#TRPBF | IC REG BUCK BOOST SYNC ADJ 10DFN |
| LTC3441EDE#TRPBF | IC REG BUCK BOOST SYNC ADJ 12DFN |
| LTC3442EDE#TRPBF | IC REG BUCK BOOST SYNC ADJ 12DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3428 | 制造商:LINER 制造商全称:Linear Technology 功能描述:4A, 2MHz Dual Phase Step-Up DC/DC Converter in 3mm 3mm DFN |
| LTC3428EDD | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 1.6V to 4.5V 10-Pin DFN EP |
| LTC3428EDD#PBF | 功能描述:IC REG BOOST ADJ 4A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3428EDD#TRPBF | 功能描述:IC REG BOOST ADJ 4A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3428EDDPBF | 制造商:Linear Technology 功能描述:4A 1MHz 2-ph.Step-up DC-DC Conv DFN10EP |
发布紧急采购，3分钟左右您将得到回复。