- 您现在的位置：买卖IC网 > PDF目录1829 > LTC3458EDE#TRPBF (Linear Technology)IC REG BOOST SYNC ADJ 1.4A 12DFN PDF资料下载
参数资料
| 型号： | LTC3458EDE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST SYNC ADJ 1.4A 12DFN |
| 标准包装： | 2,500 |
| 类型： | 升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 2 V ~ 7.5 V |
| 输入电压： | 1.5 V ~ 6 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 1.5MHz |
| 电流 - 输出： | 1.4A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 12-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 12-DFN（4x3） |
LTC3458
APPLICATIO S I FOR ATIO
Error Amp. The error amplifier is a transconductance type,
with its positive input internally connected to the 1.23V
reference, and its negative input connected to FB. A simple
compensation network is placed from COMP to ground.
Internal clamps limit the minimum and maximum error
amp output voltage for improved large signal transient
response. During sleep (in Burst Mode), the compensa-
tion pin is high impedance, however clamps limit the
voltage on the external compensation network, preventing
the compensation capacitor from discharging to zero
during the sleep time.
Oscillator. The frequency of operation is set through a
resistor from R T to ground. An internally trimmed timing
capacitor resides inside the IC. The oscillator frequency is
calculated using the following formula:
Current Sensing. Lossless current sensing converts the
peak current signal to a voltage to sum in with the internal
slope compensation. This summed signal is compared to
the error amplifier output to provide a peak current control
command for the PWM. The slope compensation in the IC
is adaptive to the input and output voltage, therefore the
converter provides the proper amount of slope compensa-
tion to ensure stability, but not an excess to cause a loss
of phase margin in the converter.
Output Disconnect and Inrush Limiting. The LTC3458 is
designed to allow true output disconnect by eliminating
body diode conduction of the internal P-channel MOSFET
rectifier. This allows V 0UT to go to zero volts during
shutdown, drawing no current from the input source. It
also allows for inrush current limiting at turn-on, minimiz-
ing surge currents seen by the input supply. Note that to
f OSC =
1
0 . 2 + 0 . 004 ? R T
obtain the advantages of output disconnect, there must be
no external Schottky diodes connected between SW and
where f OSC is in MHz and R T is in k Ω
The oscillator can be synchronized with an external clock
applied to the SYNC pin. When synchronizing the oscilla-
tor, the free running frequency must be set to approxi-
mately 30% lower than the desired synchronized fre-
quency.
Soft-Start. The soft-start time is programmed with an
external capacitor to ground on SS. An internal current
source charges it with a nominal 5 μ A. The voltage on the
SS pin (in conjunction with the external resistor on I LIM ) is
used to control the peak current limit until the voltage on
the capacitor exceeds ~1V, at which point the external
resistor sets the peak current. In the event of a com-
manded shutdown, severe short-circuit, or a thermal
shutdown, the capacitor is discharged automatically.
t (msec) = C SS ( μ F) ? 200
Other LTC3458 Features and Functions
Antiringing Control. The antiringing control places a
resistor across the inductor to damp the ringing on SW pin
discontinuous conduction mode. The LC ringing
(L = inductor, C SW = Capacitance on SW pin) is low energy,
but can cause EMI radiation.
V OUT .
Shutdown. The part is shut down by pulling SHDN below
0.3V, and made active by pulling the pin above 1.25V. Note
that SHDN can be driven above V IN or V OUT , as long as it
is limited to less than 8V.
Synchronous Rectifier. To prevent the inductor current
from running away, the P-channel MOSFET synchronous
rectifier is only enabled when V OUT > (V IN + 0.25V).
Thermal Shutdown. If the die temperature reaches ap-
proximately 150 ° C, the part will go into thermal shutdown
and all switches will be turned off and the soft-start
capacitor will be reset. The part will be enabled again when
the die temperature has dropped by 10 ° C (nominal).
Zero Current Amplifier. The zero current amplifier moni-
tors the inductor current to the output and shuts off the
synchronous rectifier once the current is below 50mA
typical, preventing negative inductor current.
Burst Mode Operation
Burst Mode operation can be automatic or user controlled.
In automatic operation, the IC will automatically enter
Burst Mode operation at light load and return to fixed
frequency PWM mode for heavier loads. The user can
program the average load current at which the mode
3458fa
9
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3459EDCB#TRPBF | IC REG BOOST SYNC ADJ 6DFN |
| LTC3499BEDD#TRPBF | IC REG BOOST SYNC ADJ 0.75A 8DFN |
| LTC3520EUF#PBF | IC REG BUCK BOOST SYNC ADJ 24QFN |
| LTC3521IFE#TRPBF | IC REG BUCK BST SYNC ADJ 20TSSOP |
| LTC3522EUD#TRPBF | IC REG BUCK BOOST SYNC ADJ 16QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3458L | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.7A, 1.5MHz Synchronous Step-Up DC/DC Converter with Output Disconnect |
| LTC3458LEDE | 功能描述:IC REG BOOST SYNC ADJ 1.4A 12DFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3458LEDE#PBF | 功能描述:IC REG BOOST SYNC ADJ 1.4A 12DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3458LEDE#TRPBF | 功能描述:IC REG BOOST SYNC ADJ 1.4A 12DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3459 | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2MHz Step-Up DC/DC Converter in SOT-23 |
发布紧急采购，3分钟左右您将得到回复。