参数资料
型号: LTC3490ES8#PBF
厂商: Linear Technology
文件页数: 7/12页
文件大小: 0K
描述: IC LED DRIVER PHOTO FLASH 8-SOIC
标准包装: 100
恒定电流:
拓扑: PWM,升压(升压)
输出数: 1
内部驱动器:
类型 - 主要: 闪灯/白光
类型 - 次要: 白色 LED
频率: 1MHz ~ 1.6MHz
电源电压: 1 V ~ 3.2 V
输出电压: 2.8 V ~ 4 V
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
供应商设备封装: 8-SOIC
包装: 管件
工作温度: -40°C ~ 85°C
产品目录页面: 1339 (CN2011-ZH PDF)
LTC3490
APPLICATIO S I FOR ATIO
The LTC3490 requires only four external components to
operate: an inductor, an output capacitor, a switch and a
pull-down resistor. The inductor is nominally set at 3.3 μ H
and the capacitor at 4.7 μ F. Optional components include
an input capacitor and dimming resistors.
COMPONENT SELECTION
Inductor Selection
The high frequency operation of the LTC3490 allows the
use of small surface mount inductors. The minimum
inductance value is proportional to the operating fre-
quency and is limited by the following constraints:
where:
V IN = Input Voltage (V)
V OUT = Output Voltage (V)
I OUT = LED Drive Current (A)
I IN = Input Current = V OUT /V IN ? I OUT (A)
R P = R DSON of the PFET Switch ( ? )
R N = R DSON of the NFET Switch ( ? )
For high efficiency, choose an inductor with a high fre-
quency core material, such as ferrite, to reduce core
losses. The inductor should have low ESR (equivalent
series resistance) to reduce the I 2 R losses and must be
L ≥ H
V IN ( MIN ) ? ( V OUT ( MAX ) – V IN ( MIN )
and
L ≥
3
f
f ? Ripple ? V OUT ( MAX )
) H
able to handle the peak inductor current at full load without
saturating. In single cell applications, the inductor ESR
must be below 25m ? to keep the efficiency up and
maintain output current regulation. Dual cell applications
can tolerate significantly higher ESR (up to 75m ? ) with
minimal efficiency degradation. Molded chokes or chip
inductors usually do not have enough core to support the
where:
f = Operating Frequency (Hz)
Ripple = Inductor Current Ripple (A)
V IN(MIN) = Minimum Input Voltage (V)
peak inductor currents in the 1A to 2A region. If radiated
noise is an issue, use a toroid, pot core or shielded bobbin
inductor to minimize radiated noise. See Table 1 for a list
of suggested inductors. Look closely at the manufacturers
data sheets; they specify saturation current differently.
Table 1. Inductor Information
V OUT(MAX) = Maximum Output Voltage (V)
The inductor current ripple is typically set to 20% to 40%
of the inductor current.
The peak inductor current is given by:
INDUCTOR PART NUMBER
TOKO A918CY-3R3M
TYCO DN4835-3R3M
TDK SLF7045T-3R3M2R5
ESR (m ? )
47
58
20
SATURATION CURRENT (A)
1.97
2.15
2.5
V IN ( V OUT – V IN )
I LPK = I OUT
( V OUT + I OUT ? R P ) – R N ? I IN
V IN – R N ? I IN
+
2 ? L ? f ? V OUT
Output Capacitor Selection
The output capacitor value and equivalent series resis-
tance (ESR) are the primary factors in the output ripple.
The output ripple is not a direct concern for LED drive as
the LED will operate at the average current value. However
the peak pulsed forward current rating of the LED must not
be exceeded to avoid damaging the LED.
3490fa
7
相关PDF资料
PDF描述
DBL17W2P500P30LF CONN DSUB PLUG 17W2 T/H R/A GOLD
MIC4832YMM IC DRIVER LN 220VP-P EL 8-MSOP
TAJY686M016RNJ CAP TANT 68UF 16V 20% 2917
RSA40DRMT CONN EDGECARD 80POS .125 SQ WW
RMA40DRMT CONN EDGECARD 80POS .125 SQ WW
相关代理商/技术参数
参数描述
LTC3499 制造商:LINER 制造商全称:Linear Technology 功能描述:750mA Synchronous Step-Up DC/DC Converters with Reverse-Battery Protection
LTC3499B 制造商:LINER 制造商全称:Linear Technology 功能描述:750mA Synchronous Step-Up DC/DC Converters with Reverse-Battery Protection
LTC3499BEDD 制造商:LINER 制造商全称:Linear Technology 功能描述:750mA Synchronous Step-Up DC/DC Converters with Reverse-Battery Protection
LTC3499BEDD#PBF 功能描述:IC REG BOOST SYNC ADJ 0.75A 8DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON(1.45x1) 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2
LTC3499BEDD#TR 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 1.8V to 5.5V 8-Pin DFN EP T/R