- 您现在的位置：买卖IC网 > PDF目录79748 > LTC3589IUJ#PBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PQCC40 PDF资料下载
参数资料
| 型号： | LTC3589IUJ#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PQCC40 |
| 封装： | 6 X 6 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, QFN-40 |
| 文件页数： | 10/46页 |
| 文件大小： | 570K |
| 代理商： | LTC3589IUJ#PBF |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页
LTC3589/LTC3589-1
18
3589fc
250mA LDO REGULATORS
Three LDO regulators on the LTC3589/LTC3589-1 will
each deliver up to 250mA output. The LDO regulators
are enabled by pin input or I2C command register. Pin
EN_LDO2 enables LDO2 and the LTC3589 EN_LDO34 pin
enables LDO3 and LDO4 together. An I2C command regis-
ter bit is available to decouple LDO4 from pin EN_LDO34
so that LDO4 is under command register control only.
The LTC3589-1 EN_LDO3 pin enables LDO3 only. LDO4
is controlled using the I2C command registers. All the
regulators have current limit protection circuits. When
disabled, a 2.5k internal pull-down resistor is connected
to the regulators output.
To help reduce LDO power loss in the system, the regula-
tors have dedicated supply inputs that may be lower than
the main VIN supply. Connect a low ESR 1μF capacitor to
each of the output pins LDO2, LDO3, and LDO4.
LDO Regulator 2
One of the LTC3589/LTC3589-1 dynamic slewing DACs
serves as the reference input of LDO2. The output range
of LDO2 is set using an external resistor divider connected
from LDO2 to the feedback pin LDO2_FB, as shown in
Figure 2. Set the output voltage of LDO2 using the fol-
lowing formula:
VOUT = 1+
R1
R2
(0.3625+L2DTVx 0.0125)
L2DTVx is the ve bit word contained in the LDO2 dynamic
target voltage 1 (L2DTV1) or the LDO2 dynamic target
voltage 2 (L2DTV2) command registers. The default value
of L2DTVx[4-0] is 11001 to output a reference voltage
of 0.675V. LDO2 is enabled by writing bit 4 in the output
voltage enable (OVEN) command register to 1 or driving
the LDO2_EN pin high. Whenever the command is given to
slew LDO2 DAC reference to a lower voltage an integrated
2.5k pull-down resistor is connected to LDO2 output.
Table 2. Shows the I2C command register settings used
to control LDO2.
Table 2. LDO 2 Command Register Settings
COMMAND
REGISTER[BIT]
VALUE
SETTING
OVEN[4]
0*
1
Disable
Enable
SCR2[4]
0*
1
Wait for Output Below 300mV Before Enable
Enable Immediately
VCCR[5]
0*
1
Select Register L2DTV1 (V1) Reference
Select Register L2DTV2 (V2) Reference
VCCR[6]
1
Initiate Dynamic Voltage Slew
VRRCR[7-6]
00
01
10
11*
Reference Slew Rate = 0.88mV/μs
Reference Slew Rate = 1.75mV/μs
Reference Slew Rate = 3.5mV/μs
Reference Slew Rate = 7mV/μs
L2DTV1[4-0]
11001*
DAC Dynamic Target Voltage V1
L2DTV1[5]
0*
1
Force PGOOD Low When Slewing
Normal PGOOD Operation When Slewing
L2DTV1[7]
0*
1
Shutdown LDO2 Normally
Keep LDO2 Alive
L2DTV2[4-0]
11001*
DAC Dynamic Target Voltage V2
* Denotes Default Power-On Value
OPERATION
3589 F02
PVIN
0.3625V
TO 0.75V
EA
FB
LDO2
R1
1μF
R2
DAC
5
Figure 2. LDO2 Application Circuit
–
+
3589 F01
VIN
0.8V
LDO1_FB
LDO1_STBY
R1
1μF
R2
Figure 1. Always-On LDO Application Circuit
LDO1_STBY is protected from short-circuits and over-
loading.
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3862IFE#TRPBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3388EDD-3#TRPBF | 0.21 A SWITCHING REGULATOR, PDSO10 |
| LNS-X-28 | 1-OUTPUT 85 W AC-DC REG PWR SUPPLY MODULE |
| LQN-2/50-D12H | DC-DC REG PWR SUPPLY MODULE |
| LM2575-33IKTT | 4 A SWITCHING REGULATOR, 63 kHz SWITCHING FREQ-MAX, PSSO5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3589IUJ-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:8-Output Regulator with Sequencing and I2C |
| LTC3600EDD#PBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 12DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3600EDD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 12DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3600EMSE#PBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 12MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3600EMSE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 12MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
发布紧急采购，3分钟左右您将得到回复。