- 您现在的位置：买卖IC网 > PDF目录14832 > LTC3601EMSE#PBF (Linear Technology)IC REG BUCK SYNC ADJ 1.5A 16MSOP PDF资料下载
参数资料
| 型号： | LTC3601EMSE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/26页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 1.5A 16MSOP |
| 标准包装： | 37 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.5 V ~ 14.52 V |
| 输入电压： | 4 V ~ 15 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 800kHz ~ 4MHz |
| 电流 - 输出： | 1.5A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TFSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 16-MSOP，裸露焊盘 |
| 产品目录页面： | 1335 (CN2011-ZH PDF) |
LTC3601
OPERATION
The LTC3601 is a current mode, monolithic, step-down
regulator capable of providing up to 1.5A of output current.
Its unique controlled on-time architecture allows extremely
low step-down ratios while maintaining a constant switch-
ing frequency. Part operation is enabled by raising the
voltage on the RUN pin above 1.25V nominally.
Main Control Loop
In normal operation the internal top power MOSFET is
turned on for a ?xed interval determined by an internal
one-shot timer (“ON” signal in the Block Diagram). When
the top power MOSFET turns off, the bottom power MOS-
FET turns on until the current comparator, I CMP , trips,
thus restarting the one-shot timer and initiating the next
cycle. The inductor current is monitored by sensing the
voltage drop across the SW and PGND nodes of the bot-
tom power MOSFET. The voltage at the ITH pin sets the
I CMP comparator threshold corresponding to the induc-
tor valley current. The error ampli?er EA adjusts this ITH
voltage by comparing an internal 0.6V reference to the
feedback signal, V FB , derived from the output voltage. If, for
example, the load current increases, the feedback voltage
will decrease relative to the internal 0.6V reference. The
ITH voltage then rises until the average inductor current
matches that of the load current.
The operating frequency is determined by the value of the
RT resistor, which programs the current for the internal
oscillator. An internal phase-locked loop servos the switch-
ing regulator on-time to track the internal oscillator edge
and force a constant switching frequency. A clock signal
can be applied to the SYNC/MODE pin to synchronize the
switching frequency to an external source. The regulator
defaults to forced continuous operation once the clock
signal is applied.
At low load currents the inductor current can drop to
zero or become negative. If the LTC3601 is con?gured for
Burst Mode operation, this inductor current condition is
detected by the current reversal comparator, I REV , which
the part into a low quiescent current sleep state resulting
in discontinuous operation and increased ef?ciency at low
load currents. Both power MOSFETs will remain off with
the part in sleep and the output capacitor supplying the
load current until the ITH voltage rises suf?ciently to initi-
ate another cycle. Discontinuous operation is disabled by
tying the MODE/SYNC pin to ground placing the LTC3601
into forced continuous mode. During forced continuous
mode, continuous synchronous operation occurs regard-
less of the output load current.
“Power Good” Status Output
The PGOOD open-drain output will be pulled low if the
regulator output exits a ±8% window around the regulation
point. This condition is released once regulation within
a 5% window is achieved. To prevent unwanted PGOOD
glitches during transients or dynamic V OUT changes, the
LTC3601 PGOOD falling edge includes a ?lter time of ap-
proximately 40μs.
V IN Overvoltage Protection
In order to protect the internal power MOSFET devices
against transient voltage spikes, the LTC3601 constantly
monitors the V IN pin for an overvoltage condition. When
V IN rises above 17.5V, the regulator suspends operation
by shutting off both power MOSFETs. Once V IN drops
below 16.5V, the regulator immediately resumes normal
operation. The regulator does not execute its soft-start
function when exiting an overvoltage condition.
Short-Circuit Protection
Foldback current limiting is provided in the event the
output is inadvertently shorted to ground. During this
condition the internal current limit (I LIM ) will be lowered
to approximately one-third its normal value. This feature
reduces the heat dissipation in the LTC3601 during short-
circuit conditions and protects both the IC and the input
supply from any potential damage.
in turn shuts off the bottom power MOSFET and places
3601fb
9
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3601EUD#PBF | IC REG BUCK SYNC ADJ 1.5A 16QFN |
| GEM44DSEI | CONN EDGECARD 88POS .156 EYELET |
| RBM22DTAT-S189 | CONN EDGECARD 44POS R/A .156 SLD |
| RSM18DSEI-S13 | CONN EDGECARD 36POS .156 EXTEND |
| GMM15DRXS | CONN EDGECARD 30POS DIP .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3601EUD#PBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3601EUD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC3601EUDPBF | 制造商:Linear Technology 功能描述:DC-DC Converter Step-Down 4-15V QFN16EP |
| LTC3601IMSE#PBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3601IMSE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
发布紧急采购，3分钟左右您将得到回复。