- 您现在的位置：买卖IC网 > PDF目录1830 > LTC3613EWKH#PBF (Linear Technology)IC REG BUCK SYNC ADJ 15A 56-QFN PDF资料下载
参数资料
| 型号： | LTC3613EWKH#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/36页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 15A 56-QFN |
| 标准包装： | 40 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 5.5 V |
| 输入电压： | 4.5 V ~ 24 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 200kHz ~ 1MHz |
| 电流 - 输出： | 15A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 56-VFQFN 裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 56-QFN 多焊盘（7x9） |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LTC3613
APPLICATIONS INFORMATION
The Typical Application on the first page of this data sheet
is a basic LTC3613 application circuit. The LTC3613 can
SW
V OUT
be configured to sense the inductor current either through
a series sense resistor, R SENSE , or through an RC filter
across the inductor (DCR). The choice between the two
LTC3613
V OSNS
+
C FF
(OPT)
R FB2
C OUT
current sensing schemes is largely a design trade-off
between cost, power consumption and accuracy. DCR
V OSNS–
R FB1
3613 F01
sensing is becoming popular because it saves expensive
V OUT =0.6V? ? 1+ FB2 ?
current sensing resistors and is more power efficient,
especially in high current applications. However, cur-
rent sensing resistors provide the most accurate current
limits for the controller. Once the required output voltage
and operating frequency have been determined, external
component selection is driven by load requirements, and
begins with the selection of inductor and current sensing
components. Next, the proper current sense threshold is
programmed using the V RNG pin. Finally, input and output
capacitors are selected.
Output Voltage Programming and
Differential Output Sensing
The LTC3613 integrates differential output sensing with
output voltage programming, allowing for simple and
seamless design. As shown in Figure 1, the output voltage
is programmed by an external resistor divider from the
regulated output point to its ground reference. The resis-
tive divider is tapped by the V OSNS+ pin, and the ground
reference is sensed by V OSNS– . An optional feed-forward
capacitor, C FF , can be used to improve the transient per-
formance of the regulator system as discussed under
OPTI-LOOP ? Compensation. The resulting output voltage
is given according to the following equation:
? R ?
? R FB1 ?
More precisely, the V OUT value programmed in the previous
equation is with respect to the output’s ground reference,
and thus is a differential quantity. For example, if V OUT
is programmed to 5V and the output ground reference
is at –0.5V, then the output will be 4.5V with respect to
Figure 1. Setting Output Voltage
The V OSNS+ pin is high impedance with no input bias cur-
rent. The V OSNS– pin has about 35μA of current flowing
out of the pin.
Differential output sensing allows for more accurate output
regulation in high power distributed systems having large
line losses. Figure 2 illustrates the potential variations in
the power and ground lines due to parasitic elements.
These variations are exacerbated in multi-application
systems with shared ground planes. Without differential
output sensing, these variations directly reflect as an error
in the regulated output voltage. The LTC3613’s differential
output sensing can correct for up to ±500mV of variation
in the output’s power and ground lines.
The LTC3613’s differential output sensing scheme is
distinct from conventional schemes where the regulated
output and its ground reference are directly sensed with
a difference amplifier whose output is then divided down
with an external resistive divider and fed into the error
amplifier input. This conventional scheme is limited by
the common mode input range of the difference amplifier
and typically limits differential sensing to the lower range
of output voltages.
The LTC3613 allows for seamless differential output
sensing by sensing the resistively divided feedback volt-
age differentially. This allows for differential sensing in
the full output range from 0.6V to 5.5V. The difference
amplifier of the LTC3613 has a –3dB bandwidth of 8MHz,
high enough to not affect main loop compensation and
transient behavior.
signal ground. The minimum differential output voltage is
limited to the internal reference, 0.6V, and the maximum
differential output voltage is 5.5V.
3613fa
13
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3614IUDD#TRPBF | IC REG BUCK SYNC ADJ 4A 24QFN |
| LTC3615EFE#PBF | IC REG BUCK SYNC ADJ 3A 24TSSOP |
| LTC3616IUDD#TRPBF | IC REG BUCK SYNC ADJ 6A 24QFN |
| LTC3617IUDD#TRPBF | IC REG SYNC 6A BUCK 24QFN |
| LTC3618EFE#PBF | IC REG DUAL SYNC 3A BUCK 24TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3613IWKH#PBF | 功能描述:IC REG BUCK SYNC ADJ 15A 56QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3613IWKH#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 15A 56QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3614EUDD#PBF | 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3614EUDD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3614IUDD#PBF | 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。