- 您现在的位置：买卖IC网 > PDF目录14807 > LTC3614EUDD#PBF (Linear Technology)IC REG BUCK SYNC ADJ 4A 24QFN PDF资料下载
参数资料
| 型号： | LTC3614EUDD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 24/30页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 4A 24QFN |
| 标准包装： | 73 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 5.5 V |
| 输入电压： | 2.25 V ~ 5.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 300kHz ~ 4MHz |
| 电流 - 输出： | 4A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-WFQFN 裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 24-QFN 裸露焊盘（3x5） |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页第29页第30页
LTC3614
APPLICATIONS INFORMATION
3.82 11 Hz
R T = k – 16k = 130k Ω
L = ?
? ? ? 1 –
? = 0.35μH
ThermalConsiderations
In most applications, the LTC3614 does not dissipate
much heat due to its high efficiency.
However, in applications where the LTC3614 is running
at high ambient temperature with low supply voltage and
high duty cycles, such as in dropout, the heat dissipated
may exceed the maximum junction temperature of the part.
If the junction temperature reaches approximately 170°C,
both power switches will be turned off and the SW node
will become high impedance.
To prevent the LTC3614 from exceeding the maximum
junction temperature, some thermal analysis is required.
The temperature rise is given by:
T RISE = (P D )( θ JA )
where P D is the power dissipated by the regulator and
θ JA is the thermal resistance from the junction of the die
to the ambient temperature. The junction temperature,
T J , is given by:
T J = T A + T RISE
where T A is the ambient temperature.
As an example, consider the case when the LTC3614 is in
dropout at an input voltage of 3.3V with a load current of
4A at an ambient temperature of 85°C. From the Typical
Performance Characteristics graph of Switch Resistance,
the R DS(ON) resistance of the P-channel switch is 0.038Ω.
Therefore, power dissipated by the part is:
Note that for very low input voltage, the junction tempera-
ture will be higher due to increased switch resistance,
R DS(ON) . It is not recommended to use full load current
with high ambient temperature and low input voltage.
To maximize the thermal performance of the LTC3614 the
exposed pad should be soldered to a ground plane. See
the PCB Layout Board Checklist.
Design Example
As a design example, consider using the LTC3614 in an
application with the following specifications:
V IN = 2.25V to 5.5V, V OUT = 1.8V, I OUT(MAX) = 4A, I OUT(MIN)
= 200mA, f = 2.6MHz.
Efficiency is important at both high and low load current,
so Burst Mode operation will be utilized.
First, calculate the timing resistor:
2.6MHz
Next, calculate the inductor value for about 33% ripple
current at maximum V IN :
? 1.8V ? ? 1.8V ?
? 2.6MHz ? 1.3A ? ? 5.5V ?
Using a standard value of 0.33μH inductor results in a
maximum ripple current of:
? I L = ?
? ? ? 1 –
? = 1.41A
P D =(I OUT ) 2 ?R DS(ON) = 0.61W
For the QFN package, the θ JA is 38°C/W.
? 1.8V ? ?
? 2.6MHz ? 0.33μH ? ?
1.8V ?
5.5V ?
Therefore, the junction temperature of the regulator op-
erating at 85°C ambient temperature is approximately:
T J = 0.61W ? 38° C/W + 85°C = 108°C
We can safely assume that the actual junction temperature
will not exceed the absolute maximum junction tempera-
ture of 125°C.
C OUT will be selected based on the ESR that is required
to satisfy the output voltage ripple requirement and the
bulk capacitance needed for loop stability. For this design,
a 100μF ceramic capacitor is used with a X5R or X7R
dielectric.
24
For more information www.linear.com/LTC3614
3614fb
相关PDF资料 |
PDF描述 |
|---|---|
| RCM31DCAN-S189 | CONN EDGECARD 62POS R/A .156 SLD |
| LT1507CS8#PBF | IC REG BUCK ADJ 1.5A 8SOIC |
| LT1375CS8-5#PBF | IC REG BUCK 5V 1.5A 8SOIC |
| RCM31DCAH-S189 | CONN EDGECARD 62POS R/A .156 SLD |
| LT3681EDE#PBF | IC REG BUCK ADJ 2A 14DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3614IUDD#PBF | 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3614IUDD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3614MPUDD#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN |
| LTC3614MPUDD#TRPBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN |
| LTC3615EFE#PBF | 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。