- 您现在的位置：买卖IC网 > PDF目录44992 > LTC3634EFE#PBF (LINEAR TECHNOLOGY CORP) 5.5 A DUAL SWITCHING CONTROLLER, 4600 kHz SWITCHING FREQ-MAX, PDSO28 PDF资料下载
参数资料
| 型号： | LTC3634EFE#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 5.5 A DUAL SWITCHING CONTROLLER, 4600 kHz SWITCHING FREQ-MAX, PDSO28 |
| 封装： | 4.40 MM, LEAD FREE, PLASTIC, TSSOP-28 |
| 文件页数： | 26/28页 |
| 文件大小： | 359K |
| 代理商： | LTC3634EFE#PBF |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页当前第26页第27页第28页
LTC3634
7
3634f
pin FuncTions
PGOOD1(Pin1/Pin4):Channel1Open-DrainPowerGood
Output Pin. PGOOD1 is pulled to ground when the voltage
on the VFB1 pin is not within ±8% (typical) of the internal
0.6V reference. This threshold has 15mV of hysteresis.
PHMODE (Pin 2/Pin 5): Phase Select Input. Tie this pin to
ground to force both channels to switch 90° out-of-phase.
Tie this pin to INTVCC to force both channels to switch
180° out-of-phase. Do not float this pin.
RUN1 (Pin 3/Pin 6): Channel 1 Regulator Enable Pin.
Enables channel 1 operation by tying RUN1 above 1.22V.
Tying it below 1V places the part into shutdown. Do not
float this pin.
MODE/SYNC (Pin 4/Pin 7): Channel 1 Mode Select and
External Synchronization Input. Tie this pin to ground to
force continuous synchronous operation on Channel 1.
Floating this pin or tying it to INTVCC enables high
efficiency Burst Mode operation at light loads. Channel 2
operation is forced continuous regardless of the state of
this pin. Drive this pin with a clock to synchronize the
LTC3634 switching frequency. An internal phase-locked
loop will force the bottom power NMOS’s turn-on signal to
be synchronized with the rising edge of the CLKIN signal.
When this pin is driven with a clock, forced continuous
mode is automatically selected.
RT (Pin 5/Pin 8): Oscillator Frequency Program Pin.
Connect an external resistor (between 80k to 640k) from
this pin to SGND in order to program the frequency from
500kHz to 4MHz. When RT is tied to INTVCC, the switch-
ing frequency will default to 2MHz. See the Applications
Information section.
RUN2 (Pin 6/Pin 9): Channel 2 Regulator Enable Pin.
Enables channel 2 operation by tying RUN2 above 1.22V.
Tying it below 1V places the part into shutdown. Do not
float this pin.
SGND (Pin 7/Pin 10): Signal Ground Pin. This pin should
have a low noise connection to reference ground. The
feedbackresistornetwork,externalcompensationnetwork,
and RT resistor should be connected to this ground.
PGOOD2 (Pin 8/Pin 11): Channel 2 Open-Drain Power
Good Output Pin. PGOOD2 is pulled to ground when
the voltage on the VFB2 pin is not within 8% (typical) of
VDDQIN 0.5. This threshold has 15mV of hysteresis.
VFB2 (Pin 9/Pin 12): Channel 2 Output Feedback Voltage
Pin.Inputtotheerroramplifierthatcomparesthefeedback
voltage to VTTR. Connect this pin directly to the output in
order to set VOUT2 equal to VTTR.
VDDQIN (Pin 10/Pin 13): External Reference Input for
Channel 2. An internal resistor divider sets the VTTR pin
voltage to be equal to half the voltage applied to this input.
Channel 2 uses the VTTR pin voltage as its error amplifier
reference.
ITH2 (Pin 11/Pin 14): Channel 2 Error Amplifier Output
and Switching Regulator Compensation Pin. Connect this
pin to appropriate external components to compensate
the regulator loop frequency response. See the Applica-
tions Information section for guidelines on component
selection.
VON2 (Pin 12/Pin 15): On-Time Voltage Input for Chan-
nel 2. This pin sets the voltage trip point for the on-time
comparator. Tying this pin to the output voltage makes
the on-time proportional to VOUT2 when VOUT2 < 3V. When
VOUT2 > 3V, switching frequency may become higher than
the set frequency (see the Applications Information sec-
tion). The pin impedance is nominally 150kΩ.
SW2 (Pins 13, 14/Pins 16, 17): Channel 2 Switch Node
Connection to External Inductor. Voltage swing of SW is
from a diode voltage below ground to a diode voltage
above VIN2.
VIN2 (Pins 15, 16/Pins 18, 19): Power Supply Input for
Channel 2. Input voltage to the on-chip power MOSFETs
on channel 2. This input is capable of operating from a
supply voltage separate from VIN1.
BOOST2 (Pin 17/Pin 20): Boosted Floating Driver Supply
for Channel 2. The (+) terminal of the bootstrap capacitor
connects to this pin while the (–) terminal connects to
the SW pin. The normal operation voltage swing of this
pin ranges from a diode voltage drop below INTVCC up
to VIN2 + INTVCC.
(QFN/TSSOP)
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3642IMS8E-3.3E#PBF | 0.13 A SWITCHING REGULATOR, PDSO8 |
| LTC3672BEDC-2#PBF | 1.1 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3707IGN-SYNC | 3 A SWITCHING CONTROLLER, 360 kHz SWITCHING FREQ-MAX, PDSO28 |
| LTC3728IUH | 3 A DUAL SWITCHING CONTROLLER, 590 kHz SWITCHING FREQ-MAX, PQCC32 |
| LTC3728IG | 3 A DUAL SWITCHING CONTROLLER, 590 kHz SWITCHING FREQ-MAX, PDSO28 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3634EUFD#PBF | 功能描述:IC CONV DDR DDR2 DDR3 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3634EUFD#TRPBF | 功能描述:IC CONV DDR DDR2 DDR3 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3634HFE#PBF | 制造商:Linear Technology 功能描述:IC CONV DDR DDR2 DDR3 28TSSOP 制造商:Linear Technology 功能描述:BUCK 15V 3A 500KHZ-4MHZ TS 制造商:Linear Technology 功能描述:DP-SWREG/Monolithic, 15V Dual 3A Monolithic Step Down Regulator for DDR Power 制造商:Linear Technology 功能描述:DC-DC REGULATOR, BUCK, ADJ, TSSOP-28, Primary Input Voltage:15V, No. of Outputs:2, Output Current:3A, No. of Pins:28, Operating Temperature Min:-40C, Operating Temperature Max:150C, MSL:MSL 1 - Unlimited, Package / Case:28-TSSOP , RoHS Compliant: Yes |
| LTC3634HFE#TRPBF | 制造商:Linear Technology 功能描述:IC REG 15V 3A STEP DOWN 28-TSSOP |
| LTC3634HUFD#PBF | 制造商:Linear Technology 功能描述:IC CONV DDR DDR2 DDR3 28-QFN 制造商:Linear Technology 功能描述:BUCK 15V 3A 500KHZ-4MHZ QF 制造商:Linear Technology 功能描述:DC-DC REGULATOR, BUCK, ADJ, QFN-28, Primary Input Voltage:15V, No. of Outputs:2, Output Current:3A, No. of Pins:28, Operating Temperature Min:-40C, Operating Temperature Max:150C, MSL:MSL 1 - Unlimited, Package / Case:28-QFN , RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。