- 您现在的位置：买卖IC网 > PDF目录15314 > LTC3703EGN-5#TRPBF (Linear Technology)IC REG CTRLR BST PWM VM 16-SSOP PDF资料下载
参数资料
| 型号： | LTC3703EGN-5#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 12/32页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST PWM VM 16-SSOP |
| 标准包装： | 2,500 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 330kHz |
| 占空比： | 96% |
| 电源电压： | 4.1 V ~ 15 V |
| 降压： | 是 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页当前第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC3703-5
OPERATIO
(Refer to Functional Diagram)
Buck or Boost Mode Operation
The LTC3703-5 has the capability of operating both as a
step-down (buck) and step-up (boost) controller. In boost
mode, output voltages as high as 60V can be tightly
regulated. With the INV pin grounded, the LTC3703-5
operates in buck mode with TG driving the main (top side)
switch and BG driving the synchronous (bottom side)
switch. If the INV pin is pulled above 2V, the LTC3703-5
operates in boost mode with BG driving the main (bottom
side) switch and TG driving the synchronous (top side)
switch. Internal circuit operation is very similar regardless
APPLICATIO S I FOR ATIO
The basic LTC3703-5 application circuit is shown on the first
page of this data sheet. External component selection is de-
termined by the input voltage and load requirements as
explained in the following sections. After the operating
frequency is selected, R SET and L can be chosen. The
operating frequency and the inductor are chosen for a
desired amount of ripple current and also to optimize ef-
ficiency and component size. Next, the power MOSFETs and
D1 are selected based on voltage, load and efficiency re-
quirements. C IN is selected for its ability to handle the large
RMS currents in the converter and C OUT is chosen with low
enough ESR to meet the output voltage ripple and transient
specifications. Finally, the loop compensation components
of the operating mode with the following exceptions: In
boost mode, Pulse Skip Mode operation is always dis-
abled regardless of the level of the MODE/SYNC pin and
the line feedforward compensation is also disabled. The
overcurrent circuitry continues to monitor the load current
by looking at the drain voltage of the main (bottom side)
MOSFET. In boost mode, however, the peak MOSFET
current does not equal the load current but instead
I D = I LOAD /(1 – D). This factor needs to be taken into
account when programming the I MAX voltage.
noise-sensitive communications systems, it is often de-
sirable to keep the switching noise out of a sensitive
frequency band.
The LTC3703-5 uses a constant frequency architecture
that can be programmed over a 100kHz to 600kHz range
with a single resistor from the f SET pin to ground, as shown
in the circuit on the first page of this data sheet. The
nominal voltage on the f SET pin is 1.2V, and the current that
flows from this pin is used to charge and discharge an
internal oscillator capacitor. The value of R SET for a given
operating frequency can be chosen from Figure 6 or from
the following equation:
are chosen to meet the desired transient specifications.
Operating Frequency
The choice of operating frequency and inductor value is a
trade off between efficiency and component size. Low
frequency operation improves efficiency by reducing
MOSFET switching losses and gate charge losses. How-
ever, lower frequency operation requires more induc-
tance for a given amount of ripple current, resulting in a
larger inductor size and higher cost. If the ripple current
is allowed to increase, larger output capacitors may be
required to maintain the same output ripple. For convert-
R SET ( k ? ) =
1000
100
10
7100
f ( kHz ) – 25
ers with high step-down V IN to V OUT ratios, another
1
0
200
400
600
800
1000
consideration is the minimum on-time of the LTC3703-5
(see the Minimum On-time Considerations section). A
final consideration for operating frequency is that in
FREQUENCY (kHz)
37035 F06
Figure 6. Timing Resistor (R SET ) Value
37035fa
12
相关PDF资料 |
PDF描述 |
|---|---|
| RMA15DRMH-S288 | CONN EDGECARD 30POS .125 EXTEND |
| RSA15DRMD-S288 | CONN EDGECARD 30POS .125 EXTEND |
| LTC3703EGN-5#TR | IC REG CTRLR BST PWM VM 16-SSOP |
| VI-22Y-EY-B1 | CONVERTER MOD DC/DC 3.3V 33W |
| EBC36DREH-S734 | CONN EDGECARD 72POS .100 EYELET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3703EGNPBF | 制造商:Linear Technology 功能描述:100V Synch Sw. Reg. Controller SSOP16 |
| LTC3703EGPBF | 制造商:Linear Technology 功能描述:LTC3703 100V SU/SD PS controller |
| LTC3703HGN | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Sync Step Down 9.3V to 100V Input 16-Pin SSOP N |
| LTC3703HGN#PBF | 功能描述:IC REG CTRLR BST PWM VM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3703HGN#TRPBF | 功能描述:IC REG CTRLR BST PWM VM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。