- 您现在的位置：买卖IC网 > PDF目录15342 > LTC3704EMS#TR (Linear Technology)IC REG CTRLR INV PWM CM 10-MSOP PDF资料下载
参数资料
| 型号： | LTC3704EMS#TR |
| 厂商： | Linear Technology |
| 文件页数： | 24/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR INV PWM CM 10-MSOP |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1MHz |
| 占空比： | 97% |
| 电源电压： | 2.5 V ~ 36 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 是 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 包装： | 带卷 (TR) |
| 其它名称： | LTC3704EMSTR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页
LTC3704
APPLICATIO S I FOR ATIO
2. Beware of ground loops in multiple layer PC boards. Try
to maintain one central ground node on the board and
use the input capacitor to avoid excess input ripple for
high output current power supplies. If the ground plane
is to be used for high DC currents, choose a path away
from the small-signal components.
3. Place the C VCC capacitor immediately adjacent to the
INTV CC and GND pins on the IC package. This capacitor
carries high di/dt MOSFET gate drive currents. A low
ESR X5R-dielectric 4.7 μ F ceramic capacitor works well
here.
4. The high di/dt loop from the drain of the power MOSFET,
through the coupling capacitor and back through the
diode to ground should be kept as tight as possible to
reduce inductive ringing. Excess inductance can cause
increased stress on the power MOSFET and increase HF
noise on the drain node. It is also important to keep the
cathode of the diode as close as possible to the MOSFET
source or the bottom of the sense resistor.
5. Check the stress on the power MOSFET by measuring
its drain-to-source voltage directly across the device
terminals (reference the ground of a single scope probe
directly to the source pad on the PC board). Beware of
inductive ringing which can exceed the maximum speci-
fied voltage rating of the MOSFET. If this ringing cannot
be avoided and exceeds the maximum rating of the
device, either choose a higher voltage device or specify
an avalanche-rated power MOSFET. Not all MOSFETs
are created equal (some are more equal than others).
6. Place the small-signal components away from high
frequency switching nodes. In the layout shown in
Figure 22, all of the small-signal components have been
placed on one side of the IC and all of the power
components have been placed on the other. This also
allows the use of a pseudo-Kelvin connection for the
signal ground, where high di/dt gate driver currents
flow out of the IC ground pin in one direction (to the
bottom plate of the INTV CC decoupling capacitor) and
small-signal currents flow in the other direction.
7. If a sense resistor is used in the source of the power
MOSFET, minimize the capacitance between the SENSE
pin trace and any high frequency switching nodes. The
LTC3704 contains an internal leading edge blanking
time of approximately 180ns, which should be ad-
equate for most applications.
8. For optimum load regulation and true remote sensing,
the top of the output resistor divider should connect
independently to the top of the output capacitor (Kelvin
connection), staying away from any high dV/dt traces.
Place the divider resistors near the LTC3704 in order to
keep the high impedance FB node short.
9. For applications with multiple switching power con-
verters connected to the same input supply, make sure
that the input filter capacitor for the LTC3704 is not
shared with other converters. AC input current from
another converter could cause substantial input voltage
ripple, and this could interfere with the operation of the
LTC3704. A few inches of PC trace or wire (L ≈ 100nH)
between the C IN of the LTC3704 and the actual source
V IN should be sufficient to prevent current sharing
problems.
3704fb
24
相关PDF资料 |
PDF描述 |
|---|---|
| RSC17DRTI | CONN EDGECARD 34POS DIP .100 SLD |
| ADM8698ANZ | IC SUPERVISOR MPU 4.65V 8DIP |
| EBC17DREF-S734 | CONN EDGECARD 34POS .100 EYELET |
| GCC31DCST-S288 | CONN EDGECARD 62POS .100 EXTEND |
| VE-BWV-EV-F3 | CONVERTER MOD DC/DC 5.8V 150W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3704IMS | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Pos-Neg 2.5V to 36V Input 10-Pin MSOP |
| LTC3704IMS#PBF | 功能描述:IC REG CTRLR INV PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3704IMS#TR | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Pos-Neg 2.5V to 36V Input 10-Pin MSOP T/R |
| LTC3704IMS#TRPBF | 功能描述:IC REG CTRLR INV PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3705EGN#PBF | 功能描述:IC CTRLR OCP 16SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - AC-DC 转换器，离线开关 系列:- 标准包装:3,000 系列:- 输出隔离:隔离 频率范围:61kHz ~ 71kHz 输入电压:9.4 V ~ 28 V 输出电压:12V 功率（瓦特）:- 工作温度:-40°C ~ 125°C 封装/外壳:SC-74，SOT-457 供应商设备封装:6-TSOP 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。