- 您现在的位置：买卖IC网 > PDF目录13071 > LTC3714EG#TR (Linear Technology)IC STP-DWN CNTRLR W/OPAMP 28SSOP PDF资料下载
参数资料
| 型号： | LTC3714EG#TR |
| 厂商： | Linear Technology |
| 文件页数： | 10/28页 |
| 文件大小： | 0K |
| 描述： | IC STP-DWN CNTRLR W/OPAMP 28SSOP |
| 标准包装： | 2,000 |
| 应用： | 控制器，Intel Pentium? |
| 输入电压： | 4 V ~ 36 V |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 1.75 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 28-SSOP |
| 包装： | 带卷 (TR) |
| 其它名称： | LTC3714EGTR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC3714
OPERATION
Main Control Loop
The LTC3714 is a constant on-time, current mode controller
for DC/DC step-down converters. In normal operation, the
top MOSFET is turned on for a fixed interval determined
by a one-shot timer OST. When the top MOSFET is turned
off, the bottom MOSFET is turned on until the current
comparator I CMP trips, restarting the one-shot timer and
initiating the next cycle. Inductor current is determined
by sensing the voltage between the PGND and SENSE
pins using either the bottom MOSFET on-resistance or a
separate sense resistor. The voltage on the I TH pin sets
the comparator threshold corresponding to inductor val-
ley current. The error amplifier EA adjusts this voltage by
comparing the feedback signal V FB from the output voltage
with an internal 0.6V reference. The feedback voltage is
derived from the output voltage by a resistive divider DAC
that is set by the VID code pins VID0-VID4. If the load
current increases, it causes a drop in the feedback voltage
relative to the reference. The I TH voltage then rises until the
average inductor current again matches the load current.
At low load currents, the inductor current can drop to zero
and become negative. This is detected by current reversal
comparator I REV which then shuts off M2, resulting in
discontinuous operation. Both switches will remain off
with the output capacitor supplying the load current until
the I TH voltage rises above the zero current level (0.8V)
to initiate another cycle. Continuous synchronous opera-
tion can be forced in the LTC3714 by bringing the FCB pin
below 0.6V. The benefit of forced continuous operation is
lower output voltage ripple, faster transient response to
current load steps and a much quieter frequency spec-
trum so that it won’t interfere with any neighboring noise
sensitive components.
The operating frequency is determined implicitly by the
top MOSFET on-time and the duty cycle required to main-
tain regulation. The one-shot timer generates an on-time
that is proportional to the ideal duty cycle, thus holding
frequency approximately constant with changes in V IN
and V OUT . The nominal frequency can be adjusted with
an external resistor R ON .
Overvoltage and undervoltage comparators OV and UV
pull the PGOOD output low if the output feedback volt-
age exits a ±10% window around the regulation point.
Furthermore, in an overvoltage condition, M1 is turned
off and M2 is turned on and held on until the overvoltage
condition clears.
Foldback current limiting is provided if the output is
shorted to ground. As V FB drops, the buffered current
threshold voltage I THB is pulled down by clamp Q3 to
a 1V level set by Q2 and Q6. This reduces the inductor
valley current level to one sixth of its maximum value as
V FB approaches ground.
Pulling the RUN/SS pin low forces the controller into its
shutdown state, turning off both M1 and M2. Releasing
the pin allows an internal 1.2μA current source to charge
up an external soft-start capacitor C SS . When this voltage
reaches 1.5V, the controller turns on and begins switching,
but with the I TH voltage clamped at approximately 0.6V
below the RUN/SS voltage. As C SS continues to charge,
the soft-start current limit is removed.
3714f
10
相关PDF资料 |
PDF描述 |
|---|---|
| RBC22DREN-S93 | CONN EDGECARD 44POS .100 EYELET |
| C1005X7R1H102M | CAP CER 1000PF 50V 20% X7R 0402 |
| AHA336M35D16T-F | CAP ALUM 33UF 35V 20% SMD |
| EBA50DTBZ-S664 | CONN EDGECARD 100PS R/A .125 SLD |
| MIC5239YMM | IC REG LDO ADJ .5A 8MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3716EG | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3716EG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3716EG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3716EG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3717-1#PBF | 制造商:LINEAR 功能描述: 制造商:Linear Technology 功能描述: |
发布紧急采购，3分钟左右您将得到回复。