- 您现在的位置：买卖IC网 > PDF目录13071 > LTC3714EG#TR (Linear Technology)IC STP-DWN CNTRLR W/OPAMP 28SSOP PDF资料下载
参数资料
| 型号： | LTC3714EG#TR |
| 厂商： | Linear Technology |
| 文件页数： | 8/28页 |
| 文件大小： | 0K |
| 描述： | IC STP-DWN CNTRLR W/OPAMP 28SSOP |
| 标准包装： | 2,000 |
| 应用： | 控制器，Intel Pentium? |
| 输入电压： | 4 V ~ 36 V |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 1.75 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 28-SSOP |
| 包装： | 带卷 (TR) |
| 其它名称： | LTC3714EGTR |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC3714
PIN FUNCTIONS
BG (Pin 1): Bottom Gate Drive. Drives the gate of the
bottom N-channel MOSFET between ground and INTV CC .
PGND (Pin 2): Power Ground. Connect this pin closely to
the bottom of the sense resistor or if no sense resistor is
used, to the source of the bottom N-channel MOSFET, the
(–) terminal of CV CC and the (–) terminal of C IN .
SENSE (Pin 3): Current Sense Comparator Input. The (+)
input to the current comparator is normally connected to
the SW node unless using a sense resistor (see Applica-
tions Information).
SW (Pin 4): Switch Node. The (–) terminal of the bootstrap
capacitor C B connects here. This pin swings from a diode
voltage drop below ground up to V IN .
TG (Pin 5): Top Gate Drive. Drives the top N-channel
MOSFET with a voltage swing equal to INTV CC superim-
posed on the switch node voltage SW.
BOOST (Pin 6): Boosted Floating Driver Supply. The (+)
terminal of the bootstrap capacitor C B connects here. This
pin swings from a diode voltage drop below INTV CC up
to V IN + INTV CC .
VID0-VID4 (Pins 7, 8, 9, 24, 25): VID Digital Inputs. The
voltage identification (VID) code sets the internal feedback
resistor divider ratio for different output voltages as shown
in Table 1. If unconnected, the pins are pulled high by
internal 2.5μA current sources.
RUN/SS (Pin 10): Run Control and Soft-Start Input. A
capacitor to ground at this pin sets the ramp time to full
output current (approximately 3s/μF) and the time delay
for overcurrent latchoff (see Applications Information).
Forcing this pin below 0.8V shuts down the device.
V ON (Pin 11): On-Time Voltage Input. Voltage trip point for
the on-time comparator. Tying this pin to the output voltage
makes the on-time proportional to V OUT . The comparator
input defaults to 0.7V when the pin is grounded, 2.4V when
the pin is tied to INTV CC .
PGOOD (Pin 12): Power Good Output. Open drain logic
output that is pulled to ground when the output voltage
is not within ±10% of the regulation point.
V RNG (Pin 13): Sense Voltage Range Input. The voltage
at this pin is ten times the nominal sense voltage at maxi-
mum output current and can be set from 0.5V to 2V by a
resistive divider from INTV CC . The sense voltage defaults
to 70mV when this pin is tied to ground, 140mV when
tied to INTV CC .
ITH (Pin 14): Current Control Threshold and Error Amplifier
Compensation Point. The current comparator threshold
increases with this control voltage. The voltage ranges
from 0V to 2.4V with 0.8V corresponding to zero sense
voltage (zero current).
OPV IN (Pin 15): Internal Op Amp Supply. Connect to
INTV CC or a separate supply greater than 5V.
OP – (Pin 16): Negative Input of the Internal Op Amp.
OP + (Pin 17): Positive Input of the Internal Op Amp.
OPOUT (Pin 18): Output of the Internal Op Amp.
SGND (Pin 19): Signal Ground. All small-signal compo-
nents and compensation components should connect to
this ground, which in turn connects to PGND at one point.
FCB (Pin 20): Forced Continous Input. Tie this pin to
ground to force continuous synchronous operation at low
load, to INTV CC to enable discontinuous mode operation at
low load or to a resistive divider from a secondary output
when using a secondary winding.
I ON (Pin 21): On-Time Current Input. Tie a resistor from V IN
to this pin to set the one-shot timer current and thereby
set the switching frequency.
V FB (Pin 22): Error Amplifier Feedback Input. This pin con-
nects to both the error amplifier input and to the output
of the internal resistive divider. It can be used to attach
additional compensation components if desired.
V OSENSE (Pin 23): Output Voltage Sense. The output volt-
age connects here to the input of the internal resistive
feedback divider.
EXTV CC (Pin 26): External V CC Input. When EXTV CC exceeds
4.7V, an internal switch connects this pin to INTV CC and
shuts down the internal regulator so that controller and
gate drive power is drawn from EXTV CC . Do not exceed
7V at this pin and ensure that EXTV CC < V IN .
V IN (Pin 27): Main Input Supply. Decouple this pin to
SGND with an RC filter (1Ω, 0.1μF).
3714f
8
相关PDF资料 |
PDF描述 |
|---|---|
| RBC22DREN-S93 | CONN EDGECARD 44POS .100 EYELET |
| C1005X7R1H102M | CAP CER 1000PF 50V 20% X7R 0402 |
| AHA336M35D16T-F | CAP ALUM 33UF 35V 20% SMD |
| EBA50DTBZ-S664 | CONN EDGECARD 100PS R/A .125 SLD |
| MIC5239YMM | IC REG LDO ADJ .5A 8MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3716EG | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3716EG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3716EG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3716EG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3717-1#PBF | 制造商:LINEAR 功能描述: 制造商:Linear Technology 功能描述: |
发布紧急采购，3分钟左右您将得到回复。