参数资料
型号: LTC3727AIG-1#TR
厂商: LINEAR TECHNOLOGY CORP
元件分类: 稳压器
英文描述: 3 A SWITCHING CONTROLLER, 580 kHz SWITCHING FREQ-MAX, PDSO28
封装: 5.30 MM, PLASTIC, SSOP-28
文件页数: 13/32页
文件大小: 328K
代理商: LTC3727AIG-1#TR
LTC3727A-1
20
3727a1fa
A comparator monitors the output for overvoltage
conditions. The comparator (OV) detects overvoltage faults
greater than 7.5% above the nominal output voltage. When
this condition is sensed, the top MOSFET is turned off and
the bottom MOSFET is turned on until the overvoltage
condition is cleared. The output of this comparator is
only latched by the overvoltage condition itself and will
therefore allow a switching regulator system having a poor
PC layout to function while the design is being debugged.
The bottom MOSFET remains on continuously for as long
as the OV condition persists; if VOUT returns to a safe
level, normal operation automatically resumes. A shorted
top MOSFET will result in a high current condition which
will open the system fuse. The switching regulator will
regulate properly with a leaky top MOSFET by altering the
duty cycle to accommodate the leakage.
Phase-Locked Loop and Frequency Synchronization
The LTC3727A-1 has a phase-locked loop comprised of an
internal voltage controlled oscillator and phase detector.
This allows the top MOSFET turn-on to be locked to the
rising edge of an external source. The frequency range of
the voltage controlled oscillator is
±50%aroundthecenter
frequency fO. A voltage applied to the PLLFLTR pin of 1.2V
corresponds to a frequency of approximately 380kHz. The
nominal operating frequency range of the LTC3727A-1 is
250kHz to 550kHz.
The phase detector used is an edge sensitive digital
type which provides zero degrees phase shift between
the external and internal oscillators. This type of phase
detector will not lock up on input frequencies close to the
harmonics of the VCO center frequency. The PLL hold-in
range,
ΔfH, is equal to the capture range, ΔfC:
ΔfH = ΔfC = ±0.5 fO (250kHz-550kHz)
The output of the phase detector is a complementary pair
of current sources charging or discharging the external
lter network on the PLLFLTR pin.
APPLICATIONS INFORMATION
If the external frequency (fPLLIN) is greater than the
oscillator frequency fOSC, current is sourced continuously,
pulling up the PLLFLTR pin. When the external frequency is
less than fOSC, current is sunk continuously, pulling down
the PLLFLTR pin. If the external and internal frequencies
are the same but exhibit a phase difference, the current
sources turn on for an amount of time corresponding to the
phase difference. Thus the voltage on the PLLFLTR pin is
adjusted until the phase and frequency of the external and
internal oscillators are identical. At this stable operating
point the phase comparator output is open and the lter
capacitor CLP holds the voltage. The LTC3727A-1 PLLIN
pin must be driven from a low impedance source such as
a logic gate located close to the pin. When using multiple
LTC3727A-1s for a phase-locked system, the PLLFLTR pin
of the master oscillator should be biased at a voltage that
will guarantee the slave oscillator(s) ability to lock onto the
master’s frequency. A DC voltage of 0.7V to 1.7V applied
to the master oscillator’s PLLFLTR pin is recommended
in order to meet this requirement. The resultant operating
frequency can range from 310kHz to 470kHz.
The loop lter components (CLP, RLP) smooth out the cur-
rent pulses from the phase detector and provide a stable
input to the voltage controlled oscillator. The lter com-
ponents CLP and RLP determine how fast the loop acquires
lock. Typically RLP =10kΩ and CLP is 0.01μF to 0.1μF.
Minimum On-Time Considerations
Minimum on-time tON(MIN) is the smallest time duration
that the LTC3727A-1 is capable of turning on the top
MOSFET. It is determined by internal timing delays and the
gate charge required to turn on the top MOSFET. Low duty
cycle applications may approach this minimum on-time
limit and care should be taken to ensure that
t
V
Vf
ON MIN
OUT
IN
()
<
相关PDF资料
PDF描述
LTC3727AIG-1#TRPBF 3 A SWITCHING CONTROLLER, 580 kHz SWITCHING FREQ-MAX, PDSO28
LTC3727AIG-1#PBF 3 A SWITCHING CONTROLLER, 580 kHz SWITCHING FREQ-MAX, PDSO28
LTC3736-2EUF#PBF SWITCHING CONTROLLER, PDSO24
LTC3736-2EUF#TRPBF SWITCHING CONTROLLER, PQCC24
LTC3736-2EGN#PBF SWITCHING CONTROLLER, PDSO24
相关代理商/技术参数
参数描述
LTC3727EG 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3727EG#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3727EG#TR 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3727EG#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3727EG-1 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX