- 您现在的位置：买卖IC网 > PDF目录15260 > LTC3727EG-1 (Linear Technology)IC REG CTRLR BUCK PWM CM 28-SSOP PDF资料下载
参数资料
| 型号： | LTC3727EG-1 |
| 厂商： | Linear Technology |
| 文件页数： | 19/32页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 28-SSOP |
| 标准包装： | 47 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 580kHz |
| 占空比： | 99% |
| 电源电压： | 4 V ~ 36 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC3727/LTC3727-1
APPLICATIO S I FOR ATIO
Regulating an output voltage of 1.8V, the maximum value
of R1 should be 32K. Note that for an output voltage above
2.4V, R1 has no maximum value necessary to absorb the
3.3V OR 5V
D1
V IN
RUN/SS
R SS *
INTV CC
R SS *
RUN/SS
sense currents; however, R1 is still bounded by the
V OSENSE feedback current.
C SS
C SS
Soft-Start/Run Function
The RUN/SS1 and RUN/SS2 pins are multipurpose pins
*OPTIONAL TO DEFEAT OVERCURRENT
LATCHOFF (NOT NEEDED WITH THE LTC3727-1)
(7a)
(7b)
3727 F07
that provide a soft-start function and a means to shut
down the LTC3727. Soft-start reduces the input power
source’s surge currents by gradually increasing the
controller’s current limit (proportional to V ITH ). This pin
can also be used for power supply sequencing.
An internal 1.2 μ A current source charges up the C SS
capacitor . When the voltage on RUN/SS1 (RUN/SS2)
reaches 1.5V, the particular controller is permitted to start
operating. As the voltage on RUN/SS increases from 1.5V
to 3.0V, the internal current limit is increased from 45mV/
R SENSE to 135mV/R SENSE . The output current limit ramps
up slowly, taking an additional 1.25s/ μ F to reach full
current. The output current thus ramps up slowly, reduc-
ing the starting surge current required from the input
power supply. If RUN/SS has been pulled all the way to
ground there is a delay before starting of approximately:
Figure 7. RUN/SS Pin Interfacing
The RUN/SS capacitor, C SS , is used initially to turn on and
limit the inrush current. After the controller has been
started and been given adequate time to charge up the
output capacitor and provide full load current, the RUN/SS
capacitor is used for a short-circuit timer. If the regulator’s
output voltage falls to less than 70% of its nominal value
after C SS reaches 4.1V, C SS begins discharging on the
assumption that the output is in an overcurrent condition.
If the condition lasts for a long enough period as deter-
mined by the size of the C SS and the specified discharge
current, the controller will be shut down until the RUN/SS
pin voltage is recycled. If the overload occurs during start-
up, the time can be approximated by:
t LO1 ? [C SS (4.1 – 1.5 + 4.1 – 3.5)]/(1.2 μ A)
t DELAY
=
1 . 5 V
1 . 2 μ A
C SS = ( 1 . 25 s / μ F ) C SS
= 2.7 ? 10 6 (C SS )
If the overload occurs after start-up the voltage on C SS will
C SS = ( 1 . 25 s / μ F ) C SS
t IRAMP =
3 V ? 1.5 V
1 . 2 μ A
By pulling both RUN/SS pins below 1V, the LTC3727 is
put into low current shutdown (I Q = 20 μ A). The RUN/SS
pins can be driven directly from logic as shown in Fig-
ure 7. Diode D1 in Figure 7 reduces the start delay but
allows C SS to ramp up slowly providing the soft-start
function. Each RUN/SS pin has an internal 6V zener clamp
(See Functional Diagram).
Fault Conditions: Overcurrent Latchoff (LTC3727 Only)
The RUN/SS pins also provide the ability to latch off the
begin discharging from the zener clamp voltage:
t LO2 ? [C SS (6 – 3.5)]/(1.2 μ A) = 2.1 ? 10 6 (C SS )
This built-in overcurrent latchoff can be overridden by
providing a pull-up resistor to the RUN/SS pin as shown
in Figure 7. This resistance shortens the soft-start period
and prevents the discharge of the RUN/SS capacitor
during an over current condition. Tying this pull-up resis-
tor to V IN , as in Figure 7a, defeats overcurrent latchoff.
Diode-connecting this pull-up resistor to INTV CC , as in
Figure 7b, eliminates any extra supply current during
controller shutdown while eliminating the INTV CC loading
from preventing controller start-up. This pull-up resistor
is not needed in LTC3727-1 designs.
controller(s) when an overcurrent condition is detected.
3727fc
19
相关PDF资料 |
PDF描述 |
|---|---|
| ESA14DRMI-S288 | CONN EDGECARD 28POS .125 EXTEND |
| LTC3727EG#PBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| VE-27N-EY-F4 | CONVERTER MOD DC/DC 18.5V 50W |
| VE-2TN-EW-F3 | CONVERTER MOD DC/DC 18.5V 100W |
| VE-2TN-EW-F2 | CONVERTER MOD DC/DC 18.5V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3727EG-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3727EG-1#TR | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3727EG-1#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3727EG-1PBF | 制造商:Linear Technology 功能描述:DC-DC Controller Dual Step-Dn 36V SSOP28 |
| LTC3727EGPBF | 制造商:Linear Technology 功能描述:Dual Sync Buck Sw Vreg Controller SSOP28 |
发布紧急采购，3分钟左右您将得到回复。