- 您现在的位置：买卖IC网 > PDF目录15291 > LTC3736EGN (Linear Technology)IC REG CTRLR BUCK PWM CM 24-SSOP PDF资料下载
参数资料
| 型号： | LTC3736EGN |
| 厂商： | Linear Technology |
| 文件页数： | 10/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 24-SSOP |
| 标准包装： | 55 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 825kHz |
| 占空比： | 100% |
| 电源电压： | 2.75 V ~ 9.8 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 24-SSOP（0.154"，3.90mm 宽） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC3736
OPERATIO
Main Control Loop
(Refer to Functional Diagram)
rise linearly from approximately 0.65V to 1.3V (being
The LTC3736 uses a constant frequency, current mode
architecture with the two controllers operating 180 de-
grees out of phase. During normal operation, the top
external P-channel power MOSFET is turned on when the
clock for that channel sets the RS latch, and turned off
when the current comparator (I CMP ) resets the latch. The
peak inductor current at which I CMP resets the RS latch is
determined by the voltage on the I TH pin, which is driven
by the output of the error amplifier (EAMP). The V FB pin
receives the output voltage feedback signal from an exter-
nal resistor divider. This feedback signal is compared to
the internal 0.6V reference voltage by the EAMP. When the
load current increases, it causes a slight decrease in V FB
relative to the 0.6V reference, which in turn causes the I TH
voltage to increase until the average inductor current
matches the new load current. While the top P-channel
MOSFET is off, the bottom N-channel MOSFET is turned
on until either the inductor current starts to reverse, as
indicated by the current reversal comparator, I RCMP , or the
beginning of the next cycle.
Shutdown, Soft-Start and Tracking Start-Up
(RUN/SS and TRACK Pins)
The LTC3736 is shut down by pulling the RUN/SS pin low.
In shutdown, all controller functions are disabled and the
chip draws only 9 μ A. The TG outputs are held high (off)
and the BG outputs low (off) in shutdown. Releasing
RUN/SS allows an internal 0.7 μ A current source to charge
up the RUN/SS pin. When the RUN/SS pin reaches 0.65V,
the LTC3736’s two controllers are enabled.
The start-up of V OUT1 is controlled by the LTC3736’s
internal soft-start. During soft-start, the error amplifier
EAMP compares the feedback signal V FB1 to the internal
soft-start ramp (instead of the 0.6V reference), which rises
linearly from 0V to 0.6V in about 1ms. This allows the
output voltage to rise smoothly from 0V to its final value,
while maintaining control of the inductor current.
The 1ms soft-start time can be increased by connecting
the optional external soft-start capacitor C SS between the
RUN/SS and SGND pins. As the RUN/SS pin continues to
charged by the internal 0.7 μ A current source), the EAMP
regulates the V FB1 proportionally linearly from 0V to 0.6V.
The start-up of V OUT2 is controlled by the voltage on the
TRACK pin. When the voltage on the TRACK pin is less
than the 0.6V internal reference, the LTC3736 regulates
the V FB2 voltage to the TRACK pin instead of the 0.6V
reference. Typically, a resistor divider on V OUT1 is con-
nected to the TRACK pin to allow the start-up of V OUT2 to
“track” that of V OUT1 . For one-to-one tracking during start-
up, the resistor divider would have the same values as the
divider on V OUT2 that is connected to V FB2 .
Light Load Operation (Burst Mode or Continuous
Conduction) (SYNC/FCB Pin)
The LTC3736 can be enabled to enter high efficiency Burst
Mode operation or forced continuous conduction mode at
low load currents. To select Burst Mode operation, tie the
SYNC/FCB pin to a DC voltage above 0.6V (e.g., V IN ). To
select forced continuous operation, tie the SYNC/FCB to a
DC voltage below 0.6V (e.g., SGND). This 0.6V threshold
between Burst Mode operation and forced continuous mode
can be used in secondary winding regulation as described
in the Auxiliary Winding Control Using SYNC/FCB Pin dis-
cussion in the Applications Information section.
When a controller is in Burst Mode operation, the peak
current in the inductor is set to approximate one-fourth of
the maximum sense voltage even though the voltage on
the I TH pin indicates a lower value. If the average inductor
current is lower than the load current, the EAMP will
decrease the voltage on the I TH pin. When the I TH voltage
drops below 0.85V, the internal SLEEP signal goes high
and both external MOSFETs are turned off.
In sleep mode, much of the internal circuitry is turned off,
reducing the quiescent current that the LTC3736 draws.
The load current is supplied by the output capacitor. As
the output voltage decreases, the EAMP increases the I TH
voltage. When the I TH voltage reaches 0.925V, the SLEEP
signal goes low and the controller resumes normal
operation by turning on the external P-channel MOSFET
on the next cycle of the internal oscillator.
3736fa
10
相关PDF资料 |
PDF描述 |
|---|---|
| VE-B5K-EV-F1 | CONVERTER MOD DC/DC 40V 150W |
| B43086F2156M | 15UF 250V 10X20 SINGLE END |
| LTC3703HGN#PBF | IC REG CTRLR BST PWM VM 16-SSOP |
| AS1917Z-T | IC SUPERVISOR ACT HIGH SOT23-5 |
| LTC3891EFE#TRPBF | IC REG CTRLR BUCK PWM CM 20TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3736EGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3736EGN#TR | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3736EGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3736EGN-1 | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3736EGN-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。