- 您现在的位置：买卖IC网 > PDF目录15249 > LTC3780IG#TRPBF (Linear Technology)IC REG CTRLR BST PWM CM 24-SSOP PDF资料下载
参数资料
| 型号： | LTC3780IG#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 10/30页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST PWM CM 24-SSOP |
| 标准包装： | 1,800 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 440kHz |
| 占空比： | 99% |
| 电源电压： | 4 V ~ 36 V |
| 降压： | 是 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 24-SSOP（0.209"，5.30mm 宽） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LTC3780
PIN FUNCTIONS
(SSOP/QFN)
PGOOD (Pin 1/Pin 30): Open-Drain Logic Output. PGOOD
is pulled to ground when the output voltage is not within
±7.5% of the regulation point.
SS (Pin 2/Pin 31): Soft-start reduces the input power
sources’ surge currents by gradually increasing the
controller’s current limit. A minimum value of 6.8nF is
recommended on this pin.
SENSE + (Pin 3/Pin 1): The (+) Input to the Current Sense
and Reverse Current Detect Comparators. The I TH pin volt-
age and built-in offsets between SENSE – and SENSE + pins,
in conjunction with R SENSE , set the current trip threshold.
SENSE – (Pin 4/Pin 2): The (–) Input to the Current Sense
and Reverse Current Detect Comparators.
I TH (Pin 5/Pin 3): Current Control Threshold and Error
Amplifier Compensation Point. The current comparator
threshold increases with this control voltage. The voltage
ranges from 0V to 2.4V.
V OSENSE (Pin 6/Pin 4): Error Amplifier Feedback Input.
This pin connects the error amplifier input to an external
resistor divider from V OUT .
SGND (Pin 7/Pin 5, Exposed Pad Pin 33): Signal Ground. All
small-signal components and compensation components
should connect to this ground, which should be connected
to PGND at a single point. The QFN exposed pad must be
soldered to PCB ground for electrical connection and rated
thermal performance.
RUN (Pin 8/Pin 6): Run Control Input. Forcing the RUN
pin below 1.5V causes the IC to shut down the switching
regulator circuitry. There is a 100k resistor between the
RUN pin and SGND in the IC. Do not apply >6V to this pin.
FCB (Pin 9/Pin 7): Forced Continuous Control Input. The
voltage applied to this pin sets the operating mode of the
controller. When the applied voltage is less than 0.8V, the
forced continuous current mode is active. When this pin
is allowed to float, the Burst Mode operation is active in
boost operation and the skip-cycle mode is active in buck
operation. When the pin is tied to INTV CC , the constant
frequency discontinuous current mode is active in buck
or boost operation.
PLLFLTR (Pin 10/Pin 8): The phase-locked loop’s
lowpass filter is tied to this pin. Alternatively, this pin can
be driven with an AC or DC voltage source to vary the
frequency of the internal oscillator.
PLLIN (Pin 11/Pin 10): External Synchronization Input to
Phase Detector. This pin is internally terminated to SGND
with 50kΩ. The phase-locked loop will force the rising
bottom gate signal of the controller to be synchronized
with the rising edge of the PLLIN signal.
STBYMD (Pin 12/Pin 11): LDO Control Pin. Determines
whether the internal LDO remains active when the control-
ler is shut down. See Operation section for details. If the
STBYMD pin is pulled to ground, the SS pin is internally
pulled to ground, preventing start-up and thereby provid-
ing a single control pin for turning off the controller. To
keep the LDO active when RUN is low, for example to
power a “wake up” circuit which controls the state of the
RUN pin, bypass STBYMD to signal ground with a 0.1μF
capacitor, or use a resistor divider from V IN to keep the
pin within 2V to 5V.
BOOST2, BOOST1 (Pins 13, 24/Pins 14, 27): Boosted
Floating Driver Supply. The (+) terminal of the bootstrap
capacitor C A and C B (Figure 11) connects here. The BOOST2
pin swings from a diode voltage below INTV CC up to V IN
+ INTV CC . The BOOST1 pin swings from a diode voltage
below INTV CC up to V OUT + INTV CC .
TG2, TG1 (Pins 14, 23/Pins 15, 26): Top Gate Drive. Drives
the top N-channel MOSFET with a voltage swing equal to
INTV CC superimposed on the switch node voltage SW.
SW2, SW1 (Pins 15, 22/Pins 17, 24): Switch Node. The (–)
terminal of the bootstrap capacitor C A and C B (Figure 11)
connects here. The SW2 pin swings from a Schottky diode
(external) voltage drop below ground up to V IN . The SW1
pin swings from a Schottky diode (external) voltage drop
below ground up to V OUT .
3780ff
10
For more information www.linear.com/LTC3780
相关PDF资料 |
PDF描述 |
|---|---|
| ACC10DRTI-S13 | CONN EDGECARD 20POS .100 EXTEND |
| LTC1629CG-PG#TRPBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| AEB106M2EK32T-F | CAP ALUM 10UF 250V 20% SMD |
| CAT809TTBI-GT3 | IC SUPERVISOR PP ACT LOW SOT-23 |
| ABC13DRTI-S13 | CONN EDGECARD 26POS .100 EXTEND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3780IUH | 制造商:Linear Technology 功能描述:DC DC Cntrlr Dual-OUT Synchronous Boost/Buck Controller 4V to 36V Input 32-Pin QFN EP |
| LTC3780IUH#PBF | 功能描述:IC REG CTRLR BST PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3780IUH#PBF | 制造商:Linear Technology 功能描述:DC/DC Controller IC |
| LTC3780IUH#TR | 制造商:Linear Technology 功能描述:DC DC Cntrlr Dual-OUT Synchronous Boost/Buck Controller 4V to 36V Input 32-Pin QFN EP T/R |
| LTC3780IUH#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。