- 您现在的位置：买卖IC网 > PDF目录44992 > LTC3783IFE#TR (LINEAR TECHNOLOGY CORP) 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | LTC3783IFE#TR |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | 4.40 MM, PLASTIC, TSSOP-16 |
| 文件页数： | 2/24页 |
| 文件大小： | 250K |
| 代理商： | LTC3783IFE#TR |
LTC3783
10
3783fb
OPERATION
The SS pin provides a soft-start current to charge an
external capacitor. Enabled by RUN, the soft-start current
is 50μA, which creates a positive voltage ramp on VSS
to which the internal ITH is limited, avoiding high peak
currents on start-up. Once VSS reaches 1.23V, the full ITH
range is established.
The LTC3783 can be used either by sensing the voltage
drop across the power MOSFET or by connecting the
SENSE pin to a conventional shunt resistor in the source
of the power MOSFET, as shown in the Typical Application
on the rst page of this data sheet. Sensing the voltage
across the power MOSFET maximizes converter efciency
and minimizes the component count, but limits the out-
put voltage to the maximum rating for this pin (36V). By
connecting the SENSE pin to a resistor in the source of
the power MOSFET, the user is able to program output
voltages signicantly greater than 36V, limited only by
other components’ breakdown voltages.
Externally Synchronized Operation
When an external clock signal drives the SYNC pin at a
rate faster than the chip’s internal oscillator, the oscillator
will synchronize to it. When the oscillator’s internal logic
circuitry detects a synchronizing signal on the SYNC pin,
the internal oscillator ramp is terminated early and the
slope compensation is increased by approximately 25%.
As a result, in applications requiring synchronization, it
is recommended that the nominal operating frequency of
the IC be programmed to be about 80% of the external
clock frequency. Attempting to synchronize to too high
an external frequency (above 1.3fOSC) can result in inad-
equate slope compensation and possible subharmonic
oscillation (or jitter).
The external clock signal must exceed 2V for at least 25ns,
and should have a maximum duty cycle of 80%, as shown
in Figure 1. The MOSFET turn-on will synchronize to the
rising edge of the external clock signal.
Programming the Operating Frequency
The choice of operating frequency and inductor value is
a tradeoff between efciency and component size. Low
frequency operation improves efciency by reducing
MOSFET and diode switching losses. However, lower
frequency operation requires more inductance for a given
amount of load current.
The LTC3783 uses a constant frequency architecture that
can be programmed over a 20kHz to 1MHz range with
a single external resistor from the FREQ pin to ground,
as shown in the application on the rst page of this data
sheet. The nominal voltage on the FREQ pin is 0.615V,
and the current that ows out of the FREQ pin is used to
charge and discharge an internal oscillator capacitor. The
oscillator frequency is trimmed to 300kHz with RT = 20k.
A graph for selecting the value of RT for a given operating
frequency is shown in Figure 2.
3783 F01
2V TO 7V
MODE/
SYNC
GATE
IL
tMIN = 25ns
0.8T
D = 40%
T
T = 1/fO
Figure 1. MODE/SYNC Clock Input and Switching Waveforms
for Synchronized Operation
FREQUENCY (kHz)
10
R
T(kΩ)
100
1
100
1000
10000
3783 G09
1
10
1000
Figure 2. Timing Resistor (RT) Value
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3783IDHD#TR | 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3783IFE | 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3785IUF#PBF | 3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC24 |
| LTC3785EUF | 3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC24 |
| LTC3786IMSE#TRPBF | SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3785EUF#PBF | 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3785EUF#TRPBF | 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3785EUF-1#PBF | 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3785EUF-1#TRPBF | 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3785EUFPBF | 制造商:Linear Technology 功能描述:10V Synch Buck-Boost Controller LTC3785 |
发布紧急采购，3分钟左右您将得到回复。