参数资料
型号: LTC3783IFE#TR
厂商: LINEAR TECHNOLOGY CORP
元件分类: 稳压器
英文描述: 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
封装: 4.40 MM, PLASTIC, TSSOP-16
文件页数: 22/24页
文件大小: 250K
代理商: LTC3783IFE#TR
LTC3783
7
3783fb
PIN FUNCTIONS
FBN (Pin 1): Error Amplier Inverting Input/Negative Cur-
rent Sense Pin. In voltage mode (VFBP ≤ VVREF), this pin
senses feedback voltage from either the external resistor
divider across VOUT for output voltage regulation, or the
grounded sense resistor under the load for output current
regulation. In constant current/constant voltage mode
(VFBP > 2.5V), connect this pin to the negative side of the
current-regulating resistor. Nominal voltage for this pin in
regulation is either VFBPor(VFBP–100mV)forVILIM= 1.23V,
depending on operational mode (voltage or constant cur-
rent/constant voltage) set by the voltage at VFBP.
FBP (Pin 2): Error Amplier Noninverting Input/Positive
Current Sense Pin. This pin voltage determines the control
loop’s feedback mode (voltage or constant current/constant
voltage), the threshold of which is approximately 2V. In
voltage mode (VFBP ≤ VREF), this pin represents the desired
voltage which the regulated loop will cause FBN to follow.
In constant current/constant voltage mode (VFBP > 2.5V),
connect this pin to the positive side of the load current-
sensing resistor. The acceptable input ranges for this pin
are 0V to 1.23V (voltage mode) and 2.5V to 36V (constant
current/constant voltage mode).
ILIM(Pin 3): Current Limit Pin. Sets current sense resis-
tor offset voltage (VFBP – VFBN) in constant current mode
regulation (i.e., when VFBP > 2.5V). Offset voltage is 100mV
when VILIM=1.23VanddecreasesproportionallywithVILIM.
Nominal voltage range for this pin is 0.1V to 1.23V.
VREF (PIN 4): Reference Voltage Pin. Provides a buffered
version of the internal bandgap voltage, which can be
connected to FBP either directly or with attenuation.
Nominal voltage for this pin is 1.23V. This pin should
never be bypassed by a capacitor to GND. Instead, a 10k
resistor to GND should be used to lower pin impedance
in noisy systems.
FREQ (Pin 5): A resistor from the FREQ pin to ground
programs the operating frequency of the chip. The nominal
voltage at the FREQ pin is 0.615V.
SYNC (Pin 6): This input allows for synchronizing the op-
erating frequency to an external clock and has an internal
100k pull-down resistor.
PWMIN (Pin 7): PWM Gate Driver Input. Internal 100k
pull-up resistor. While PWMIN is low, PWMOUT is low,
GATE stops switching and the external ITH network is
disconnected, saving the ITH state.
PWMOUT (Pin 8): PWM Gate Driver Output. Used for con-
stant current dimming (LED load) or for output disconnect
(step-up power supply).
GATE (Pin 9): Main Gate Driver Output for the Boost
Converter.
INTVCC (Pin 10): Internal 7V Regulator Output. The main
and PWM gate drivers and control circuits are powered
from this voltage. Decouple this pin locally to the IC ground
with a minimum of 4.7μF low ESR ceramic capacitor.
VIN (Pin 11): Main Supply Pin. Must be closely decoupled
to ground.
SENSE (Pin 12): Current Sense Input for the Control Loop.
Connect this pin to the drain of the main power MOSFET
for VDS sensing and highest efciency for VSENSE ≤ 36V.
Alternatively, the SENSE pin may be connected to a resistor
in the source of the main power MOSFET. Internal leading-
edge blanking is provided for both sensing methods.
SS (Pin 13): Soft-Start Pin. Provides a 50μA pull-up current,
enabledandresetbyRUN,whichchargesanoptionalexternal
capacitor. This voltage ramp translates into a corresponding
current limit ramp through the main MOSFET.
OV/FB (Pin 14): Overvoltage Pin/Voltage Feedback Pin.
In voltage mode (VFBP ≤ VREF), this input, connected to
VOUT through a resistor network, sets the output voltage
at which GATE switching is disabled in order to prevent
an overvoltage situation. Nominal threshold voltage for
the OV pin is 1.32V (VREF + 7%) with 20mV hysteresis. In
current/voltage mode (VFBP > 2.5V), this pin senses VOUT
through a resistor divider and brings the loop into voltage
regulation such that pin voltage approaches VREF = 1.23V,
provided the loop is not regulating the load current (e.g.,
[VFBP – VFBN] < 100mV for ILIM = 1.23V).
相关PDF资料
PDF描述
LTC3783IDHD#TR 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
LTC3783IFE 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
LTC3785IUF#PBF 3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC24
LTC3785EUF 3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC24
LTC3786IMSE#TRPBF SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO16
相关代理商/技术参数
参数描述
LTC3785EUF#PBF 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LTC3785EUF#TRPBF 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3785EUF-1#PBF 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3785EUF-1#TRPBF 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3785EUFPBF 制造商:Linear Technology 功能描述:10V Synch Buck-Boost Controller LTC3785