- 您现在的位置：买卖IC网 > PDF目录69007 > LTC3785EUF-1#PBF (LINEAR TECHNOLOGY CORP) 3 A SWITCHING REGULATOR, 650 kHz SWITCHING FREQ-MAX, PQCC24 PDF资料下载
参数资料
| 型号： | LTC3785EUF-1#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 3 A SWITCHING REGULATOR, 650 kHz SWITCHING FREQ-MAX, PQCC24 |
| 封装： | 4 X 4 MM, LEAD FREE, PLASTIC, MO-220WGGD, QFN-24 |
| 文件页数： | 2/20页 |
| 文件大小： | 213K |
| 代理商： | LTC3785EUF-1#PBF |
LTC3785-1
10
37851fa
OPERATION
RUN/SOFT-START (RUN/SS)
The RUN/SS pin serves as the enable to the LTC3785-1,
soft-start function, and fault programming. A 1μA current
source charges the external capacitor. Once the RUN/SS
voltage is above a diode drop(~0.7V) the IC is enabled. Once
the IC is enabled, the RUN/SS voltage minus a diode drop
(RUN/SS – 0.7V) clamps the output of the error amp (VC)
to limit duty cycle. The range of the duty cycle clamping is
approximately 0.7V to 1.7V. The RUN/SS pin is clamped
to approximately 2.2V. If current limit is reached the pin
will begin to discharge with a current determined by the
magnitude of inductor current overcurrent limit, but not
to exceed 10μA. This function will be described in more
detail in the Forward Current Limit section.
OSCILLATOR
The frequency of operation is set through a resistor from
the RT pin to ground where f
(2.5e10/RT)Hz.
ERROR AMP
The error amplier is a voltage mode amplier with a
reference voltage of 1.225V internally connected to the
non-inverting input. The loop compensation components
are congured around the amplier to provide loop com-
pensation for the converter. The RUN/SS pin will clamp the
error amp output, VC, to provide a soft-start function.
UNDERVOLTAGE AND OVERVOLTAGE PROTECTION
The LTC3785-1 incorporates overvoltage (OV) and
undervoltage (UV) functions for fault protection and
transient limitation. Both comparators are connected
to the VSENSE pin, which usually has a similar voltage
divider as the error amplier without the compensation.
The overvoltage threshold is 7.5% above the reference.
The undervoltage threshold is 7.5% below the reference
with both comparators having 1.5% hysteresis. During
an overvoltage fault, all output switching stops until the
fault ceases. During an undervoltage fault, the IC is com-
manded to run xed frequency only (disabled Burst Mode
operation). If the design requires a tightened threshold to
one of the comparator thresholds the voltage divider on
the VSENSE pin can be skewed to achieve the threshold.
Since the range is a constant, tightening the UV threshold
will loosen the OV threshold and vice versa.
POWER GOOD COMPARATOR
The PGOOD pin is an open-drain output which indicates
the status of the buck-boost converter output. The output
voltage is monitored at VSENSE via a resistor divider tap
from VOUT to GND. The values used for this resistor divider
are typically selected to be the same as those used in the
error amplier feedback divider. If the voltage on VSENSE
either falls 7.5% below (UV condition) or rises 7.5%
above (OV condition) the regulation voltage, the PGOOD
open-drain output will pull low signaling the output is
out of regulation. Once an out of regulation condition is
triggered, the voltage on VSENSE must rise 1.5% above
the UV threshold or fall 2% below the OV threshold before
the pull-down will turn off. In addition, there is a 15μs
deglitch delay to help prevent false trips due to voltage
transients caused by line or load steps. Depending upon
the application, this delay may be insufcient. A capaci-
tor can be placed from VSENSE to GND to add additional
deglitch ltering, ensuring PGOOD doesn’t trip during
a transient. The PGOOD output will also pull low during
shutdown and input undervoltage lockout to indicate these
fault conditions.
FORWARD CURRENT LIMIT
The LTC3785-1 is designed to sense the input current by
sampling the voltage across MOSFET A during the on time of
the switch (TG1 = High). The sense pins are ISVINandISSW1.
A current sense resistor can be used if increased accuracy
is required. The current limit threshold can be programmed
with a resistor on the ILSET pin. Once the desired current
limit has been chosen, RILSET can be determined by the
following formula:
RILSET =
6000
RDS(ON)A ILIMIT
Ω
where RDS(ON)A = RDS(ON) of N-channel MOSFET switch A
and ILIMIT = current limit in Amps.
Once the voltage between ISVIN and ISSW1 exceeds the
threshold, current will be sourced out of FB to take control
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3823EUH | 4 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PQCC32 |
| LTC3823EGN | 4 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28 |
| LTC3823EUH#TR | 4 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PQCC32 |
| LTC3823EGN#TR | 4 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28 |
| LTC3827IUH | 3 A DUAL SWITCHING CONTROLLER, 580 kHz SWITCHING FREQ-MAX, PQCC32 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3785EUFPBF | 制造商:Linear Technology 功能描述:10V Synch Buck-Boost Controller LTC3785 |
| LTC3785IUF#PBF | 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC3785IUF#TRPBF | 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3786EMSE#PBF | 功能描述:IC REG CTRLR BST PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3786EMSE#PBF | 制造商:Linear Technology 功能描述:IC DC-DC CONV 550kHz MSOP16 制造商:Linear Technology 功能描述:IC, DC-DC CONV, 550kHz, MSOP16 |
发布紧急采购，3分钟左右您将得到回复。