参数资料
型号: LTC3788EUH#PBF
厂商: LINEAR TECHNOLOGY CORP
元件分类: 稳压器
英文描述: DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32
封装: 5 X 5 MM, LEAD FREE, PLASTIC, MO-220WHHD, QFN-32
文件页数: 17/32页
文件大小: 386K
代理商: LTC3788EUH#PBF
LTC3788
24
3788fb
applicaTions inForMaTion
The RSENSE resistor value can be calculated by using the
maximum current sense voltage specification with some
accommodation for tolerances:
RSENSE
75mV
9.25A
= 0.008
Choosing 1% resistors: RA = 5k and RB = 95.3k yields an
output voltage of 24.072V.
The power dissipation on the top side MOSFET can
be easily estimated. Choosing a Vishay Si7848BDP
MOSFET results in: RDS(ON) = 0.012Ω, CMILLER = 150pF.
At maximum input voltage with T(estimated) = 50°C:
PMAIN =
(24V
12V) 24V
(12V)2
(4A)2
1
+(0.005)(50°C 25°C)
[
]0.008
+ (1.7)(24V)3
4A
12V
(150pF)(350kHz)
= 0.7W
COUT is chosen to filter the square current in the output.
The maximum output current peak is:
IOUT(PEAK) = 4 1+
31%
2
=
4.62A
A low ESR (5m) capacitor is suggested. This capacitor
will limit output voltage ripple to 23.1mV (assuming ESR
dominate ripple).
PC Board Layout Checklist
When laying out the printed circuit board, the following
checklist should be used to ensure proper operation of
the IC. These items are also illustrated graphically in the
layout diagram of Figure 7. Figure 8 illustrates the current
waveforms present in the various branches of the 2-phase
synchronousregulatorsoperatinginthecontinuousmode.
Check the following in your layout:
1.PutthebottomN-channelMOSFETsMBOT1andMBOT2
and the top N-channel MOSFETs MTOP1 and MTOP2
in one compact area with COUT.
2. Are the signal and power grounds kept separate? The
combined IC signal ground pin and the ground return of
CINTVCCmustreturntothecombinedCOUT(–)terminals.
The path formed by the bottom N-channel MOSFET and
the CIN capacitor should have short leads and PC trace
lengths. The output capacitor (–) terminals should be
connected as close as possible to the (–) terminals of
the input capacitor by placing the capacitors next to
each other.
3. Do the LTC3788 VFB pins’ resistive dividers connect to
the (+) terminals of COUT? The resistive divider must be
connected between the (+) terminal of COUT and signal
ground and placed close to the VFB pin. The feedback
resistor connections should not be along the high cur-
rent input feeds from the input capacitor(s).
4. Are the SENSEand SENSE+ leads routed together with
minimumPCtracespacing?Thefiltercapacitorbetween
SENSE+ and SENSEshould be as close as possible
to the IC. Ensure accurate current sensing with Kelvin
connections at the sense resistor.
5. Is the INTVCC decoupling capacitor connected close
to the IC, between the INTVCC and the power ground
pins? This capacitor carries the MOSFET drivers’ cur-
rent peaks. An additional 1F ceramic capacitor placed
immediately next to the INTVCCandPGNDpinscanhelp
improve noise performance substantially.
6. Keep the switching nodes (SW1, SW2), top gate nodes
(TG1, TG2) and boost nodes (BOOST1, BOOST2) away
from sensitive small-signal nodes, especially from
the opposites channel’s voltage and current sensing
feedback pins. All of these nodes have very large and
fast moving signals and, therefore, should be kept on
the output side of the LTC3788 and occupy a minimal
PC trace area.
7. Use a modified “star ground” technique: a low imped-
ance, large copper area central grounding point on
the same side of the PC board as the input and output
capacitors with tie-ins for the bottom of the INTVCC
decouplingcapacitor,thebottomofthevoltagefeedback
resistive divider and the SGND pin of the IC.
相关PDF资料
PDF描述
LTC3788IUH#PBF DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32
LTC3788IGN-1#PBF DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO28
LTC3788EGN-1#TRPBF DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO28
LTC3789EGN#TRPBF 0.1 A SWITCHING CONTROLLER, 710 kHz SWITCHING FREQ-MAX, PDSO28
LTC3789EUFD#TRPBF 0.1 A SWITCHING CONTROLLER, 710 kHz SWITCHING FREQ-MAX, PQCC28
相关代理商/技术参数
参数描述
LTC3788IGN-1#PBF 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3788IGN-1#TRPBF 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3788IUH#PBF 功能描述:IC REG CTRLR BST PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3788IUH#TRPBF 功能描述:IC REG CTRLR BST PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3789EGN#PBF 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX