- 您现在的位置：买卖IC网 > PDF目录1832 > LTC3789EGN#PBF (Linear Technology)IC REG CTRLR BST PWM CM 28-SSOP PDF资料下载
参数资料
| 型号： | LTC3789EGN#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/30页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST PWM CM 28-SSOP |
| 标准包装： | 49 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 710kHz |
| 占空比： | 98% |
| 电源电压： | 4 V ~ 38 V |
| 降压： | 是 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 28-SSOP（0.154"，3.90mm 宽） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LTC3789
PIN FUNCTIONS
(SSOP/QFN)
V FB (Pin 1/Pin 26): Error Amplifier Feedback Pin. Receives
the feedback voltage for the controller from an external
resistive divider across the output.
SS (Pin 2/Pin 27): External Soft-Start Input. The LTC3789
regulates the V FB voltage to the smaller of 0.8V or the
voltage on the SS pin. A internal 3μA pull-up current
source is connected to this pin. A capacitor to ground
at this pin sets the ramp time to final regulated output
voltage.
SENSE + (Pin 3/Pin 28): The (+) Input to the Current Sense
Comparator. The I TH pin voltage and controlled offsets
between the SENSE – and SENSE + pins, in conjunction
with R SENSE , set the current trip threshold.
SENSE – (Pin 4/Pin 1): The (–) Input to the Current Sense
Comparator.
I TH (Pin 5/Pin 2): Error Amplifier Output and Switch-
ing Regulator Compensation Point. The channel’s
current comparator trip point increases with this control
voltage.
SGND (Pin 6/Pins 3, Exposed Pad Pin 29): Small
Signal Ground. Must be routed separately from high
current grounds to the common (–) terminals of the
C IN capacitors. In the QFN package, the exposed pad
is SGND. It must be soldered to PCB ground for rated
thermal performance.
MODE/PLLIN (Pin 7/Pin 4): Mode Selection or External
Synchronization Input to Phase Detector. This is a dual-
purpose pin. When external frequency synchronization
is not used, this pin selects the operating mode. The
pin can be tied to SGND or INTV CC . SGND or below
0.8V enables forced continuous mode. INTV CC enables
pulse-skipping mode. For external sync, apply a clock
signal to this pin. The internal PLL will synchronize the
internal oscillator to the clock, and forced continuous
mode will be enabled. The PLL composition network is
integrated into the IC.
FREQ (Pin 8/Pin 5): Frequency Set Pin. There is a precision
10μA current flowing out of this pin. A resistor to ground
sets a voltage which, in turn, programs the frequency.
Alternatively, this pin can be driven with a DC voltage to
vary the frequency of the internal oscillator.
RUN (Pin 9/Pin 6): Run Control Input. Forcing the pin
below 0.5V shuts down the controller, reducing quies-
cent current. There are 1.2μA pull-up currents for this
pin. Once the RUN pin rises above 1.22V, the IC is turned
on, and an additional 5μA pull-up current is added to
the pin.
V INSNS (Pin 10/Pin 7): V IN Sense Input to the Buck-Boost
Transition Comparator. Connect this pin to the drain of the
top N-channel MOSFET on the input side.
V OUTSNS (Pin 11/Pin 8): V OUT Sense Input to the Buck-
Boost Transition Comparator. Connect this pin to the drain
of the top N-channel MOSFET on the output side.
I LIM (Pin 12/Pin 9): Input/Output Average Current
Sense Range Input. This pin tied to SGND, INTV CC or
left floating, sets the maximum average current sense
threshold.
I OSENSE+ (Pin 13/Pin 10): The (+) Input to the Input/Output
Average Current Sense Amplifier.
I OSENSE– (Pin 14/Pin 11): The (–) Input to the Input/Output
Average Current Sense Amplifier.
TRIM (Pin 15/Pin 12): Tie this pin to GND for normal
operation. Do not allow this pin to float.
EXTV CC (Pin 20/Pin 17): External Power Input to an
Internal LDO Connected to INTV CC . This LDO supplies
INTV CC power, bypassing the internal LDO powered from
V IN whenever EXTV CC is higher than 4.8V. See EXTV CC
Connection in the Applications Information section. Do
not exceed 14V on this pin.
3789fa
9
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3801BES6#TRM | IC REG CTRLR BUCK PWM TSOT23-6 |
| LTC3802EGN | IC REG CTRLR BUCK PWM VM 28-SSOP |
| LTC3803MPS6-3#TRMPBF | IC REG CTRLR FLYBK PWM TSOT23-6 |
| LTC3803MPS6-5#TRMPBF | IC REG CTRLR FLYBK PWM TSOT23-6 |
| LTC3803MPS6#TRMPBF | IC REG CTRLR FLYBK PWM TSOT23-6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3789EUFD#PBF | 功能描述:IC REG CTRLR BST PWM CM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3789EUFD#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3789IGN#PBF | 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3789IGN#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3789IUFD#PBF | 功能描述:IC REG CTRLR BST PWM CM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。