- 您现在的位置：买卖IC网 > PDF目录44993 > LTC3812IFE-5 (LINEAR TECHNOLOGY CORP) 1 A SWITCHING CONTROLLER, PDSO16 PDF资料下载
参数资料
| 型号： | LTC3812IFE-5 |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 1 A SWITCHING CONTROLLER, PDSO16 |
| 封装： | 4.40 MM, PLASTIC, TSSOP-16 |
| 文件页数： | 15/32页 |
| 文件大小： | 425K |
| 代理商： | LTC3812IFE-5 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC3812-5
22
38125fb
Applications using large MOSFETs with a high input
voltage and high frequency of operation may result in a
large EXTVCC pin current. Due to the LTC3812-5 thermally
enhanced package, maximum junction temperature will
rarely be exceeded, however, it is good design practice
to verify that the maximum junction temperature rating
and RMS current rating are within the maximum limits.
Typically, most of the EXTVCC current consists of the
MOSFET gates current. In continuous mode operation,
this EXTVCC current is:
IEXTVCC = f(QG(TOP) + QG(BOTTOM)) + 3mA < 50mA
The junction temperature can be estimated from the
equations given in Note 2 of the Electrical Characteristics
as follows:
TJ = TA + IEXTVCC (VEXTVCC– VINTVCC)(38°C/W) < 125°C
If absolute maximum ratings are exceeded, consider
using an external supply connected directly to the
INTVCC pin.
FEEDBACK LOOP/COMPENSATION
Feedback Loop Types
In a typical LTC3812-5 circuit, the feedback loop con-
sists of the modulator, the output lter and load, and the
feedback amplier with its compensation network. All of
these components affect loop behavior and must be ac-
counted for in the loop compensation. The modulator and
output lter consists of the internal current comparator,
the output MOSFET drivers and the external MOSFETs,
inductor and output capacitor. Current mode control
eliminates the effect of the inductor by moving it to the
inner loop, reducing it to a rst order system. From a
feedback loop point of view, it looks like a linear voltage
controlled current source from ITH to VOUT and has a gain
equal to (IMAXROUT)/1.2V. It has fairly benign AC behavior
at typical loop compensation frequencies with signicant
phase shift appearing at half the switching frequency. The
external output capacitor and load cause a rst order roll
off at the output at the ROUTCOUT pole frequency, with
the attendant 90° phase shift. This roll off is what lters
the PWM waveform, resulting in the desired DC output
voltage. The output capacitor also contributes a zero at
the COUTRESR frequency which adds back the 90° phase
and cancels the rst order roll off.
So far, the AC response of the loop is pretty well out of the
user’s control. The modulator is a fundamental piece of
the LTC3812-5 design and the external output capacitor is
usually chosen based on the regulation and load current
requirements without considering the AC loop response.
The feedback amplier, on the other hand, gives us a
handle with which to adjust the AC response. The goal is
to have 180° phase shift at DC (so the loop regulates), and
something less than 360° phase shift (preferably about
300°) at the point that the loop gain falls to 0dB, i.e., the
crossover frequency, with as much gain as possible at
frequencies below the crossover frequency. Since the
modulator/output lter is a rst order system with maxi-
mum of 90° phase shift (at frequencies below fSW/4) and
the feedback amplier adds another 90° of phase shift,
some phase boost is required at the crossover frequency
to achieve good phase margin. If the ESR zero is below the
crossover frequency, this zero may provide enough phase
boost to achieve the desired phase margin and the only
requirement of the compensation will be to guarantee that
the gain is below zero at frequencies above fSW/4. If the
ESR zero is above the crossover frequency, the feedback
amplier will probably be required to provide phase boost.
For most LTC3810 applications, Type 2 compensation will
provide enough phase boost; however some applications
where high bandwidth is required with low ESR ceramics
and lots of bulk capacitance, Type 3 compensation may
be necessary to provide additional phase boost.
The two types of compensation networks, “Type 2” and
“Type 3” are shown in Figures 10 and 11. When compo-
nent values are chosen properly, these networks provide
Figure 10. Type 2 Schematic and Transfer Function
APPLICATIONS INFORMATION
GAIN
(dB)
38125 F10
0
PHASE
–6dB/OCT
GAIN
PHASE
(DEG)
FREQ
–90
–180
–270
–360
RB
VREF
R1
R2
FB
C2
IN
OUT
+
–
C1
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3831IGN | SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3833IUDC#PBF | SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC3833EFE#TRPBF | SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, PDSO20 |
| LTC3833EUDC#TRPBF | SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC3833EUDC#PBF | SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, PQCC20 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3812IFE-5#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3812IFE-5#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3813EG#PBF | 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3813EG#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3813IG#PBF | 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。