参数资料
| 型号： | LTC3819EG#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 16/32页 |
| 文件大小： | 0K |
| 描述： | IC CNTRLR STEP DOWN 36-SSOP |
| 标准包装： | 2,000 |
| 应用： | 控制器，Sun 服务器 |
| 输入电压： | 4 V ~ 36 V |
| 输出数： | 1 |
| 输出电压： | 1.03 V ~ 1.41 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 36-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 36-SSOP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC3819
APPLICATIO S I FOR ATIO
0.6
0.5
C OUT required ESR < 4(R SENSE ) and
C OUT > 1/(16f)(R SENSE )
0.4
0.3
0.2
0.1
1-PHASE
2-PHASE
The emergence of very low ESR capacitors in small,
surface mount packages makes very physically small
implementations possible. The ability to externally com-
pensate the switching regulator loop using the I TH
pin(OPTI-LOOP compensation) allows a much wider se-
lection of output capacitor types. OPTI-LOOP compensa-
0
0.1
0.2
0.3 0.4 0.5 0.6 0.7
DUTY FACTOR (V OUT /V IN )
0.8 0.9
3819 F04
tion effectively removes constraints on output capacitor
ESR. The impedance characteristics of each capacitor
type are significantly different than an ideal capacitor and
Figure 4. Normalized RMS Input Ripple Current
vs Duty Factor for 1 and 2 Output Stages
It is important to note that the efficiency loss is propor-
tional to the input RMS current squared and therefore a
2-phase implementation results in 75% less power loss
when compared to a single phase design. Battery/input
protection fuse resistance (if used), PC board trace and
connector resistance losses are also reduced by the
reduction of the input ripple current in a 2-phase system.
The required amount of input capacitance is further
reduced by the factor, 2, due to the effective increase in
the frequency of the current pulses.
The selection of C OUT is driven by the required effective
series resistance (ESR). Typically once the ESR require-
ment has been met, the RMS current rating generally far
exceeds the I RIPPLE(P-P) requirements. The steady state
output ripple ( ? V OUT ) is determined by:
therefore require accurate modeling or bench evaluation
during design.
Manufacturers such as Nichicon, United Chemicon and
Sanyo should be considered for high performance
through-hole capacitors. The OS-CON semiconductor
dielectric capacitor available from Sanyo and the Panasonic
SP surface mount types have the lowest (ESR)(size)
product of any aluminum electrolytic at a somewhat
higher price. An additional ceramic capacitor in parallel
with OS-CON type capacitors is recommended to reduce
the inductance effects.
In surface mount applications, multiple capacitors may
have to be paralleled to meet the ESR or RMS current
handling requirements of the application. Aluminum elec-
trolytic and dry tantalum capacitors are both available in
surface mount configurations. New special polymer sur-
face mount capacitors offer very low ESR also but have
much lower capacitive density per unit volume. In the case
? V OUT RIPPLE ? ESR +
16 fC OUT ?
≈ ? I
?
?
1 ?
?
of tantalum, it is critical that the capacitors are surge tested
for use in switching power supplies. Several excellent
choices are the AVX TPS, AVX TPSV or the KEMET T510
Where f = operating frequency of each stage, C OUT =
output capacitance and ? I RIPPLE = combined inductor
ripple currents.
The output ripple varies with input voltage since ? I L is a
function of input voltage. The output ripple will be less than
50mV at max V IN with ? I L = 0.4I OUT(MAX) /2 assuming:
series of surface mount tantalums, available in case heights
ranging from 2mm to 4mm. Other capacitor types include
Sanyo OS-CON, POSCAPs, Panasonic SP caps, Nichicon
PL series and Sprague 595D series. Consult the manufac-
turer for other specific recommendations. A combination
of capacitors will often result in maximizing performance
and minimizing overall cost and size.
3819f
16
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3822EGN-1#PBF | IC REG CTRLR BUCK PWM CM 16-SSOP |
| LTC3822EMSE#TRPBF | IC REG CTRLR BUCK PWM CM 10-MSOP |
| LTC3823IUH#PBF | IC REG CTRLR BUCK PWM CM 32-QFN |
| LTC3824EMSE#PBF | IC REG CTRLR BUCK PWM CM 10-MSOP |
| LTC3826IUH#TRPBF | IC REG CTRLR BUCK PWM CM 32-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3822EDD#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 10-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC3822EDD#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 10-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3822EDD-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3822EDD-1#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3822EGN-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
发布紧急采购，3分钟左右您将得到回复。