参数资料
型号: LTC3829EUHF#PBF
厂商: LINEAR TECHNOLOGY CORP
元件分类: 稳压器
英文描述: SWITCHING REGULATOR, PQCC38
封装: 5 X 7 MM, LEAD FREE, PLASTIC, M0-220WHKD, QFN-38
文件页数: 6/40页
文件大小: 478K
代理商: LTC3829EUHF#PBF
LTC3829
3829f
operaTion (Refer to Functional Diagram)
A phase-locked loop (PLL) is available on the LTC3829
to synchronize the internal oscillator to an external clock
source that is connected to the PLLIN pin. The PLL loop
filter network is integrated inside the LTC3829. The phase-
locked loop is capable of locking any frequency within
the range of 250kHz to 770kHz. The frequency setting
resistor should always be present to set the controller’s
initial switching frequency before locking to the external
clock. The controller is operating in forced continuous
mode when it is synchronized.
Sensing the Output Voltage with a
Differential Amplifier
The LTC3829 includes a low offset, unity-gain, high band-
widthdifferentialamplifierforapplicationsthatrequiretrue
remote sensing. Sensing the load across the load capaci-
torsdirectlygreatlybenefitsregulationinhighcurrent,low
voltage applications, where board interconnection losses
can be a significant portion of the total error budget.
TheLTC3829differentialamplifierhasatypicaloutputslew
rate of 2V/s. The amplifier is configured for unity gain,
meaning that the difference between DIFFP and DIFFN is
translated to DIFFOUT, relative to SGND.
Care should be taken to route the DIFFP and DIFFN PCB
traces parallel to each other all the way to the terminals
of the output capacitor or remote sensing points on the
board. In addition, avoid routing these sensitive traces
near any high speed switching nodes in the circuit. Ideally,
the DIFFP and DIFFN traces should be shielded by a low
impedance ground plane to maintain signal integrity.
The maximum output voltage when using the differential
amplifierisINTVCC–1.4V(typically3.6V).Abovethisoutput
voltage the differential amplifier should not be used.
Power Good (PGOOD Pin)
The PGOOD pin is connected to an open drain of an
internal N-channel MOSFET. The MOSFET turns on and
pulls the PGOOD pin low when the VFB pin voltage is not
within ±10% of the 0.6V reference voltage. The PGOOD
pin is also pulled low when the RUN pin is below 1.22V or
when the LTC3829 is in the soft-start or tracking phase.
When the VFB pin voltage is within the ±10% regulation
window, the MOSFET is turned off and the pin is allowed
to be pulled up by an external resistor to a source of up
to 6V. The PGOOD pin will flag power good immediately
when the VFBpiniswithintheregulationwindow.However,
there is an internal 100s power-bad mask when the VFB
goes out of the window.
Output Overvoltage Protection
An overvoltage comparator, OV, guards against transient
overshoots (>10%) as well as other more serious condi-
tions that may overvoltage the output. In such cases, the
topMOSFETisturnedoffandthebottomMOSFETisturned
on until the overvoltage condition is cleared.
Undervoltage Lockout
The LTC3829 has two functions that help protect the
controller in case of undervoltage conditions. A precision
UVLO comparator constantly monitors the INTVCCvoltage
to ensure that an adequate gate-drive voltage is present. It
locks out the switching action when INTVCC is below 3.3V.
To prevent oscillation when there is a disturbance on the
INTVCC, the UVLO comparator has 600mV of precision
hysteresis.
Anotherwaytodetectanundervoltageconditionistomoni-
tor the VIN supply. Because the RUN pin has a precision
turn-on reference of 1.22V, one can use a resistor divider
to VIN to turn on the IC when VIN is high enough. An extra
4.5A of current flows out of the RUN pin once the RUN
pin voltage passes 1.22V. The RUN comparator itself has
about 80mV of hysteresis. One can program additional
hysteresis for the RUN comparator by adjusting the val-
ues of the resistive divider. For accurate VIN undervoltage
detection, VIN needs to be higher than 4.5V.
相关PDF资料
PDF描述
LPD28SP 1-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE
LM4041CIM3-1.2T&R 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 1.225 V, PDSO3
LM4040CIM3-2.5T&R 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 2.5 V, PDSO3
LK2540-7EPD3TB1 2-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
LS1001-7EPD7TB1 1-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE
相关代理商/技术参数
参数描述
LTC3829IFE#PBF 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3829IFE#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3829IUHF#PBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3829IUHF#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3830-1ES8 功能描述:IC REG CTRLR BUCK PWM VM 8-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP(0.173",4.40mm 宽) 包装:带卷 (TR)