- 您现在的位置：买卖IC网 > PDF目录44994 > LTC3851AEMSE#PBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, PDSO16 PDF资料下载
参数资料
| 型号： | LTC3851AEMSE#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING REGULATOR, PDSO16 |
| 封装： | LEAD FREE, PLASTIC, MSOP-16 |
| 文件页数： | 2/30页 |
| 文件大小： | 430K |
| 代理商： | LTC3851AEMSE#PBF |
第1页当前第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LTC3851A
10
3851afa
operaTion
Main Control Loop
The LTC3851A is a constant frequency, current mode
step-down controller. During normal operation, the top
MOSFET is turned on when the clock sets the RS latch,
and is turned off when the main current comparator, ICMP,
resets the RS latch. The peak inductor current at which
ICMP resets the RS latch is controlled by the voltage on
the ITH pin, which is the output of the error amplifier, EA.
The VFB pin receives the voltage feedback signal, which is
comparedtotheinternalreferencevoltagebytheEA.When
the load current increases, it causes a slight decrease in
VFB relative to the 0.8V reference, which in turn causes the
ITH voltage to increase until the average inductor current
matches the new load current. After the top MOSFET has
turned off, the bottom MOSFET is turned on until either
the inductor current starts to reverse, as indicated by the
reverse current comparator, IREV, or the beginning of the
next cycle.
INTVCC Power
Power for the top and bottom MOSFET drivers and most
other internal circuitry is derived from the INTVCC pin. An
internal 5V low dropout linear regulator supplies INTVCC
power from VIN.
The top MOSFET driver is biased from the floating boot-
strap capacitor, CB,whichnormallyrechargesduringeach
off cycle through an external diode when the top MOSFET
turns off. If the input voltage, VIN, decreases to a voltage
close to VOUT, the loop may enter dropout and attempt
to turn on the top MOSFET continuously. The dropout
detector detects this and forces the top MOSFET off for
about 1/10 of the clock period every tenth cycle to allow
CB to recharge. However, it is recommended that there is
always a load present during the drop-out transition to
ensure CB is recharged.
Shutdown and Start-Up (RUN and TK/SS)
The LTC3851A can be shut down using the RUN pin. Pull-
ing this pin below 1.1V disables the controller and most
of the internal circuitry, including the INTVCC regulator.
Releasing the RUN pin allows an internal 2A current to
pull up the pin and enable that controller. Alternatively,
the RUN pin may be externally pulled up or driven directly
by logic. Be careful not to exceed the absolute maximum
rating of 6V on this pin.
The start-up of the controller’s output voltage, VOUT, is
controlled by the voltage on the TK/SS pin. When the
voltage on the TK/SS pin is less than the 0.8V internal
reference, the LTC3851A regulates the VFB voltage to the
TK/SS pin voltage instead of the 0.8V reference. This al-
lows the TK/SS pin to be used to program a soft-start by
connecting an external capacitor from the TK/SS pin to
GND.Aninternal1Apull-upcurrentchargesthiscapacitor
creating a voltage ramp on the TK/SS pin. As the TK/SS
voltage rises linearly from 0V to 0.8V (and beyond), the
output voltage VOUT rises smoothly from zero to its final
value. Alternatively, the TK/SS pin can be used to cause
the start-up of VOUT to track another supply. Typically,
this requires connecting to the TK/SS pin an external
resistor divider from the other supply to ground (see the
Applications Information section). When the RUN pin
is pulled low to disable the controller, or when INTVCC
drops below its undervoltage lockout threshold of 3.2V,
the TK/SS pin is pulled low by an internal MOSFET. When
in undervoltage lockout, the controller is disabled and the
external MOSFETs are held off.
Light Load Current Operation (Burst Mode Operation,
Pulse-Skipping or Continuous Conduction)
The LTC3851A can be enabled to enter high efficiency
Burst Mode operation, constant frequency pulse-skipping
mode or forced continuous conduction mode. To select
forced continuous operation, tie the MODE/PLLIN pin to
INTVCC. To select pulse-skipping mode of operation, float
the MODE/PLLIN pin or tie it to GND. To select Burst Mode
operation, tie MODE/PLLIN to INTVCC through a resistor
no less than 50k, but no greater than 250k.
When the controller is enabled for Burst Mode operation,
the peak current in the inductor is set to approximately
one-forth of the maximum sense voltage even though
the voltage on the ITH pin indicates a lower value. If the
average inductor current is higher than the load current,
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3851EUD-1#PBF | 0.05 A SWITCHING CONTROLLER, 530 kHz SWITCHING FREQ-MAX, PQCC16 |
| LTC3851EMSE-1#PBF | 0.05 A SWITCHING CONTROLLER, 530 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3851IMSE-1#PBF | 0.05 A SWITCHING CONTROLLER, 530 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3851IMSE#TRPBF | 0.05 A SWITCHING CONTROLLER, 790 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3851IMSE#PBF | 0.05 A SWITCHING CONTROLLER, 790 kHz SWITCHING FREQ-MAX, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3851AEUD#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3851AEUD#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3851AEUD-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3851AEUD-1#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3851AHMSE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。