- 您现在的位置：买卖IC网 > PDF目录1832 > LTC3853EUJ#PBF (Linear Technology)IC REG CTRLR BUCK PWM CM 40-QFN PDF资料下载
参数资料
| 型号： | LTC3853EUJ#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 12/36页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 40-QFN |
| 产品培训模块： | LTC3853 Multiphase Switching Controller |
| 标准包装： | 61 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 3 |
| 频率 - 最大： | 830kHz |
| 占空比： | 98% |
| 电源电压： | 4.5 V ~ 24 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 40-WFQFN 裸露焊盘 |
| 包装： | 管件 |
| 产品目录页面： | 1336 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页当前第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LTC3853
OPERATION
voltage below 0.8V (e.g., SGND). To select pulse skipping
mode of operation, tie the MODE/PLLIN pin to INTV CC . To
select Burst Mode operation, float the MODE/PLLIN pin.
When the controller is enabled for Burst Mode operation,
the peak current in the inductor is set to approximately
one-third of the maximum sense voltage even though
the voltage on the I TH pin indicates a lower value. If the
average inductor current is higher than the load current,
the error amplifier EA will decrease the voltage on the I TH
pin. When the I TH voltage drops below 0.5V, the internal
sleep signal goes high (enabling “sleep” mode) and both
external MOSFETs are turned off.
In sleep mode, the load current is supplied by the output
capacitor. As the output voltage decreases, the EA’s output
begins to rise. When the output voltage drops enough, the
sleep signal goes low, and the controller resumes normal
operation by turning on the top external MOSFET on the
next cycle of the internal oscillator. When the controller
is enabled for Burst Mode operation, the inductor current
is not allowed to reverse. The reverse current comparator
(I REV ) turns off the bottom external MOSFET just before the
inductor current reaches zero, preventing it from revers-
ing and going negative. Thus, the controller operates in
discontinuous operation. In forced continuous operation,
the inductor current is allowed to reverse at light loads or
under large transient conditions. The peak inductor current
is determined by the voltage on the I TH pin, just as in nor-
mal operation. In this mode, the efficiency at light loads is
lower than in Burst Mode operation. However, continuous
mode has the advantages of lower output ripple and less
interference with audio circuitry.
When the MODE/PLLIN pin is connected to INTV CC , the
LTC3853 operates in PWM pulse skipping mode at light
loads. At very light loads, the current comparator, I CMP ,
may remain tripped for several cycles and force the external
top MOSFET to stay off for the same number of cycles (i.e.,
skipping pulses). The inductor current is not allowed to
reverse (discontinuous operation). This mode, like forced
continuous operation, exhibits low output ripple as well as
low audio noise and reduced RF interference as compared
to Burst Mode operation. It provides higher low current
efficiency than forced continuous mode, but not nearly as
high as Burst Mode operation.
Frequency Selection and Phase-Locked Loop
(FREQ/PLLFLTR and MODE/PLLIN Pins)
The selection of switching frequency is a tradeoff between
efficiency and component size. Low frequency operation
increases efficiency by reducing MOSFET switching losses,
but requires larger inductance and/or capacitance to main-
tain low output ripple voltage. The switching frequency
of the LTC3853’s controllers can be selected using the
FREQ/PLLFLTR pin. If the MODE/PLLIN pin is not being
driven by an external clock source, the FREQ/PLLFLTR
pin can be used to program the controller’s operating
frequency from 250kHz to 750kHz.
A phase-locked loop (PLL) is available on the LTC3853
to synchronize the internal oscillator to an external clock
source that is connected to the MODE/PLLIN pin. The
controller is operating in forced continuous mode when
it is synchronized. A series R-C should be connected
between the FREQ/PLLFLTR pin and SGND to serve as
the PLL’s loop filter.
Power Good (PGOOD12 and PGOOD3 Pins)
The PGOOD12 pin is connected to an open drain of an
internal N-channel MOSFET. The MOSFET turns on and
pulls the PGOOD12 pin low when either V FB1 or V FB2 pin
voltage is not within ±7.5% of the 0.8V reference voltage.
The PGOOD12 pin is also pulled low when either RUN1
or RUN2 pin is below 1.2V or when the LTC3853 is in the
soft-start or tracking phase. When the V FB pin voltage
is within the ±7.5% requirement, the MOSFET is turned
off and the pin is allowed to be pulled up by an external
resistor to a source of up to 6V. The PGOOD12 pin will
flag power good immediately when both V FB1 and V FB2
pins are within the ±7.5% window. However, there is an
internal 17μs power bad mask when either V FB is out of
the ± 7.5% window. PGOOD3 monitors V FB3 and is also
pulled low when RUN3 is below 1.2V.
Output Overvoltage Protection
An overvoltage comparator, OV, guards against transient
overshoots (> 7.5%) as well as other more serious con-
ditions that may overvoltage the output. In such cases,
the top MOSFET is turned off and the bottom MOSFET is
turned on until the overvoltage condition is cleared.
3853fa
12
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3854EMSE#PBF | IC REG CTRLR BUCK PWM CM 12-MSOP |
| LTC3855IUJ#PBF | IC REG CTRLR BUCK PWM CM 40-QFN |
| LTC3856IFE#TRPBF | IC REG CTRLR BUCK PWM CM 38TSSOP |
| LTC3858IUH#TRPBF | IC REG CTRLR BUCK PWM CM 32-QFN |
| LTC3859EFE#PBF | IC REG CTRLR BST PWM CM 38-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3853IUJ#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 40-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3853IUJ#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 40-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3854EDDB#PBF | 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Cut Tape Small Footprint, Low Pin Count Synchronous Step-Do |
| LTC3854EDDB#TRMPBF | 功能描述:IC REG CTRLR BUCK PWM CM 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3854EDDB#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。