参数资料
型号: LTC3856EFE#PBF
厂商: Linear Technology
文件页数: 13/40页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 38TFSOP
标准包装: 50
系列: PolyPhase®
PWM 型: 电流模式
输出数: 1
频率 - 最大: 850kHz
占空比: 94%
电源电压: 4.5 V ~ 38 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: 38-TFSOP (0.173",4.40mm 宽)裸露焊盘
包装: 管件
LTC3856
OPERATION (Refer to Functional Diagram)
Light Load Current Operation (Burst Mode Operation,
Stage Shedding or Continuous Conduction)
The LTC3856 can be enabled to enter high efficiency
Burst Mode operation, Stage Shedding mode or forced
continuous conduction mode. To select forced continuous
operation, tie the MODE pin to a DC voltage below 0.6V
(e.g., SGND). To select Stage Shedding mode of opera-
tion, tie the MODE pin to INTV CC . To select Burst Mode
operation, float the MODE pin.
When the controller is enabled for Burst Mode operation,
the peak current in the inductor is set to approximately
one-sixth of the maximum sense voltage even though
the voltage on the I TH pin indicates a lower value. The
peak current can be programmed by the ISET pin. If the
average inductor current is higher than the load current,
the error amplifier, EA, will decrease the voltage on the
I TH pin. When the I TH voltage drops, the internal sleep
signal goes high (enabling sleep mode) and the external
MOSFETs are turned off. In sleep mode, the load current
is supplied by the output capacitor. As the output voltage
decreases, the EA’s output begins to rise. When the output
voltage drops enough, the sleep signal goes low, and the
controller resumes normal operation by turning on the
top external MOSFET on the next cycle of the internal
oscillator. When a controller is enabled for Burst Mode
operation, the inductor current is not allowed to reverse.
The reverse current comparator, I REV , turns off the bottom
external MOSFET just before the inductor current reaches
zero, preventing it from reversing and going negative.
Thus, the controller operates in discontinuous operation.
In forced continuous operation, the inductor current is
allowed to reverse at light loads or under large transient
conditions. The peak inductor current is determined by
the voltage on the I TH pin, just as in normal operation. In
this mode, the efficiency at light loads is lower than in
Burst Mode operation. However, continuous mode has the
advantages of lower output ripple and less interference
with audio circuitry.
When the MODE pin is connected to INTV CC , the LTC3856
operates in Stage Shedding mode at light loads. The
controller will turn off channel 2 and increase the current
gain of the first channel to ensure a smooth transition. The
threshold where the controller goes into Stage Shedding
mode is where the I TH voltage drops below 0.5V, but it can
be programmed by the ISET pin. The inductor current is
not allowed to reverse in this mode (discontinuous op-
eration). At very light loads, the current comparator may
remain tripped for several cycles and force the external top
MOSFET to stay off for the same number of cycles (i.e.,
skipping pulses). This mode exhibits low output ripple as
well as low audio noise and reduced RF interference as
compared to Burst Mode operation. It provides a higher
low current efficiency than forced continuous mode, but
not nearly as high as Burst Mode operation.
Multichip Operations (PHASMD and CLKOUT Pins)
The LTC3856’s two channels are 180° out-of-phase, provid-
ing multiphase operation. This configuration can provide
enough power for most of the high current applications.
However, for even higher power applications, the LTC3856
can be configured for PolyPhase and multichip operation.
The LTC3856 features PHASMD and CLKOUT pins which
enable multiple LTC3856s to operate out-of-phase, as
shown in Table 1. The CLKOUT signal is out-of-phase
with respect to phase 1 of the controller depending on the
PHASMD pin setting. In Stage Shedding mode, however,
the CLKOUT signal is 180° out-of-phase with respect to
phase 1 of the controller.
Table 1.
PHASMD GND FLOAT INTV CC
Phase 1 0° 0° 0°
Phase 2 180° 180° 240°
CLKOUT 60° 90° 120°
Frequency Selection and Phase-Locked Loop
(FREQ and PLLIN Pins)
The selection of switching frequency is a trade-off between
efficiency and component size. Low frequency opera-
tion increases efficiency by reducing MOSFET switching
losses, but requires larger inductance and/or capacitance
to maintain low output ripple voltage.
If the PLLIN pin is not being driven by an external clock
source, the FREQ pin can be used to program the controller’s
3856f
  
相关PDF资料
PDF描述
LTC3866IFE#PBF IC REG CTRLR BUCK PWM CM 24TSSOP
EMC15DRYI-S13 CONN EDGECARD 30POS .100 EXTEND
ECC36DRTN-S13 CONN EDGECARD 72POS .100 EXTEND
LTC3838EFE#PBF IC REG CTRLR BUCK PWM CM 38TSSOP
ECC36DRTH-S13 CONN EDGECARD 72POS .100 EXTEND
相关代理商/技术参数
参数描述
LTC3856EUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32WFQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3856EUH#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3856IFE#PBF 功能描述:IC REG CTRLR BUCK PWM CM 38TFSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3856IFE#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3856IUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32WFQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)