- 您现在的位置：买卖IC网 > PDF目录15239 > LTC3880IUJ#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM CM 40-QFN PDF资料下载
参数资料
| 型号： | LTC3880IUJ#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 17/112页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 40-QFN |
| 软件下载： | LTpowerPlay™ |
| 标准包装： | 2,000 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 1MHz |
| 电源电压： | 4.5 V ~ 24 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 40-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页
LTC3880/LTC3880-1
OPERATION
2.5V, 3.3V and 5V. If V IN is below 6V, the INTV CC and V IN
pins must be tied together. The controller configuration
is initialized by an internal threshold based UVLO where
V IN must be approximately 4V and the 5V, 3.3V and 2.5V
linear regulators must be within approximately 20% of
the regulated values. The LTC3880-1 does not have an
internal 5V linear regulators. The EXTV CC pin is driven by
an external regulator to improve efficiency of the circuit
and minimize power on the LTC3880. The EXTV CC pin
must exceed approximately 4V before the internal UVLO
is exceeded. To minimize application power, the EXTV CC
pin can be supplied by a switching regulator.
During initialization, the external configuration resistors
are identified and/or contents of the NVM are read into
the controller’s commands. The GPIO n pins are in high
impedance (Hi-Z) mode. The TG n , BG n and RUN n pins
are held low. The LTC3880 will use the contents of Tables
12 to 15 to determine the resistor defined parameters.
See the Resistor Configuration section for more detail.
The resistor configuration pins only control some of the
preset values of the controller. The remaining values are
programmed in NVM either at the factory or by the user.
If the configuration resistors are not inserted or if the
ignore RCONFIG bit is asserted (bit 6 of the MFR_
CONFIG_ALL_LTC3880 configuration command), the
LTC3880 will use only the contents of NVM to determine
the DC/DC characteristics. The ASEL value read at power-
up or reset is always respected unless the pin is open.
The ASEL will use the MSB from NVM and the LSB from
the detected threshold. See the Applications Information
section for more detail.
After the part has initialized, an additional comparator
monitors V IN . The VIN_ON threshold must be exceeded
before the output power sequencing can begin. After V IN
is initially applied, the part will typically require 130ms to
initialize and begin the TON_DELAY timer. The readback of
voltages and currents may require an additional 120ms.
SOFT-START
The part must enter the run state prior to soft-start.
The run pins are released by the LTC3880 after the part
initializes and V IN is greater than the VIN_ON threshold. If
multiple LTC3880s are used in an application, they all hold
their respective run pins low until all devices initialize and
V IN exceeds the VIN_ON threshold for every device. The
SHARE_CLK pin assures all the devices connected to the
signal use the same time base. The SHARE_CLK pin is held
low until the part has initialized after V IN is applied. The
LTC3880 can be set to turn off (or remain off) if SHARE_CLK
is low (set bit 2 of MFR_CHAN_CONFIG_LTC3880 to a 1).
This allows the user to assure synchronization across
numerous LTC ICs even if the RUN pins can not be con-
nected together due to board constraints. In general, if
the user cares about synchronization between chips it is
best to connect all the respective RUN pins together and
to connect all the respective SHARE_CLK pins together.
This assures all chips begin sequencing at the same time
and use the same time base.
After the RUN pin releases and prior to entering a constant
output voltage regulation state, the LTC3880 performs a
monotonic initial ramp or “soft-start”. Soft-start is per-
formed by actively regulating the load voltage while digitally
ramping the target voltage from 0V to the commanded
voltage set-point. Once the LTC3880 is commanded to turn
on, (after power up and initialization) the controller waits
for the user specified turn-on delay (TON_DELAY) prior
to initiating this output voltage ramp. The rise time of the
voltage ramp can be programmed using the TON_RISE
command to minimize inrush currents associated with the
start-up voltage ramp. The soft-start feature is disabled
by setting the value of TON_RISE to any value less than
0.25ms. The LTC3880 PWM always uses discontinuous
mode during the TON_RISE operation. In discontinuous
mode, the bottom gate is turned off as soon as reverse
current is detected in the inductor. This will allow the
regulator to start up into a pre-biased load. When the
TON_MAX_FAULT_LIMIT is reached, the part transi-
tions to continuous mode or burst, if so programmed. If
TON_MAX_FAULT_LIMIT is set to zero, there is no time
limit and the part transitions to the desired conduction
mode after TON_RISE completes and V OUT has exceeded
the VOUT_UV_FAULT_LIMIT and IOUT_OC is not pres-
ent. Setting TON_MAX_FAULT_LIMIT to a value of 0 is
not recommended. This described method of start-up
sequencing is time based.
3880fb
For more information www.linear.com/LTC3880
17
相关PDF资料 |
PDF描述 |
|---|---|
| SRP1040-R56M | INDUCTOR 560NH 25A SMD |
| LTC3880IUJ-1#TRPBF | IC REG CTRLR BUCK PWM CM 40-QFN |
| SRP1040-R50M | INDUCTOR 500NH 23A SMD |
| LTC3729EUH#TRPBF | IC REG CTRLR BUCK PWM CM 32-QFN |
| ELL-6PM1R0N | COIL PWR CHOKE 1UH 2.7A SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3883EUH#PBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN 制造商:Linear Technology 功能描述:BUCK CNTRL 24V 1MHZ 0.5/5.5V 32QFN 制造商:Linear Technology 功能描述:BUCK, CNTRL, 24V, 1MHZ, 0.5/5.5V, 32QFN 制造商:Linear Technology 功能描述:PWM CONTROLLER, BUCK, 1MHZ, 24V, QFN-32, Input Voltage:24V, Output Voltage:5.5V, Output Current:30A, Supply Voltage Min:4.5V, Supply Voltage Max:24V, Digital IC Case Style:QFN, No. of Pins:32, Frequency:1MHz, MSL:MSL 1 - Unlimited , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Digitally Programmable, Multiphase Step-Down DC/DC Controll |
| LTC3883EUH#TRPBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Digitally Programmable, Multiphase Step-Down DC/DC Controll |
| LTC3883EUH-1#PBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN 制造商:Linear Technology 功能描述:BUCK CNTRL 24V 1MHZ 0.5/5.5V 32QFN 制造商:Linear Technology 功能描述:BUCK, CNTRL, 24V, 1MHZ, 0.5/5.5V, 32QFN 制造商:Linear Technology 功能描述:PWM CONTROLLER, BUCK, 1MHZ, 24V, QFN-32, Input Voltage:24V, Output Voltage:5.5V, Output Current:30A, Supply Voltage Min:4.5V, Supply Voltage Max:24V, Digital IC Case Style:QFN, No. of Pins:32, Frequency:1MHz, MSL:MSL 1 - Unlimited , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Digitally Programmable, Multiphase Step-Down DC/DC Controll |
| LTC3883EUH-1#TRPBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN |
| LTC3883IUH#PBF | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Sync Step Down 4.5V to 24V Input 32-Pin QFN EP 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN 制造商:Linear Technology 功能描述:BUCK CNTRL 24V 1MHZ 0.5/5.5V 32QFN 制造商:Linear Technology 功能描述:BUCK, CNTRL, 24V, 1MHZ, 0.5/5.5V, 32QFN 制造商:Linear Technology 功能描述:PWM CONTROLLER, BUCK, 1MHZ, 24V, QFN-32, Input Voltage:24V, Output Voltage:5.5V, Output Current:30A, Supply Voltage Min:4.5V, Supply Voltage Max:24V, Digital IC Case Style:QFN, No. of Pins:32, Frequency:1MHz, MSL:MSL 1 - Unlimited , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Digitally Programmable, Multiphase Step-Down DC/DC Controll |
发布紧急采购，3分钟左右您将得到回复。